2003 Chevrolet Venture Passanger Logo
Posted on Jan 09, 2010
Answered

Need to know how to change battery in a 2003 chev. venture van

Answer This Question

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.
MVP:

An expert that got 5 achievements.
New Friend:

An expert that has 1 follower.
Hot-Shot:

An expert who has answered 20 questions.

  • Contributor 20 Answers
  • Posted on Jan 10, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.
MVP:

An expert that got 5 achievements.
New Friend:

An expert that has 1 follower.
Hot-Shot:

An expert who has answered 20 questions.

Joined: Nov 15, 2009
Answers
20
Questions
0
Helped
26237
Points
48

Best way to charge / safest / is to remove battery from vehicle ...set battery in a open well venilated area / no smoking / with the apporpiate capacity 12 volt charger / read the instructions that come with the charger . Attach red connector of charger to positive post of battery (usually red) attach black connector to battery ground (-) negative side of battery / plug charger into appropiate outlet (120) . Reverese application when battery is fully charged .
Re-install battery in vehicle/ being sure to re-install as removed .
Install black cable to battery (-) negative ...then Hot (red) (+)

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do you remove a headrest for a 2003 chev venture van
Just 2 ways to do it. Pull it up. Look at where it goes into the seat. The cover will have to slits in it. This is a button to push in to release it. No slits. Push it back down and forcefully pull it up and pop it out. It is held in with a detent clip/ball.
Read full answer
Dec 04, 2016 • 2003 Chevrolet Venture
0helpful
1answer

REPLACING HEATER HOSE ON 2000 CHEV VENTURE VAN
You can try here, they will have it www.rockauto.com
Read full answer
Dec 18, 2012 • Cars & Trucks
0helpful
2answers

Put in new battery-all fuses good. Have no power to anything. 2001 CHEV VENTURE VAN
Do you have a small wire connected with your neg. battery post This wire is a ground that grounds your car . , May have come lose when replaced battery. Not all cars have these i really don't know for sure on yours but is sure the place i would start. May even try hooking up a wire from battery " the black cable" And hold it to the car's frame to check good luck on this sorry not be more help.
Read full answer
Mar 28, 2011 • 2001 Chevrolet Venture
0helpful
1answer

I WANT TO CHANGE MY STEREO I NEED TO KNOW WHAT WIRES GO TO WHAT i NEED TO FIND A DIAGRAM TO FOLLOW WHAT SITE DO I USE. ITS A 2003 CHEVY VENTURE LT MINI VAN
you can use a scosche plug in that plugs directly to the wiring harness
Read full answer
Jan 24, 2010 • 2003 Chevrolet Venture Passanger
2helpful
1answer

Change Oil light is on and oil has already been changed how do I reset the light? Chev Venture Van 2000
pump gas pedal three times once you have turn the key to on position before starting.
Read full answer
Oct 03, 2009 • 2000 Chevrolet Venture
0helpful
2answers

Need to change an engine in my van.
yes they will swap out ,most have same sensors and all ,check the plugs on wiring harness before you swap them out make sure,im sure you can cause they both will work in there. hope to help you, thanks robert b.
Read full answer
Jun 26, 2009 • 1999 Chevrolet Venture
1helpful
2answers

2003 chev venture i turn the key and nothing no sound at all i have radio and lights and power windows work any ideas
Most likely your starter or the starter solenoid. (assuming your battery isn't just really low...)

Read full answer
Mar 19, 2009 • 2003 Chevrolet Venture Passanger
2helpful
1answer

Replaced battery securty light came on power no start
Here is something that the emission wiz helped me with


PASS LOCK RESET GM CARS 1999 UP
1) Put the key in the ignition and turn to the "ON" position. Leave it that way for 10 minutes. After 10 minutes turn the key and take it out. Repeat this process (2) more times (3 times, 30 minutes total) This should reset the passlock system to recognize your key.
Read full answer
Mar 14, 2009 • 1997 Chevrolet Venture
8helpful
2answers

Thermostat in a 2003 chevy venture van
no you dont need a special tool you have to take the throttle body off it makes it sooooooo much more simple.
Read full answer
Nov 27, 2008 • 2004 Chevrolet Venture Passanger
2helpful
2answers

Thermostat in a 2003 chevy venture van
the bottom boult is hard but can be done need to use a 10 or 12 stubby wrench and take a pry bar and lighty pry heat shild away to get bottom bolt dont need to take it out all the way just loosen and slide down
Read full answer
Aug 08, 2008 • 2003 Chevrolet Venture Passanger
Not finding what you are looking for?

View Most Popular

2003 Venture Passanger

  • Cars & Trucks

Related Question

How do you remove a headrest for a 2003 chev venture van

  • 2003 Chevrolet Venture

Related Topics

356 views

Ask a Question

Usually answered in minutes!

Popular Questions

Google

2005 Chevrolet Venture

What is the firing order for 3.4 V6 engine and

2003 Chevrolet Venture Passanger

Shift handle moves freely with out shifting trans

1999 Chevrolet Venture

Power sliding door closes half way than opens up

2001 Chevrolet Venture

How to adjust chevy venture headlights?

1998 Chevrolet Venture Cargo

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...