Digital dash, everything quit working except the speedometer. What do I need to do to fix it?

None of my gauges will work, but my turn signal indicators ...

www.americanautowire.com/.../none-of-my-gauges-will-work-but-my-tu...

None of my gauges will work, but my turn signal indicators, high beam ... As we've discussed previously, anything electrical needs a 12 volt feed and ground to work. ... 09/28/2015 There are a number of new products coming in Nov/Dec this ...

my gauges quit working - CarGurus

www.cargurus.com > Questions > Ford > F-250 Super Duty

CarGurusSep 21, 2013 - my gauges quit working - My odometer, speedometer, fuel, tach, trip, and ... I tried fixing the wire and had the same problem....so I replaced the shift lever and everything is back to ... no gauges will work in dashboard 1 answer.

No dash gauges, but dash lights - Car Forums and Automotive Chat ...

www.automotiveforums.com > ... > Dodge > Caravan ' Voyager

Feb 6, 2010 - The dash lights work fine, so does everything else. The dash gaugesjust don't work. This is something that has been an intermittent problem ...

there is a regulator for the display brightness, you may have it turn'd down or it has stopped working;. it controls the brightness at which the dash lights are. usually has a speedo sign on it. goes up and down. it works with the main light and is conecter to them on the same lighting board if it has gone then a new light swtch control switch will be needed.

remove again the dash. in the position of the speedometer, you can see a cable that is quite thick, as thick as a normal coaxial cable that can be seen behind your TV. attach this first at the back of the speedometer before reinstalling the dash.

The odometer quits working when the speedometer quits working. The most common cause for the speedometer to quit working is the speed sensor in the transmission. You said you replaced it, there is also a transmission speed sensor on your truck that may need to be replaced. I understand your frustration, but there is nothing else that would cause the speedometer to quit except the cable behind the gauges being clogged.

1. do the park lamps work?
2. dash lamp fuse burnt?
3. is the instrument cluster analog or digital?
4. digital clusters have been known to fail however the cluster lighting is controlled by a body computer.
5. proper diagnosis with require a scan tool that will access the body module ( computer)

this car uses an electronic speedo head, u must rmove the speedometer from the dash and send it in for repair at an authorized ford electronics repair center.

these digital clusters were not made very well,the fix is a reconditioned unitor take a chance on a used one

HI. If your speedometer needle doesn't move, or if it flutters, your speedometer cable may be bad.

To determine if it is the cable, disconnect the cable casing from the transmission and from the back of the speedometer on the instrument panel. Draw the cable out from inside of the casing. The cable looks like a twisted piece or wire. If the cable is broken or if it is dry or brittle. It probably needs to be replaced. If the cable is intact and the same length as the cable casing, the problem is likely the speedometer head.

I would also advise to check the speedometer gear as well.

The speedometer gear is located on the output shaft. Inspect it for damage.

This gear rarely suffers damage because the gear from the speedometer that meshes with it is usually made of a softer material. Sometimes, the speedometer gear on the main-shaft is replaceable. A clip can hold it in place or it can be a pressed fit. A special puller is available to pull these gears on the car.

sounds like the cluster has shorted out, replacement of the cluster is your only option. don't forget to check all your fuses

Sounds like a loose connection on insterment cluster. or a dead spot on printed circute, either way dash will have to come apart to fix.