This is part of the parking brake assemly pedal. If you are looking for it to diagnose, it is on top of the assembly. it is a one wire white connector. If light is on and this is suspected to be the problem, unplugging it will shut the light off if this is the problem. If light is still on after you un plug it then it may be the master cylinder resivior switch, or the brake fluid is low. I hope this helps.
SOURCE: Changing CO2 Sensor on 2003 Chevy Suburban
check the whole exaust sestyem? there should be 4to5
SOURCE: parking brake pedal goes to floor
The disc brake pads are NOT used for the parking brake. The parking brake uses mini-drum type shoes inside the rear disc rotor.
Take a look at http://wiki.answers.com/Q/How_do_you_change_the_emergency_brake_pads_on_a_2000_Chevy_1500_Silverado_Pickup
For more info
SOURCE: where is the location of the bank one sensor one
bank 1 on a chevy is on the drivers side youll have 4 O2 sensors sensor 1 bank 1 is on the engine side of the cat converter sensor 2 bank 1 is after the cat converter (drivers side )
bank 2 is on the passenger side sensor 1 is pre cat sensor 2 is post cat converter
424 views
Usually answered in minutes!
×