At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: Not getting gas to motor put in new fule pumper and...
Check fuel pump relays. there should be a reset button and or switch. mine was located behind my glove compartment. check your manual for location. also check fuses for fuel pump fuses.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If the injectors do not fire, fuel in the rail does not matter since it's not getting gas into the engine. Look to see if your check engine light comes on, when you turn on the ignition. If it does not, then your ecu computer is in need of repair since it's not sending either a spark or fuel injector signal to fire up your jeep.
May have sucked up sedement from the bottem of the fuletank. Try blowing out fule line with compressed air. If it is clear and problem persists, change fule pump
Sounds like it. On new automobiles the fuel pump is in the gas tank, cools the pump, but you can disconnect the pump and put on an outside pump instead of pulling the gas tank and replacing gas pump and tank. Leave old pump in gas tank.
you may have an air leak in the fule line from the fule tank this is letting fule run back to the tank when you stop the engine running over night check all the fule pipes are air tight and do not have crossed or striped threds on them
Hi:
You can do some basic tests to check for fuel. A simple one is to take off the gas cap, and have someone listen for the pump to run for a few seconds when the key is turned on. you can also remove your fuel filter or check for fuel pressure with a fuel pressure guage too. Often you can get a guage loaned to you from the auto parts store, for just a deposit.
these were hard to fix when they were new in 1990, question:::: does it run and rev-up hi normally in neutral/park??? with a timing light does the distributor show full advance???you claim "CUTS-OUT", like back-firing ??you may need to test the COIL, TPS (throttle position sensor) and LOOM to isolate the cause,.. try those and let me know the outcome....GL
its your fule filter theres 2 of them i the 86 ford ranger you need to change them the location of the fule filters are on google just tipe in fule filter 1986 ford ranger location it should pop up there about 8 dollors a peace easy fix and your truck is like new also get a new battey if you havent k have a good day. oh i know this because i own one had the same problem
×