2003 kia rio, It is located under the intake manifold. Get underneath the car, pull the oil filter...it is right above it and in clear view with the oil filter out of the way. The connector plug is up top behing the air breather on the firewall.
Most knock sensors are located either on the back of the engine closser to the fire wall or under the intake manifold ..... good luck.
Testimonial: "THANK YOU "
Where abouts is the knock sensor on a Kia cerato
SOURCE: where is the knock sensor located at on 2003 kia
you have to take off the air cleaner box and its on the back of the engine you have to reach down between the fire wall and the mainafold it right there in the middle
SOURCE: need to replace knock sensor/ O2 sensor 04 kia rio
IT IS IN THE SIDE OF THE ENGINE BLOCK, SCREWED INTO THE WATER JACKET OF THE BLOCK
SOURCE: need to know where knock sensor is located on a 2001 kia rio.
At center rear of engine compartment, by intake manifold support bracket.
SOURCE: knock sensor replacement
Turn ignition off. Disconnect knock sensor 3
-
pin harness connector. Locate knock sensor, on cyli
nder block.
On Optima 2.7L engine, sensors are located on both
sides of cylinder block. . Remove knock
sensor from cylinder block. To install, reverse rem
oval procedure.
SOURCE: omi replaced a knock sensor
Did you delete the code ? Maybe it wasnt the knock sensor but the wiring to it. When we get a code we check all that is involved, wiring, connector, corroded connector terminals, then we test the sensor. If there is a fault in the wiring and or connector, this will set a code for the sensor indicating the need for a proper dignosis.
4,167 views
Usually answered in minutes!
×