Question about 2002 Ford Ranger Regular Cab

1 Answer

Looking for the location of the cps on 2002 ranger 3.0L

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 279 Answers

Mounted on the front of the engine timing cover passenger side.

Posted on Feb 09, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

3,0L Ford ranger 91 want shift into over drive.did before I pulled trans to replace rear main seal in Truck.please help


Overdrive is engaged with a torque convert clutch lockup. ATF travels through the splined shaft on the transmission to the torque converter. Check the seals on the converter and the trans.

Aug 25, 2015 | Ford Cars & Trucks

1 Answer

WARE IS THE STATER RELAY ON A 2002 FORD RANGER?


the starter relay is located near the battery on the fender well! It will have 2- 9/16" or 13mm nuts on top. It is black and round, and also has at least 1 push plug wire on it. if you look on the wheel well there will be 2- 10mm bolts holding it in place!

Feb 25, 2015 | 2002 Ford Ranger

2 Answers

Where is cps located on 2002 town and country


on the bellhousing it picks up the sensor on the flywheel

Aug 25, 2014 | 2002 Chrysler Town & Country

2 Answers

Where is the cam shaft senser on a ford ranger 2.5 td 2002


Ford did not put a 2.5 in a Ranger, maybe a 2.3 ?
2.3 = 2007-01-27_154722_2.gif
3.0 - The CMP sensor& synchronizer/shaft are located behind the intake manifold (i.e., back near the firewall on a Ranger) on the top of the cylinder block. If you just need to replace the sensor, it is a simple job of unplugging the electrical connector and removing the screws holding the sensor in place. Here is a sketch of the sensor to give you an idea what to look for:

Jun 17, 2014 | 2002 Ford Ranger Regular Cab

1 Answer

Where is crank sensor


If you go to Google and type in "2002 GMC Yukon XL Crankshaft Position Sensor"...click enter...then look for the tab that says "images". The first image I found shows the location of the CPS. If you're not able to view the image, the sensor is located on the lower right rear of the engine block.

Good luck!
Jason

May 21, 2014 | 2002 GMC Yukon XL

1 Answer

Cps location 2002 mercury sable


The crank sensor on the 2002 DOHC engine is located just under the alternator and you can change it but you have to get at it from underneath the car.

rotundx_1.jpg

May 15, 2011 | Mercury Sable Cars & Trucks

1 Answer

Where is the camshaft position sensor(CPS) located at on a 2002 GMC Safari Van


2002 Safari 4.3L engine, cam sensor, same as pick-up coil, sits in ignition distributor, will be the one with three wire connector, held on with two small bolt's in the distributor.

Nov 11, 2010 | 2002 GMC Safari

1 Answer

Location of the crank positioning sensor on a Ford 1999 e350 v10 std emissions?


The CPS is located in the engine block right next to the A/C compressor. You'll have to unbolt the compressor to have room to remove the CPS. Don't remove the A/C lines, just unbolt the compressor so that you can move it out of the way. There is one bolt holding the sensor in place and you can just pull it out after you remove that bolt.

Mar 04, 2010 | 2002 Ford E350

1 Answer

Location of a sensor


Replacing a CPS can be easy or hard. On the 2002 Gallant 2.4, it is located behind the timing belts. Removal of the main pulley, the covers and the belts is required. This isn't as hard as it sounds and is essentially the same as changing the timing belts.

Apr 20, 2009 | 2002 Mitsubishi Galant

1 Answer

WHERE IS THE CIGAR FUSE LOCATED IN A 2002 FORD RANGER?


you should be able to download the owners manual from www.fleet.ford.com the fuse location is in it

Mar 31, 2009 | 2002 Ford Ranger Regular Cab

Not finding what you are looking for?
2002 Ford Ranger Regular Cab Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

83083 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

gerry bissi

Level 3 Expert

4387 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...