Question about 1986 Chrysler LeBaron

1 Answer

Not getting spark

I have changed the coil,the part under the coil, the rotor, the spark plugs and the spark plug wires, I have seperated all the wires under the hood looking to see if there is an in line fuse that has blown, I cannot figure out why it still won't start. This all started when I shut the car off when it was running great. I sprayed some engine cleaner on the engine last week so I thought I would wash it down/being very careful not to get water on the distributor or in the fuel injection or on the altenator. I obviously wasn't careful enough because it hasn't been able to start since. Is there something before the coil that is not letting voltage get to it because it will still notfire up, and I do have plenty of fuel, I even sprayed starting fluid in what looked to be a carburator, still nothing. please help!!

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 237 Answers

Cam sensor is bad,(not telling the new parts to fire.)

Posted on Dec 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 Chevy Suburban will not start and has no spark


Check all fuses under the hood. Test the coil with an ohmmeter. Check for battery voltage on the coil primary with key on.
If all good, suspect the crank position sensor. A bad sensor will cause no spark.

Nov 19, 2013 | 1993 Chevrolet Suburban

3 Answers

Ignition mystery! 1994 GMC Suburban 2500 5.7 mtr. No spark to spark plugs. Have spark from coil to distributor. Have changed coil wire, cap, rotor, ignition module, and coil. have 12.5 volts going to...


I guess you could have the ignition analyzed on an oscilloscope. Maybe a tech could see something then.
I always heard the only gap was the spark plug gap-the rotor has no gap-are you sure you got the correct rotor? And does it touch the top distributor cap coil wire tower?

Let us know. It is a mystery worthy of a solution.

Sep 21, 2013 | Chevrolet Suburban 2500 Cars & Trucks

2 Answers

Van has a misfire ,stumble problem only on hills ,We put new plugs ,wirescap and rotor and a new coil .New fuel filter too it still has a definate buck ,miss stumble


Try changing the ignition control module. Also run some good fuel injector cleaner through it. Lucas, gumout, or marvel mystery oil are good options. Also, open the hood at night and make sure the spark plug wire are not arching on something metal under the hood. Check the spark plug gap, make sure the wires are not crossed also.

May 05, 2011 | GMC Safari Cars & Trucks

1 Answer

Miss fire 1 and 5 changed wires and plugs


Probably coil pack. Follow spark plug wire from spark plug to where it plugs in, that is your coil pack.Some are seperatable. Depending on motor size you may have coil over plug. You said wires not (cop) coil over plug boots.If it is coil over plug it is just a boot you changed in that case the coils plug into boots & on plug & an electrical connector. They are seperate for each cylinder.

Jun 06, 2010 | 2003 Ford E250

3 Answers

I have put in a new ignition coil, coil and rotor. And still no spark in my 1996 jeep cherokee counrty.


ignition module is not active it sounds to the coil. have that checked out next

Feb 10, 2010 | 1996 Jeep Cherokee Country

2 Answers

No spark to the plugs.


Check fuses inside the engine compartment. Remove each one, and plug it back in, to make sure it has a good contact.

Oct 01, 2009 | 1993 Dodge Dakota

4 Answers

Car will not start when it's raining


9 of ten times that's caused by bad ignition wires, cap, rotor or sometimes even the ignition coil. Dampness makes it easier for spark to bridge a gap and jump to ground when wires are porous or there are carbon tracks on the other components. If the spark escapes before it gets to the plugs, the engine will not start.

Sep 21, 2009 | 1996 Ford Aspire

2 Answers

1991 Honda Civic Won't Start


Try doing an ohms test on your fuel injectors. Sounds like 1 or 2 could be bad.

Jun 17, 2009 | 1991 Honda Civic

1 Answer

Chevy K1500 - Coil and plug spark loss


This is more common when there is a high level of moisture in the air especially with older components. Moisture can settle on the distributor and wires and act as a conductor. Since you are still having this problem with the new parts I would suggest using a moisture dissipating spray such as WD-40 or PB Blaster.

Dec 05, 2008 | 1994 Chevrolet K1500

Not finding what you are looking for?
Cars & Trucks Logo

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

83772 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...