Question about 2005 Mercedes-Benz E-Class

1 Answer

Hello i recently got a rear licance both the

Hello i recently got a rear licance both the right and left light malfunction and also the third brake lamp malfunction on the warning panel of my e200mercides 2005 model .also i noteced i cant any more open the rear ponet using the rear ponet open s/w on my left hand driver door,the only way i can open it is manual by using the small hidden key on the remote key.
thanks.
shahem2000@yahoo.com

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 73 Answers

Lamp malfunction light is telling you your bulbs are blown. yoo probably need new batteries in your remote. use only mercedes bulbs!!1 parts store bulbs dont work in a benz..

Posted on Dec 13, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

08 Buick lucerne cxl. Third brake light works as well as front signal lights. No rear brake lights or turn signals. Tail lights and headlights and third brake lights works. Bulbs good. Help


Stop Lamps
The brake pedal position sensor is used to sense the action of the driver application of the brake pedal. The body control module (BCM) provides a 5-volt reference voltage and low reference to the brake pedal position sensor. The position sensor provides an analog voltage signal back to the BCM that will increase as the brake pedal is applied. When the brake is applied, the BCM will then apply battery voltage to the left and right stop/turn signal lamp supply voltage circuits and the center high mounted stop lamp (CHMSL) supply voltage circuit illuminating the stop lamps. At the same time the BCM applies battery voltage through the signal circuit to the transmission control module (TCM) and the engine control module (ECM) indicating that the brakes are applied.
Ground for the stop lamps is supplied as follows:
• G402 provides ground for the left rear stop/tail/turn signal lamps
• G403 provides ground for the right rear stop/tail/turn signal lamps
• G301 provides ground for the CHMSL
The stop lamps on this vehicle will not illuminate unless the ignition is in the accessory, run, or crank positions. When the ignition is in the OFF position the stop lamps will not illuminate when the brake pedal is applied.
Battery voltage from the LT TRN/SIG and RT TRN/SIG fuses located in the rear fuse block is also used by the body control module (BCM) for stop lamp operation.

Turn Signal Lamps
Battery voltage supplied to the body control module (BCM) from the fuses listed below is used for turn signal and hazard lamp operation.
• LT TRN/SIG fuse for the left turn signals
• CTSY/RF TRN fuse for the right front turn signal
• RR TRN/SIG fuse for the right rear turn signal
When the turn signal switch is place in either the LEFT or RIGHT position, ground from G300 is applied through the turn signal switch signal circuit to the BCM indicating the turn signal request. In response to this signal, the BCM applies a pulsating voltage to the front and rear turn signal lamps supply voltage circuits cycling the lamps ON and OFF. At the same time the BCM sends a GMLAN serial data message to the instrument panel cluster (IPC) to cycle the appropriate turn signal indicator ON and OFF.
Ground for the turn signal lamps is supplied as follows:
• G104 provides ground for the left and right front turn signal lamps
• G402 provides ground for the left rear stop/tail/turn signal lamps
• G403 provides ground for the right rear stop/tail/turn signal lamps

Do you have a factory scan tool (tech2) ? Your best bet , take it to the dealer .

Sep 08, 2017 | Buick Cars & Trucks

1 Answer

Need to hook up a hopkins converter trailer light system up to 2008 jeep compass; Dont't have the wiring harness system. I have four wires to connects: Brake. trun RT, turn LF, tail, and ground I...


The Left Turn signal is DARK GREEN/RED
The Right Turn signal is WHITE/YELLOW
The Left Brake light is WHITE/ORANGE
The Right Brake is WHITE/RED
The High-Mount Brake lamp is DARK GREEN/WHITE

Now, with all that said, your Jeep should be already equipped with trailer wiring unless you have the cheapest model of Jeep Liberty available. I would check your Owner's Manual on the subject.

Also, your rear lighting is controlled by the Body Control Module (BCM) and the signal and brake inputs/outputs are all transmitted to the Instrument Cluster Module for your lamp-out warning system. Anything you connect to this wiring can adversely affect BCM function or can cause your lamp out warning to malfunction and come on all the time. I would use extreme caution unless you really want to destroy some HIGH DOLLAR electronics in your vehicle.

Sep 11, 2011 | Jeep Compass Cars & Trucks

1 Answer

Abs warning lamp circuit malfunction-11 left front wheel speed input signal-21 right front " "-22 left rear " ...


Have you checked the fuse ??? if so i would suspect wiring . Or the abs ecm mogul

Jan 23, 2011 | 1995 Buick Regal

1 Answer

Brake light dont work. 2006 chevy truck, 4.8L 2wd


Some of these had two fuses for brake lights. One for the top/center stop lamp and another for the rear left and right brake lights. Usually one said "stop" and the other said "brake" and one was in the underhood panel while the other was in the dash fuse panel. It's not uncommon to blow a brake light fuse [LR and RR] if you tow a trailer but some of these had seperate fuses for the trailer lights also. If you have a test light check both sides of the two fuses for power [ignition key on] while stepping on the brakes. It should at lest narrow your search a bit.

Jun 08, 2010 | 2006 Chevrolet Silverado 1500 2WD

1 Answer

How do i change a brake light bulb on 2000 vw jetta?


Removing:
  • Switch off all electrical consumers, switch off ignition key and remove ignition key.
  • Remove rear luggage compartment side panel trim (left or right).
98971821.gif
  • Remove 3 nuts, arrows, and remove housing.
  • Remove bulb holder.
Installing:
  • Install bulb holder.
  • Insert housing into body opening.
  • Tighten nuts.
  • Install applicable rear luggage compartment side panel trim.
Rear Light Bulb Holder Removing And Installing:
Removing:
  • Disconnect electrical connector.
  • Depress retainers, arrows, and remove bulb holder.
98971817.gif Installing:
  • Install in reverse order of removal.
And the Center Mounted Brake Lamp.
High mount Brake Light Removing And Installing:
The high mount brake light is installed in the rear shelf.
98971288.gif Removing:
  • Switch off all electrical consumers, switch off ignition key and remove ignition key.
  • Disconnect electrical connector from high mount brake light.
  • Remove rear shelf
  • Un-clip high-mount brake light from rear shelf, arrows.
  • Install in reverse order of removal.
NOTE: The bulb holder base plate contains soldered- in light emitting diodes (LEDs) that are not replaceable. In the event of LED malfunction, replace complete bulb holder.
Additional

Mar 13, 2010 | 2000 Volkswagen Beetle

1 Answer

Right turn signal and brake lights working together.


do you have a plug in for a traler in the back? if yes check for corosion. does your problem happen on the left side too?

Apr 05, 2009 | 1994 Nissan Pickup

1 Answer

I need a printable image of fuse block / 97 ford windstar


your owner manual sould have fuse chart. Some fuses/ekays in enine compartment. Some in car on left side of instrument panel

in car

1d470b5.gif
Fuse Amps Circuits Protected 1 10 Power Mirrors, Anti-Theft Warning Light, Diagnostic Connector 2 5 Generic Electronic Module, Start Interrupt Relay Coil 3 5 Radio Illumination, Remote Radio Illumination, Electronic Instrument Cluster, Electronic Instrument Cluster PRNDL Illumination, Electronic Instrument Cluster Switch Module, Analog Cluster Illumination, Instrument Illumination 4 — Not Used 5 — Not Used 6 15 Rear Quarter Windows (LH and RH) 7 15 High Mounted Stoplamp, Brake Shift Interlock 8 25 Subwoofer, JBL Amplifier 9 10 Park and Turn Lamps, Side Marker Lamps, License Lamps, Stop Lamps 10 2 High Beam Indicator Electronic Cluster 11 15 Park Lamps 12 10 Remote Radio, Auxiliary Warning Lamp Module, Remote Keyless Entry (RKE) Module, Anti-Theft Controller Module, Radio Illumination 13 15 Radio, CD Disc Changer 14 5 Electronic Chromatic Mirror, Analog Cluster Indicator Lamps, Air Bag Module 15 — Not Used 16 15 Horns, Horn Relay Coil 17 15 Fog Lamps 18 25 Front Wiper Motor, Front Washer Pump, Wiper/Washer Relays 19 10 Generic Electronic Module (Pin 57), Electronic Instrument Cluster 20 25 Integrated Relay Control Module, Ignition Coil 21 10 Air Bag Module, Rear Window Defrost Relay, A/C Clutch, Temp Blend Door Actuator, Brake Shift Interlock 22 20 Rear Cigar Lighter, Power Plug 23 15 Multi-Function Switch 24 20 Rear Wiper Motor, Rear Washer Pump 25 10 Turn Signal Lamps, Instrument Cluster Turn Indicator 26 15 LH Aero Headlamp, Left and Right Trailer Stop/Turn/Hazard 27 15 Hazard Warning Lamps, Instrument Cluster Turn Indicator 28 15 Instrument Panel Cigar Lighter 29 15 Battery Saver Relay, Interior Lamp Control Relay, Interior Lamps, RH and LH Keyhole Lamps 30 25 Backup Lamps, Electronic Cluster 31 10 Rear Air Suspension 32 15 RH Aero Headlamp, Trailer Park Lamps 33 15 Anti-Lock Brake (ABS) Relay, Anti-Lock Brake (ABS) Module, Daytime Running Lamp (DRL) Module 34 30 One Touch Relay, LH Window Motor 35 15 Anti-Theft Controller Module 36 30 A/C Mode Switch 37 20 Door Lock Actuators, Memory Door Lock Relay 38 15 Heated Mirrors (LH and RH) 39 30 Auxiliary Blower Motor, Ref. Valve Solenoid 40 30 Window Motor (RH) 41 5 Autolamp Relay Coils, Autolamp Sensor 42 — — 43 — — 44 — —

Mar 15, 2009 | 1997 Ford Windstar

1 Answer

I have a 2001 hyundai elantra and the warning lights on the dashboard. I know what the oil light looks like and the airbags. What are the other two lights.


Your best bet is to go HERE and signup for a free account then Downloading your Manual - service sheets, diagrams, parts lists etc.
Hyundai is one of the best with providing their customers with free information about the vehicles!!

I have D/L the manual, and the warning lamps on the instrument cluster are...
Left to right...(starting under temp. Gauge)

WITHOUT TRIP COMPUTER
11. Traction Control Indicator Light (If installed)

12. ABS Warning Light (If installed)

13. Seat Belt Warning Light

14. Oil Pressure Warning Light

15. Charging System Warning Light

16. Parking Brake/Brake Fluid Level Warning
Light

17. Malfunction Indicator Light (MIL)

18. SRS (Airbag) Warning Light

19. Trip Odometer/Odometer

20. Trip Odometer Reset Knob

21. Low Fuel Warning Light

WITH TRIP COMPUTER

7. Front Fog Indicator Light (If installed)

8. Door Ajar Warning Light

9. Trunk Lid Open Warning Light

10. Parking Brake/Brake Fluid Level Warning
Light

11. Malfunction Indicator Light (MIL)

12. Charging System Warning Light

13. Oil Pressure Warning Light

14. SRS (Airbag) Warning Light

15. Cruise Indicator Light (If installed)

16. Seat Belt Warning Light

17. ABS Warning Light (If installed)

18. Traction Control Indicator Light (If installed)

19. Automatic Transaxle Position Indicator Light
(Auto T/A only)

22. Low Fuel Warning Light


Thanks for using FixYa - a FixYa rating is appreciated!!

Feb 21, 2009 | 2001 Hyundai Elantra

1 Answer

Warning light on dasher


This is the taillamp failure indicator. You either have a burned out taillamp or a burned out brake lamp bulb(s). Please make sure when you check for inoperative brake lamps that you make sure that the brake lamp in the rear window works, also.

Oct 20, 2008 | 2001 Toyota Camry

Not finding what you are looking for?
2005 Mercedes-Benz E-Class Logo

205 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

Marvin
Marvin

Level 3 Expert

83810 Answers

jalal

Level 2 Expert

169 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...