Question about 1988 Toyota Pickup

1 Answer

Hi I have a 88 Toyota pickup with a carbed 22r motor. Sunday I ran it all day just like usual, Monday I get in it and it will not start. I have checked fuel, spark and have sprayed starting fluid in the carb, still nothing. It has new plugs, cap, rotor and wires. Any ideas would be greatly helpful thank you

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 486 Answers

RUN A DIRECT FEED TO THE IGN SIDE OF THE COIL, FROM BATTERY, IF THAT WORKS CHECK FEED FROM IGN SWITCH, U MY HAVE A BALLAST RESISTOR FAULT BETWEEN SWITCH AN COIL OR IMMOBILSLER FAULT

Posted on Dec 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I replaced my 1985 22r engine with an 22re engine,using carb off old engine. do i have to also replace my distrubutor and coil/igniter


repost with the spec differences beween the two engines Im a bit foggy here..Im thinkin one had or has intake restrictor plates under the intake for not letting hot gasses enter under the carb mount...

Jan 17, 2013 | 1985 Toyota Pickup

1 Answer

22r rough idle


Fuel injected or carburetor? If it has a carb check the idle circuit! Also look down the top of carb with air filter off and make sure fuel is not dripping down the inside venturies. Take some carb cleaner an check for a lean mixture at idle and also use the carb cleaner to check for vacuum leaks around base of carb.

Jul 03, 2012 | Cars & Trucks

1 Answer

My question is this I have a 1983 toyota pickup truck with the 22R engine.About a week ago I pulled out ot my drive way and when the motor warm up it started to run rough and black soot was coming from my...


black soot is a running rich condition it's getting to much gas not enough air .. 14-1 ratio air to gas your carb rebuild needs to be rechecked for sticking float..

Nov 19, 2009 | 1983 Toyota Pickup

1 Answer

Toyota 22r starts hard and floods. Repalced


It sounds like the carb. float is set to high and /or the needle and seat has some dirt in it allowing to much fuel inside the carb.. This will allow to much fuel into the engine.It seems the carb could use a rebuild and dont forget to replace your fuel filter.I hope this helps.

Sep 08, 2009 | 1983 Toyota Pickup

1 Answer

88 Toy, 22R Carb, hard cold start


in your carburetor there is a priming passage. look in there with the air cleaner out and pump the butterfly it should squirt gas. if it doesn't then you need to open the top part of the carb and clean the hole with a hair clip. if this is not the problem it will be the choke but I'm 70 percent that this is the problem.

May 25, 2009 | 1985 Toyota Pickup

5 Answers

Need to change engines


If you have a 22r carbed then all 22r carbed engines from 1981-1995 will interchange. You may need to use sensor out of your old engine however. The 20r,22r,22re,22ret all have the same mounts and tranny bolt patterns. how ever there are lot of differences. you can swap from a 22r to a 22re but you must also swap the entire vehical wiring harness to do it right. if you have a 3.0L i would keep the same engine. some people have swap to the tacoma 3.6L but that is a expensive swap not exsactly bolt on so to say. If you have a 22re then stay with the 1986-1987 22re because the newer 22re use different computers, electronics ,sensors and more.. Same story with the 22ret. I hoped this helped.

Mar 26, 2009 | 1987 Toyota Pickup

1 Answer

1988 2wd 22r toyota pickup not idling


You might check the PCV valve and grommet,I'm assuming it's EFI,if the valve isn't sealed tight it will cause the motor die at lower RPM's

Feb 05, 2009 | 1988 Toyota Pickup

Not finding what you are looking for?
Cars & Trucks Logo

227 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

83096 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...