Question about 2000 Mitsubishi Galant

2 Answers

Just had transmission replaced and thinking the fuse went out and the car want go into drive or reverse where is the fuse

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Typically fuses won't cause the symptoms that you are having. I would recommend checking the transmission fluid level. It is probably too low.

Posted on Dec 15, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 111 Answers

I would follow up on the warrenty of the trans replacement and let them fix it. Obviosly they did something.

Posted on Dec 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2007 hyundai sonata limited v6 fully loaded. i went to drive it started it up and put it in reverse and it slipped something terrible i then put it in drive and it didn't move. i then proceeded to...


I think your torque converter IS the problem. Because it's the only thing that attaches the engine to the transmission and it's designed to "lock up" at highway speeds for overdrive. If it locks up at idle it will kill the engine. If it locks up at slow speeds ( < 35mph ) the vehicle will lurch/buck... And if it wont move in forward or reverse I would say it's time for a new/rebuilt transmission

Dec 30, 2013 | 2007 Hyundai Sonata Limited Sedan

1 Answer

2004 nissan altima 2.5s will start but won't move in any gears


You have a failed automatic transmission. You will need to remove and replace it or have it rebuilt.

May 31, 2012 | Cars & Trucks

1 Answer

Changed starter and now transmission won't engage in reverse. What happened?


is the level of fluid ok ? im afraid your transmission went bad not because of the starter change but it just happen at that time

Jan 10, 2012 | 2003 Kia Sedona

1 Answer

The reverse lights went out-- where is the fuse?


There will be a switch for this,it will be on the transmission.Look at where the shift shaft is on the transmission,

Nov 22, 2009 | 1999 Buick Regal

1 Answer

Ignition fuse blows when in drive, but not in reverse


check wiring at transmission netural switch,on top of trans,chaffed or broken?Could even be the switch itself.Think you could start it in park,then unplug the switch,then try drive,still blow?

Aug 18, 2009 | 2001 Chevrolet Lumina

1 Answer

Transmission lost reverse


Speed Sensors, I think their are a few

Apr 22, 2009 | 2000 Jeep Grand Cherokee

1 Answer

1995 olds cutless is it my transmission


oil condition could be a problem
I am inclined to think that you took the car to an auto spares shop that does free fault codes reading, you will find that it is servos/ solenoids or problem TCM that is causing the problems
may even be problem wiring connectors or harness problems around the transmission
I am sure that it is not a transmission problem , just what controls the ration changes

Mar 15, 2017 | 1995 Oldsmobile Cutlass Supreme

1 Answer

Goes in reverse but dont move. in drive only goes 10mrh.


I think you need to bring that thing to a transmission shop. it is a bit surprising that a 5 y'old car would have a bad trans but maybe a transmission shop can save it. GL

Feb 01, 2009 | 2003 Dodge Stratus

1 Answer

Transmission failure


the only thing i can think of it being is a cv joint.The cv joint goes from the tranny to the front tires.Does the engine reve up when you give it gas?

Jan 10, 2009 | 2000 Ford Windstar

Not finding what you are looking for?
2000 Mitsubishi Galant Logo

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...