Question about 2002 Lincoln LS

1 Answer

I need to locate the battery for I can jump start the vehicle.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

Look in the trunk, beside the spare tire

Posted on Apr 14, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I can not start my car without my alarm going off


The battery is located under the rear seat cushion. To
access the battery, see "Removing the Rear Seat
Cushion" in the Index. You don't need to access the
battery to jump start your vehicle. See "Jump Starting"
in the Index.

Oct 25, 2013 | 1998 Volkswagen Jetta

Tip

Jump starting a Buick Lacrosse 2005


Jump starting
If your vehicles battery has run down, you may want to use another vehicle and some jumper cables to start your vehicle.
1.Check the other vehicle. it must have a 12-volt battery with a negative ground system.
2.Get the vehicles close enough so the jumper cables can reach, but be sure the vehicles are not touching each other. If they are, it could cause a ground connection you do not want. You would not be able to start your vehicle, and the bad grounding could damage the electrical systems.
3.Turn off the ignition on both vehicles. Unplug unnecessary accesories pluged into the cigarrete lighter or the accessory power outlets. Turn off the radio and lamps that are not needed. This will avoid sparks and save both batteries. And it could save the radio.
4.Open the hood on the other vehicle and locate positive (+) and the negative (-) terminal locations on that vehicle. You will not use yours vehicles battery for jump starting. It has a remote positive (+) jump starting terminal, located on the underhood fuse block, for that purpose.

on Oct 08, 2010 | Buick LaCrosse Cars & Trucks

Tip

Jump-start Jaguar X-type? it's more complicated than you think.


Jump Start of Vehicle Battery


IF THE BATTERY YOU ARE USING TO JUMP-START THE VEHICLE HAS RECENTLY BEEN CHARGED IT MAY STILL BE GASSING, COVER THE VENT PLUGS OR COVERS WITH A DAMP CLOTH TO REDUCE THE RISK OF EXPLOSION SHOULD ARCING OCCUR WHEN CONNECTING THE JUMP LEADS.

Turn off all electrical ancillary circuits such as radio, lights, indicators etc. If the reason for a flat battery is unknown the condition may be as a result of an electrical short circuit, so care must be taken during the Jump-start process and subsequent to connection to ascertain if this is the case. A short circuit or un-isolated ancillary load can cause arcing when the jump leads are connected, a small 'crackle' is normal but any spark or flash is an indication of a problem that should be rectified before attempting to Jump-Start the vehicle.

Jaguar do not recommended that the vehicle is jump started, and If at all possible it is preferable to replace the flat battery with a suitable fully charged unit rather than jump-start the car. However if it is done it should be carried out by suitably qualified personel. Garage services and services like AA and RAC homestart should be used whenever possible.

Obviously there are occasions when carrying out this proceedure yourself is the only practical way proceed.

If there is no option but to jump-start the discharged battery should be removed and recharged immediately after jump starting to avoid permanent damage.

High quality, heavy duty Jump leads must be used as the current consumption during starting is very high, and a voltage loss will be
exhibited though the jump leads, increasing current requirement.

Make sure that the Jump Start battery is of the same voltage as the vehicle, and suitable to provide the required starting current.

MAKE SURE THAT THE ENDS OF THE JUMP LEADS DO NOT TOUCH EACH OTHER OR GROUND AGAINST THE VEHICLE BODY AT ANY TIME WHILE THE LEADS ARE ATTACHED TO THE BATTERY. ARCING AND VERY RAPID DISCHARGE CAN CAUSE THE BATTERY TO EXPLODE.

Connect the jump leads in the following sequence.
Connect Positive Jump Lead to Jump Start battery positive terminal.
Connect Positive Jump Lead to Vehicle battery positive terminal.
Connect Negative Jump Lead to Jump Start battery negative terminal.
Connect Negative Jump Lead to a suitable vehicle ground point at least, 300 mm (12 in) from the battery terminal e.g. engine lifting bracket, do not do not connect directly to the vehicle battery terminal.

Start the vehicle and rev to 2000 rpm, then allow tickover for 5-10 minutes.

Do not attempt continued repeated starting of the vehicle, this will cause heat build up at the terminals and though the jump leads degrading the leads performance and adding to voltage loss.

Allow 3-4 minutes recovery time for the leads and Jump Start battery between attempts to start.

Before disconnecting the jump leads, switch on the heated rear screen, to reduce the alternator voltage peak when the leads are removed, as this can damage electronic equipment.

Disconnect the jump leads in the reverse order to the connecting sequence taking great care not to short the ends of the leads.

Do not rely on the alternator to restore a discharged battery.
Ensure that the battery is recharged or replaced with a fully recharged unit
as soon as possible.

Following Jump-starting of a compleately discharged battery, you may need to carry out a Green ECM drive Cycle, this will allow the powertrain control module to 're-learn' idle values, and most likely need to re-enter your radio code, details of these can be found at. http://www.bluejag.co.uk

on May 31, 2010 | Jaguar X-Type Cars & Trucks

2 Answers

Battery location


it is under the back seat. you need to lift out the bottom part of the back seat to get to the battery.

Oct 17, 2013 | 2002 Cadillac Deville

1 Answer

Jump start


c85a2fd9-af0e-4d08-89b4-66fb0b469e10.jpgThe motor home battery I couldn't teel you but if you're talking about the vattery for yhe charger, it's located in the Passenger side inside the trunk. There is a cover over it that has to be removed to get access to it. If jumping, there are posts next to the battery I believe designed just forr jumping. I would REALLY suggest just charging the motor home batteries or using a different vehicle to use. Have found on your kind of vehicle that sometimes when getting jumped or visa versa That it causes an electrical problem. there is a fuse link in the wiring directly (sort of) from the battery to the alternator. Have seen this fuse link blown a lot and MANY people change the alternator thinking the alt. is bad beause the battery goes dead not to mention the car letting you know thta there is a charging problem.Hope this helps.....

Jun 04, 2013 | 2007 Dodge Charger SRT8 Sedan

1 Answer

We do not know how to jump the battery for the back door is shut


Hello, there is a place under the hood you can use to jump start this vehicle. here is the instructions.


Locate the remote positive terminal which is located under a red tethered cap on the engine compartment fuse block. Remove the cap to access the terminal.
  • Do not remove fuse block cover to jump start the vehicle.
  • Locate the remote negative (-) ground terminal, marked GND (-), which is located at the front of the engine compartment on the driver side of the vehicle.



    mrtechwrench_0.gifmrtechwrench_1.gif

    Nov 04, 2010 | 2006 Chevrolet HHR

    3 Answers

    I forgot to turn off the lights in my car. What can I do to start the car running? Do I need to replace the battery?


    You can either jump the battery, or remove the battery from the car and bring it to your local repair shop to have it charged and tested, (a lot of auto supply stores will do this for free so call around), or you can jump start your battery and hope it holds a charge.

    To jump a battery you will need a set of jumper cables and a second car, or a battery booster pack, (nice investment, they really are handy in a jam).

    To jump a car with jumper cables:
    ******* Always where eye protection*********
    1) Open the hood on the dead car and locate the battery.
    2) Park the second car as close to the front of the dead car as possible, (just try to leave enough room to walk around the vehicles if you can).
    3) Open the hood on the second car and locate the battery.
    4) Attach the red, (positive) cable clamp to the Positive, (+) terminal of the battery on both cars.
    5) Connect the black, (negative) cable clamp to the negative, (-) terminal of the battery of both vehicles.
    6) With the second car running leave the vehicle to sit for about 5 minutes then attempt to start the dead vehicle.
    7) If vehicle fails to start, wiggle the cable clamps to create a better connection.
    8) If vehicle starts, remove the cable clamps negative first then the positive.
    9) You may consider bringing the vehicle to your local auto supply to have the battery load tested once the car has run for a while, (most auto supply stores will do this for free so call around)


    Using a booster pack is basically the same, except, you replace the second car with the booster pack. Follow the manufacturer’s instructions for charging the booster pack before use.

    Good luck. Please rate, thanks.

    Mar 07, 2010 | 2003 Toyota Corolla

    3 Answers

    Is it good to jump start a car with a new vehicile


    Yes it is ok to jump start a car with new car

    Feb 22, 2010 | 2008 Jeep Wrangler

    1 Answer

    Battery location


    Download a manual at this site:-
    http://safemanuals.com/user-guide-instructions-owner-manual/CADILLAC/SEVILLE%202000-_E

    "The battery is located under the rear seat cushion.
    To access the battery, see “Removing the Rear Seat
    Cushion” in the Index. You don’t need to access the
    battery to jump start your vehicle. See “Jump Starting”
    in the Index."

    Nov 10, 2009 | 2000 Cadillac Seville

    1 Answer

    Jump start a battery that's located in the trunk


    the same way you would if they were in the engine compartment.

    Jan 06, 2009 | 2007 Aston Martin DB9 Coupe

    Not finding what you are looking for?
    2002 Lincoln LS Logo

    Related Topics:

    87 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Lincoln Experts

    Marvin
    Marvin

    Level 3 Expert

    83624 Answers

    gerry bissi

    Level 3 Expert

    4387 Answers

    fordexpert

    Level 3 Expert

    5690 Answers

    Are you a Lincoln Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...