Question about 1998 Mazda Millenia

1 Answer

Need picture of supercharger installation - 1998 Mazda Millenia

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Mazda Master
  • 14,036 Answers

You need a repair manual.

Posted on Dec 12, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Vacuum diagram wh L67 1999 holden statesman ?

I've just put L67 vacuum lines into "images" on bing and got all sorts of pictures, start there?

Nov 15, 2014 | Cars & Trucks

3 Answers

Serpentine belt on a 3800 supercharger

there should be a decal under the hood somewhere that shows the belt routing. if its gone you can probably go to the library and find a book of your car that will show the routing and you can either draw a picture or take a photo of it.

Aug 19, 2014 | 1995 Buick Riviera

2 Answers

Just replaced the supercharger belt I am trying to release the tension to get it around the supercharger pulley. How do I release the tension of the belt?

There are 2 sepentine belts on your vehicle. You must use a wrench to turn the belt tensioners. Usually a breaker-bar works well.

The tensioner for the outer belt is below the power steering pump and is easier to get to with the vehicle jacked up and the wheel and plastic splash-shield removed. The tensioner for the inner belt (the one for the supercharger) is located between the alternator and the supercharger. (see picture)


Aug 28, 2011 | 1995 Buick Riviera

1 Answer

Can i put a supercharger on a 08 3.7L grand cherokee 2WD. and can i get the instructions on how to install one.

Factory non-supercharged engines are not really designed for use with a supercharger.
A supercharger increases your cylinder pressure which will cause head gaskets to fail, or worse,
damage to the pistons, connecting rods, bearings and possibly even the block.
Next thing to consider is that the entire driveline was not designed to accommodate a large horsepower increase. So, even if you were incredibly lucky and the engine did not fail, you'd find yourself replacing transmissions, driveshaft joints, differentials and axles at an astounding rate.
A half decent supercharger would cost you over $1500. You cannot just bolt one on and expect it to work. In addition to the SC, you'd need to change/alter your ignition system and add a far better exhaust system as well as altering your fuel delivery system. Doing that properly would run at least the same as the supercharger costs. So even if what I said about damage was false (which it's not) You could expect the entire install to cost double what you thought.
Much easier to buy another vehicle with a larger engine or install a larger one in yours (including computer and harness, with the transmission made for that engine).
So, available or not, it's not a good idea though it sounds impressive to say you have one on your vehicle. Even on race cars, they need constant attention and are only used when it's absolutely necessary to be competitive in a particular class.
Sorry if you are disappointed, but those are the facts!!!!

Feb 12, 2011 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Would replacing a power steering pump in a 2002 Grand Prix GTP Supercharger cause the SuperCharger belt to break.


The supercharger belt is on the main drive, the water pump is on the accessory drive. Provided that they are both properly installed of course.

Jan 14, 2011 | 2002 Pontiac Grand Prix

1 Answer

How to repair a supercharger

Fig. 1: Supercharger assembly and related parts 84303024.gif

  1. Disconnect the negative battery cable.
  2. Remove the accessory drive belt from the supercharger pulley.
  3. Relieve the fuel pressure and remove the fuel injector sight shield.
  4. Disconnect the fuel pipes from the fuel rail and vacuum hose at the pressure regulator.
  5. Disconnect the electrical connectors from the fuel injectors and remove the fuel rail mounting bolts. Remove the fuel rail with the injectors intact.
  6. Disconnect the electrical connectors at the IAC, TPS, MAF, EGR and boost control solenoid. Lay the wiring harness aside.
  7. Remove the air intake duct and remove the EGR pipe from the supercharger.
  8. Disconnect the throttle cable and the cruise control cable. Remove the cable bracket.
  9. Remove the tensioner bracket to supercharger mounting stud.
  10. Remove the supercharger to intake manifold bolts, remove the supercharger from the intake manifold. Remove the supercharger gasket and coolant passage O-rings. To install:
  11. Replace the oil passage O-rings and the supercharger gasket.
  12. Install the supercharger and bolts. Install the tensioner bracket-to-supercharger bolt. Tighten the bolts to 19 ft. lbs. (26 Nm).
  13. Install the cable bracket and connect the throttle and cruise control cables.
  14. Connect the EGR pipe to the supercharger and install the air intake duct.
  15. Connect the electrical connectors to the IAC, TPS, MAF, EGR and boost control solenoid.
  16. Install the fuel rail and bolts and tighten the bolts to 15 ft. lbs. (24 Nm).
  17. Connect the connectors to the fuel injectors and the vacuum hoses at the pressure regulator.
  18. Connect the fuel pipes to the fuel rail and install the fuel injector sight shield.
  19. Install the accessory drive belt to the supercharger and connect the negative battery cable.

Jul 14, 2010 | 1992 Buick Park Avenue

1 Answer

Need to replace supercharged engine and trans. in a 96 Riviera

Faster and safer to drop the whole unit from the bottom with the cradle. Replace the supercharger snout bearing and seal before you install the replacement engine and the supercharger belt. Also replace the boost valve to your transmission just to ensure your getting the proper transmission line pressure throughout your transmission.
Thank you for using fixya and be safe

Jun 02, 2010 | 1996 Buick Riviera

1 Answer

Replace a96 mazda millina supercharger in a take out and out back in just where the hoses go in the supercharger? offers free online manuals with instructions and illustrations/pictures/diagrams when you sign up for a free account and add your cars to your "online garage" there. This is the best way to get The locations for hook-ups on your supercharger.

Hope this helps,

Sep 20, 2009 | Mazda Millenia Cars & Trucks

1 Answer

Wanna know if i can put a tranny for basic 1995 riviera in my Supercharger

you will most probably need a beefed up tranny to take the power of the engine, I have just installed a 350 supercharged chevy motor in my sons car with a Turbo 350 transmission and a shift kit which I have been told by an auto trans mechanic may not take the power of that engine.
It is costing him $1500 australian to have it reconditioned so I hope it will survive the rides

May 10, 2009 | 1995 Buick Riviera

1 Answer

Remove supercharger on pontiac GTP 1999

Technically you are supposed to (change the s/c gasket) but if your careful and don't tear it, you don't really need to.

Be sure to inspect the yellow coolant o-rings.

The gasket thickness isn't going to matter at all on the supercharger gasket.

Perfect oportunity to install that Intercooler you always wanted ;)

Nov 10, 2008 | 2007 Cadillac CTS 3.6L

Not finding what you are looking for?
1998 Mazda Millenia Logo

Related Topics:

162 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

83036 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides