Question about 1994 Chevrolet K1500

1 Answer

Alternator wiring not right. not charging battey, retofit 350 chev in place of v 6 how do I hook it up ?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 755 Answers

Did you use the same alternator? This is a two wire unit correct?

A V6 alternator might be setup with a larger pulley so it turns slower which might not turn fast enough using a V8 pulley setup.

Look here for a wiring setup you can try.

Good luck and be careful.

http://www.rowand.net/Shop/Tech/AlternatorConversions.htm

Posted on Dec 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I own a 68 got and it will not stay running when the positive cable is removed from battey. I did this to check the alternator for output. I have replaced the voltage regulater on the fire wall and traced...


you didnt say if you've had the alternator tested or not, usually when the car dies after removing the positive cable, it is a sure sign of a bad alternator. i would start there

Mar 10, 2013 | Cars & Trucks

1 Answer

Car


charge the battery then remove the negative cable place a test light between the battery and the negative cable if the light is bright you have a draw remove fuses one at a time til the light goes dim then thats the draw you might also need to unplug and remove the wires from the alternator to see if the diodes inside failed

Sep 02, 2012 | Cars & Trucks

1 Answer

I have 1988 camaro i-roc it had a v-6 in in it some one change it over to 350 can,t get it to charge can you help think sam


the alternator wiring is the same for both engines.make sure you have power on the large red wire at the alternator and the plug connector is clean and tight for the 2 wire plug for the regulator.it should have a small wire from the battery wire to this 2 wire plug and the brown wire is generally used to put out the light on the dash when its charging.next there is a D shaped hole on the back of the alternator that you can insert a metal cotter pin into until you feel a tab and ground the tab with the cotter pin by touching the pin to the alternator case and the charging system should start to charge.use a volt meter to check the voltage.if it doesn`t charge when you do this or you don`t hear the charging system start to charge then the voltage regulator is not working and needs replacing.

Apr 12, 2011 | 1988 Chevrolet Camaro

1 Answer

1986 ford f 350 6.9 diesel charging problem


Your alternator dosent work properly rechaange it again

Oct 23, 2017 | 1986 Ford F 350

1 Answer

84 CK TRK, 2500, 5.7L 55,000 miles have replaced alternator twice - battery still reads 12 volts. Trickle charge on battery OK and engine starts up OK - terminal 1 on alternator wire (brown) reads 2.4volts...


On some of the older style GM's you can take that brown wire and cut it and take the end leading from the alternator and hook it directly to the hot terminal on the alternator and just leave it hooked up and it will work. But I have ran into the occasional problem where leaving it hooked up will drain the battery when the vehicle isn't running. Hope this helps..

Oct 24, 2009 | Chevrolet Silverado 2500 Cars & Trucks

1 Answer

I need wiring diagram for 1989 chev alternator=4-pin type


all you need is one wire to the pin marked i or L to come live with the key and it will charge.the alternator does'nt need anything but power from the charge light[L terminal] to function normalll.

Jun 23, 2009 | 1989 Chevrolet S-10 Blazer

1 Answer

Battery indecator light on on dash


Check to make sure that there's power from the alternator to the battery on the charge-back wire. If nothing's there, then your alternator is junk and you'll have to replace it again.

May 21, 2009 | 1997 Ford Escort

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

176 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

83810 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...