Question about 2003 Ford Expedition

1 Answer

The expedition goes to 30mph then just continues to increase the rpm's no speed or transmission engaged. if you turn off the over drive it drives fine, or if your in 2nd.

Posted by on

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,515 Answers

Hi.

Usually this is a Case Of Vacuum Leak. Do you see Check Engine Light being ON?

If yes, Do not Ignore it. Take the Car to the Auto Zone / Dealer and Get it Scanned for Error Codes. Once you Get the Car Scanned, you would Receive some Codes like P0171 or so. Tell us and we would tell you How to Fix this.

Still, If you do not see any Check Engine Light, Still Look for Vacuum Leak, Take a Can of Carburetor and spray it around the intake area.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Posted on Dec 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the maximum speed ford expedition 8 cylinder 232 hp 2001


Maximum speed is determined by engine rpm, divided by transmission gear ratio, divided by final drive ratio, times tire circumference (tire diameter times 3.14) However, the electronic governor limits the 2001 expedition to around 100 mph.

Dec 18, 2017 | Ford Cars & Trucks

1 Answer

1998 dodge Dakota p.u. transmission rpm rises very high before engaging.


low on fluid likely , meaning a leak
or the clutch in the transmission is bad
or the vacuum modulator is acting up

all guesses

May 09, 2015 | Dodge Cars & Trucks

1 Answer

1996 Taurus GL 3.0 OHV. How to diagnose trans popping out of drive?


Most likely you have a linkage problem between the shift lever and the transmission and or the rubber bushings for that linkage are bad. It can also be the pivot point of the shift lever.

Mar 21, 2015 | 1996 Ford Taurus

1 Answer

Toyota corolla hatch 2002 idle at 2000 rpm when


All the above is normal , except 2000rpm is a little high at idle . can be adjusted down to 1500rpm. the computer adjusts the engine speed . in drive the transmission loads up the engine idle drops to 1000rpm . in park engine unloaded rpm increase all normal.

Sep 17, 2014 | Cars & Trucks

1 Answer

Car surging


Is the car equipped with the Automatic Transmission?
If so, read on.
Otherwise skip to the end and answer some questions.

POSSIBLE SCENARIO:
I have observed a condition where my car surges slightly when the torque-converter clutch (TCC) cycles between lock and unlock when driving on an uphill grade.
First some basics and history that will explain why the TCC is used.

Engine, Torque Converter, TCC, and Transmission relationship--
The TCC allows for a solid connection between the engine and transmission which allows the input to the transmission to rotate at the same speed as the engine.
Without a TCC, there is slippage between the engine and automatic transmission. The slippage is greatest at low engine RPM. That is what allows the engine to run with the automatic transmission in gear, like when you first shift into gear or stop at a stop sign. When the throttle pedal is depressed, the engine RPM begins to increase and the torque converter begins to slip less and less the more the engine RPM increases. The car moves. But even at cruising speeds the torque converter slips slightly. Engine RPM is greater than transmission input RPM, which is realized as slight decrease in fuel efficiency.
When acceleration is complete and a constant speed is being maintained, the engine power output is reduced to the point where the TCC can engage and eliminate any slippage between the engine and transmission. If the car has a tachometer the engagement of the TCC can be verified when a slight reduction in engine RPM observed without a corresponding change in vehicle speed.
One method used to test the operation of the TCC is as follows:
Find a flat section of road where it is safe to perform the test.
Reach a steady speed and keep the gas pedal depressed with one foot. While observing the tachometer (or listening for an increase in engine RPM), with the other foot depress the brake pedal enough to activate the break light switch but not enough to engage the brakes. When the brake light switch activates, the TCC receives a signal to disengage. With the gas pedal being held steady, release the brake pedal and the engine RPM should decrease when the TCC engages.
Old cars with Automatic Transmissions did not use a TCC. I believe the TCC was put in use in an attempt to increase fuel economy.

MY EXPERIENCE WITH SIMILAR SYMPTOMS
The condition that causes that issue on my car is this:
- A slight uphill grade increases the load on the engine.
The car tends to gradually slow and it is necessary to depress the gas pedal to maintain speed.
- Depressing the throttle pedal (manually, or automatically with cruise control engaged) signals the torque converter clutch to unlock when the load increases slightly. (A more drastic load increase would signal the Transmission to downshift to a lower gear.) The corresponding increase in engine RPM and output is enough to compensate for the reduction in speed. When the vehicle speed, engine RPM, and throttle position stabilize to the point that the TCC will engage and the engine RPM will reduce in correspondence with TCC engagement. Now, if the road conditions have not changed, power output is not enough to maintain vehicle speed. With the increased load caused by full engagement between engine and transmission, and the cycle (surging) repeats itself until the road conditions change.

Does that help?
If not:

QUESTIONS
Please define the symptoms.
What are the road conditions when the surge occurs? (A slight uphill grade?)
What is the frequency of the surge?
Does the engine power output have a noticeable surge?
Is there a speed change related to the surge?
Does the tachometer move up and down with little or no change in vehicle speed?
Are all instrument indication in the normal range?
What else has changed?

Good luck!

May 24, 2014 | Subaru Impreza WRX STi Cars & Trucks

3 Answers

I dont know when and when not to use the overdrive on a 2000 grandmarquis


Overdrive is engaged for highway driving. Afterwards, it automatically disengages whenever brakes are applied. Overdrive cannot be engaged before a certain speed threshold is reached, peventing its use during city driving.

Apr 30, 2014 | Cars & Trucks

1 Answer

Over drive


if you have an OD switch, then when the light is off the OD is dis-engaged, also at hiway speed if you turn off the OD u will feel the car slow and engine speed/RPM increase about 800-1000 RPM

Feb 05, 2009 | 2002 Mazda Tribute

1 Answer

Rpm overspeed


have the transmission checked out,

quote http://www.aa1car.com/library/2002/bf90222.htm

One of the most common complaints with automatics is fluid leaks. Fluid can leak out of the driveshaft seals, the input shaft seal, the transmission pan gasket, the torque converter or the ATF cooler and line connections. If the fluid level gets low, the transmission may be slow to engage when it is shifted into drive. Gear shifts may be sloppy or delayed, or the transmission may slip between shifts

Oct 23, 2008 | 2000 Ford Expedition

Not finding what you are looking for?
2003 Ford Expedition Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

79123 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5677 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...