Question about 1999 Dodge Durango

1 Answer

BATTERY POSITIVE POST IS GET HOT AND TRUCK WILL NOT START

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 66 Answers

Most likely if the positive post is hot the battery dosent meet the CCA (cold cranking amps) required for the durango to start. Check your owners manual but using a battery that is too small (or not enough cca) will cause the positive post to heat up to the point that it will eventually melt off

Posted on Dec 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I try and start my truck positive cable get hot battery go's dead?


Replace the starter. It has a short in it. Causing the cable to get hot. Also check for good grounds.

Jan 31, 2015 | Cars & Trucks

1 Answer

Just replaced the transmission in the truck and everything will come on inside the truck but when you try to start the engine everything goes out.


Clean and retighten battery post connections, Check the negative grounding point-where the negative cable grounds to frame. And check the positive cable connection on the battery. Sounds like a loose connection somewhere.

Aug 16, 2014 | Cars & Trucks

1 Answer

Positive battery cable grounding at distribution box


Chevy trucks had a bad habit of shorting out near the starter. It shorts out because of the hot manifold melting the insulation. I moved my wire away from the starter and placed it on the battery positive post using a small extension. You might also have a bad pickup getting ready to go so be ready.

Nov 24, 2013 | 1999 Chevrolet Silverado 1500

2 Answers

Truck will not start how can i tell if its a starter or selonoid


does it spin real fast without clanging and grinding against the flywheel? if so then its probably the solenoid bad. do you have to hit the starter with a hammer then it works? it is probably bad brushes or a worn motor. eather way i think you can only get a new starter and solenoid together not sold seperate. check for bad battery cables (loose).

May 30, 2011 | 1996 Chevrolet K1500

1 Answer

Car won't start how do I jump start it?


Take jumper cables put the black cable to the negative post on the battery and the red cable to the positive post on the battery.Do the same to both cars Black to ground (-)and red to hot.(+)

Apr 22, 2011 | 2000 Dodge Intrepid

1 Answer

Replaced fender silenoid and ignition switch under dash. Even after unhooking all terminals from starter, the positive cable from battery is bubbling hot. There is a faint clicking coming from under...


Tough one. First thing I would do is replace your cables, signal wire from ignition switch to solenoid included. Sounds like a short somewhere.

Dec 24, 2010 | 1991 Ford F350

2 Answers

1984 D150 truck 318 2brl carb won't turn over...no lights, no hor


I would check your fusible links. The wires that they are on are what power everything in your cab. Usually they're attached to the starter, the starter solenoid, or the positive battery terminal. Hope this helps!

Jan 18, 2010 | 1984 Dodge D150

1 Answer

Truck wouldn't start. Starter was bad; replaced


run a positive jumper cable from the + battery post to the starter post if it turns over replace battery cable. also check ground cable

Jan 15, 2010 | 1991 Chevrolet Silverado 2500

3 Answers

I change my battery post now I don't know where they go on the - or + side can you help me out


Hello. Yes. the black wire is the ground wire. It goes from the frame to the negative post of the battery. The red wire is the hot wire and it goes to the positive post.

Nov 24, 2009 | 1994 Buick LeSabre

1 Answer

Truck back feeds power to positive terminal


Remove the terminal and clean with wirebrush until both the clamp and battery post are shiny.Re-install.The heating problem should be eliminated.

Mar 14, 2009 | 1991 Chevrolet C1500

Not finding what you are looking for?
1999 Dodge Durango Logo

Related Topics:

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...