Question about Cars & Trucks

2 Answers

IT IS 40 BELOW AND THE LOCK IS FROZEN SO THE KEYLESS ENTRY DOESNT WORK NEITHER DOES THE KEY, WHAT CAN I PUT ON THE DEADBOLT TO PREVENT IT FROM FREEZING EITHER OPEN OR CLOSED.

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 170 Answers

Wd-40 or a spray silicone

Posted on Jan 04, 2010

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 57 Answers

TRY ANTI FREEZE> AUTOMOTIVE ANTI FREEZE this works on padlocks also REAPPLY AS NEEDED

Posted on Dec 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2001 Chevrolet Impala Keyless Entry


Common problem, a small switch in the door lock breaks and does not activate the lock, all works from the key not remote, driver door recognises door not locked will unlock all doors, to repair you have to replace drivers door lock or just live with the key, I do
Merry Christmas

Dec 15, 2013 | 2001 Chevrolet Impala

2 Answers

How do I get my key remote to lock/unlock my toyota rav4 2002 model? I changed the battery because I thought that was the problem but it is still not working. The red light on the remote comes on but then...


You will need to try reprogramming the remote 1st, below is the complete procedure. If the reprogram doesn't restore function then you will need the dealer to test the keyless entry system, you may have a bad module or remote (only applies if both remotes don't work).

Start with the key out of the ignition, drivers door is open all others closed and
drivers door is unlocked.

2. Perform these steps within 5 seconds.
A. Insert the key into the ignition(Do NOT Turn) Pull key out.
B. Insert the key into the ignition(Do NOT Turn) Pull key out.

3. Perform these steps within 40 seconds.
A. Close then open the drivers door.
B. Close then open the drivers door.
C. Insert the key into the ignition(Do NOT Turn) Pull key out.

4. Perform these steps within 40 seconds.
A. Close then open the drivers door.
B. Close then open the drivers door.
C. Close the drivers door
D. Insert the key into ignition and leave it in ignition.
E. Turn the ignition to ON (Do NOT Start) then back to OFF.
F. Remove the key from the ignition.

5. Within 3 seconds, the power door locks should lock then unlock automatically
indicating successful entry into programming mode.
Return to step 1 if the locks do not cycle at this point.

6. Perform these steps within 40 seconds.
A. Press the lock and unlock buttons on the remote simultaneously for 1.5 seconds.
B. Immediately after letting go of the lock and unlock buttons,
Press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door
locks should lock and then unlock once indicating successful programming. If
the door locks cycle twice, repeat steps A and B in step 6 as the remote was
not accepted.
C. Repeat steps A and B in step 6 for each new remote.

7. Open drivers door.

Aug 24, 2011 | 2002 Toyota RAV4

1 Answer

I have a 96 ford conversion van with a 600 plus addon keyless system and need to program new keyless remots , need to know how to get system in program mode.


Hi.

To program ( or reprogram ) a keyless entry remote transmitter into the remote keyless entry module, perform the following steps:

1. Turn the key to ON or ACC and short the two terminals of the program connector, a two-pin connector located below the driver's side of the instrument panel at the base of the steering column. All doors should lock and then unlock.
2. Press any button on each keyless entry remote transmitter in turn. All doors should lock and then unlock. If the door locks do not respond, press the button again (up to three times maximum with the same keyless entry remote transmitter). If the door locks still fail to respond, go to Pinpoint Test A.
3. Repeat Step 2 to program additional keyless entry remote transmitters into the remote keyless entry module (up to four keyless entry remote transmitters maximum).
4. Turn key off.
5. Remove the short from the program connector. All doors should lock and then unlock.
6. Verify that the keyless entry remote transmitters have been successfully programmed by pressing the LOCK or UNLOCK button on each one, and observing that the system responds by locking and/or unlocking the doors.


I hope this helps you.

Thanks!

Nov 28, 2010 | 1996 Ford Econoline

1 Answer

What would you do when your 1996 lincoln town car doors won't lock with the key. And the trunk won't open.


How can a lock not lock or unlock with a physical key? Maybe the cylinders are frozen? Try squirting a little oil into the locks.
1996 Town Cars have keys and keyless entry. The physical keys are two, an ignition key and a door key. You can't use the door key in the ignition, nor the ignition key in the door. They aren't interchangeable.
The default key code for keyless entry is posted on the right trunk hinge, inside the trunk.

Jul 19, 2010 | 1996 Lincoln Town Car

1 Answer

My key will not unlock my door to 07 impala and keyless entry remote will not work.I have a car door lock ouy tool,but not sure to push or pull


if you have a slim jim (flat meatal with a hook) you are not getting in. the remote wont work because the battery is dead and the key doesnt work because you never use it (am i right?). Well this is what you can do short of calling a lock smith oir triple A. take WD-40 and spray it in the lock hole put the key in the door and work back and foward untilll it opens this could take a long time about 15 patient minutes (**TIP** put a pair of vise grips on the key this will give you a handle to use because your fingers will get tired quick.)

Jan 06, 2010 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

2008 altima When I place my key in the ignition(keyless entry) a warning shows "no key". I have changed the battery and it still says "no key" please give me an estimate of what you think it is and if it...


Lock your car with the keyless entry.Push it twice.Then walk over to passenger side and un lock with key.Then put key in ignition and start the car..If that dont work lock the doors again with the keyless entry.Push lock twice and then push the unlock twice..that should start your car,Repost if you have no luck to consider different stratigies.

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589

Apr 03, 2009 | 2005 Nissan Altima

1 Answer

Door lock problem


Most probably the lock actuator is frozen in down position. it could be your lock cylinder, but the actuator is the most common problem. You have to remove the inner trim panel to access it.

Dec 27, 2008 | 1997 Dodge Ram

3 Answers

Keyless entry


I believe dealer has to re-program the new code.

Aug 29, 2008 | 2001 Ford Explorer Sport Trac

6 Answers

Keyless entry stopped working on 05 cobalt now i have to unlock door with the key and when i do that the alarm goes off. Help


Lock all the doors from the inside (with all the doors closed), unlock your driver's door by manually lifting the lock, then press it back down after you are out - this will prevent the alarm from sounding when you use the key to unlock the door.

Aug 02, 2008 | 2007 Chevrolet Cobalt Coupe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15148 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...