Question about 2004 Chevrolet Impala

Open Question

2006 CHEVY IMPALA DUAL HEATER NOT WORKING ON DRIVER SIDE

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

SOURCE: 2004 chevy silverado 1500 a/c heater

when my truck is at an idle, it won't put out any heat in the cab, same thing in the summer with the A/C, what's the fix for it ?

Posted on Mar 11, 2009

Ad
emissionwiz
  • 80407 Answers

SOURCE: How do I program my key for my 2006 Chevy Impala?

Add Duplicate Key (PK3 or PK3+ key)
1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.
Originate New Master Key (PK3 or PK3+ key)

1. Insert new key into ignition cylinder and turn it to the ON (RUN) position.
The security light on the dash will illuminate and stay on for ten minutes.
2. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back to the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
3. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back on the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
4. After the security light has gone off the third time, the key has been programmed
into the vehicle’s computer and will operate the car. It has replaced ALL the
previous electronic key codes and is the ONLY key programmed into the
vehicle’s computer.

Add Duplicate Key (PK3 or PK3+ key)

1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.

Posted on May 20, 2009

  • 400 Answers

SOURCE: 2004 impala a/c blower not working

No it can not.
You have a couple of actuators that have gone out. The driver temp control. And the air inlet actuator.
And I don't fallow your statment of "my a/c blower went completely out. I tested the blower and it works fine".

If the blower went out, then what do you mean it works fine? Are you talking about air delivery or it just quits blowing all together?

Posted on Jul 01, 2009

  • 54 Answers

SOURCE: 2004 chevy tahoe, dual climate control, blowing different temps

Its more then likely the temp door broken or temp door motor broken/stuck. There is 2-3 of these motors under the dash on the side of the evap/heater core box. Some require extensive labor to replace, good luck

Posted on Jul 29, 2009

  • 491 Answers

SOURCE: 2005 Chevy Impala driver's side heat blows cold.

First....buy a drivers side air flow actuator at a auto parts place for dual zone heating/cooling.
(NAPA etc will have it.....or the dealer)
Open the glove compartment.....all the way....you may have to take the screws out at the bottom......look in at the heater assembly....look over to the left....you will see the two air flow actuators.
Look at the part you have and match it to the part on the heater assembly.
The actuator that is closest to the engine is the drivers side control.
Replace it.
Try your controls and check for heat and cooling on both sides.
The stepper motor in these actuators goes bad on quite a few...but over look that.....you have a great car,good for many miles of trouble free driving.


Posted on Nov 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2006 chevy impala and the driver's side sun visor won't stay up


cheap fix put alittle tape around the visor where it clips in to electric tape works well

Mar 02, 2011 | 2006 Chevrolet Impala

1 Answer

My 2004 chevy impalas heater only works on the passenger side and not the drivers side. whats wrong and where can i buy the parts for that problem. thank you


You can start by checking to see if there are any blown fuses: There is a fuse panel on the drivers side end of dash.Open cover and check AC/Cruise and DR LK and LH HTD

Feb 13, 2011 | 2004 Chevrolet Impala

2 Answers

2006 impala heater motor blows like normal but some mornings it blows cold if we shut it off and turn it on a couple of times it will blow hot and work fine. the heat gauge is at half way when the engine...


this problem is caused by a sticking air temperature control blend door actuator or blend door, this door moves back and forth to get the desired temp, the actuator is electronic and prone to this type of problem, suggest u replace it.

Sep 23, 2010 | 2006 Chevrolet Impala

1 Answer

2006 Chevy Impala driver side visor will not stay up. What do I do???? Help.


You are not alone! I have the same thing with my '06 Impala. I may have to replace it since there is not a visible mechanism for adjusting the tension.

Sep 18, 2010 | 2006 Chevrolet Impala

1 Answer

My 2005 chevy impala blows heat on the passenger side and cold air on the drivers side. Please help! I have tried disconnecting the power fuse for ten minutes to recalibrate and nothing.


I have the same issue with my 2005 chevrolet impala. I took it to the shop and its the dual module control out on the driver side which will cost anywhere from $300.00 to $500.00 to get fixed.

Nov 13, 2009 | 2005 Chevrolet Impala

1 Answer

Installing door mirror,right side,2006 chevy impala,no heater


yes yo do should be 2 bolts in the arm rest too remove then the rest of the panel just clips on!!!

Nov 12, 2009 | 2006 Chevrolet Impala

1 Answer

2005 Chevy Impala driver's side heat blows cold, but works on passenger side. Was told a vent is probably not opening to allow for the heat to get to the driver's side? Where can I locate this vent?


First....buy a drivers side air flow actuator at a auto parts place for dual zone heating/cooling.
(NAPA etc will have it.....or the dealer)
Open the glove compartment.....all the way....you may have to take the screws out at the bottom......look in at the heater assembly....look over to the left....you will see the two air flow actuators.
Look at the part you have and match it to the part on the heater assembly.
The actuator that is closest to the engine is the drivers side control.
Replace it.
Try your controls and check for heat and cooling on both sides.
The stepper motor in these actuators goes bad on quite a few...but over look that.....you have a great car,good for many miles of trouble free driving.


Nov 03, 2009 | 2005 Chevrolet Impala

1 Answer

The heater is only working on the passenger side in my 2005 impala. the driver side is blowing cold air. please help


Do you have dual zone heat and cooling controls?
If so......the drivers side air flow control unit on the heater assembly is not working.
It is mounted on the heater assembly and can usually be accessed through the glove compartment to change it.
The stepper motor on these units fails often.
This should be the problem on your car 99%...if you have a separate heat/cooling control for driver and passenger areas.

Oct 29, 2009 | 2004 Chevrolet Impala

1 Answer

Will not blow hot on drivers side


There is a temp door actuator motor gone out.It is not to easy to get to ,so a mechanic would be advisable.

Oct 18, 2009 | 2004 Chevrolet Impala

2 Answers

2000 impala cold passager and warm air driver side


there is an actuator for the drivers side heater that opens the temp door. this motor actuator needs changing. so it is stuck in heat mode and now motor will not move door to cold.

Jul 03, 2009 | 2003 Chevrolet Impala

Not finding what you are looking for?
2004 Chevrolet Impala Logo

Related Topics:

223 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...