Question about 1999 Ford Explorer

2 Answers

I need to check to see if the fuse is blown for my fuel pump but do not have an owners manual to know which one it is. I have a 1999 Ford explorer sport 4.0 L.

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 55 Answers

Usually if the fuse is gone too much amps had been sucked by the pump itself .The fuse shall be inside your fuse compartment where the other fuses are .
Buy a cheap ohmmeter and check all the fuses for continuity .Set the dial of the meter to ohms.Take all the fuses and put the leads so they connect one to one side of the fuse and another lead to the other side of the fuse .
If the reading is towards 0 the fuse is good . If other reading or 1 or infinity the fuse is blown . Replacing the fuse is easy as in the automotive store they sell them by models sometimes they sell them in a bunch. If the fuse keeps being blown after replacing it then the fuel pump may be your problem or you may have a short circuit in the cables going to the pump ..
the pump may need to be changed .
The pump is inside the fuel tank .
You may need to replace it more likely.You need to drop the tank -carefully it is heavy and open the top cover which screws on and your pump shall be right there unscrew it undo the electrical connections and you got it .to replace do the reverse operation .

Posted on Dec 11, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 253 Answers

Fuse box under dash 20 amp fuse.

Posted on Dec 11, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I dont know which fuse controls my fuel pump on my 1999 ford crown vic


On fuse pannel it should say fuel pump. It should be near battery or inside car. Read owners manual for more detail.

Jun 10, 2011 | 1999 Ford Crown Victoria

1 Answer

DASH LIGHTS DO NOT WORK AND THE DOME LIGHT STAYS ON


Do you have an owners manual? I had a similar problem with a Ford, turned out that the dome stayed on until the bad fuse was replaced. Sort of a "safety" feature you know that you have fuse blown in some other area. Owners manual should show location of fuse.

Hope this helps

Mar 07, 2011 | 1999 Ford Explorer

1 Answer

1999 ford explorer just died not getting gas is it possible to hear the fuel pump run? I cant hear the one on my ranger and it works fine. Could it possibly be the fuel filter? or is it most likely the...


How many miles do you have on it? The fuel pump is in the gas tank, I have a 97 explorer and around 75k miles the fuel pump went out. After talking with other Ford truck owners this was pretty common. Its not a cheap repair unless you are willing to drop the tank yourself.

Feb 12, 2011 | 1999 Ford Explorer

1 Answer

1999 Ford f150 V8 4.6 Fuel pump does not run up. Where is the relay and or fuse? How do I check the pump?


Did you check the fuel inertia switch ?

From the owners manual pg 155 :
Engine compartment :
Fuse # 10 - Fuel Pump
Fuse # 18 - Fuel injectors

pg 156
Fuel pump relay relay #302
You can swap the fuel pump relay with one of the trailer tow adapter relays to test with.

You can always jumper the normally open contacts in the relay socket ( shown as the red line below ) :
a3fcf2f.jpg

Oct 01, 2010 | 1999 Ford F150 Regular Cab

1 Answer

2000 ford explorer wiper fluid pump does not work,


the fuse is located in the inside fuse panel position 12. it is a 7.5 amp fuse and is brown in color. if you cant find the position #12 then check all 7.5 fuses.if no fuse is blown then open the hood and get someone toactivate the washer pump while you lisen for it to run.the pump is located in the bottom of the washer fluid resavor and is usually replaced with the resavor as a assembley.if no blown fuse and u cant hear the pump running then you will need a new pump.if u hear pump running but no fluid is coming out look for a leak in the lines.

Jan 13, 2009 | 2000 Ford Explorer

3 Answers

Diagram for fuse panel


this link you give you a PDF owners manual what you seek is fuse 9 and relay position #5 in the underhood power distribution box.

http://www.motorcraftservice.com/pubs/content/~WOXEXP/~MUS~LEN/42/99expog1e.pdf

Nov 06, 2008 | 1999 Ford Explorer

Not finding what you are looking for?
1999 Ford Explorer Logo

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

83083 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

gerry bissi

Level 3 Expert

4387 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...