Question about 1993 Dodge Dakota

1 Answer

Need to replace heat resistor. where is this located

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 19 Answers

Blower Motor Resistor Notes need to replace heat resistor. where is this - 97239958Hope this helps

Posted on Dec 11, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

How do I change heater fan


It would help to know the make and model. Different manufacturers put them in different places and mount them different.

Feb 19, 2015 | Cars & Trucks

1 Answer

Locate heat resistor for 1999 chevy lumina


if it has resistors they will be in the heater box next to the blower motor. The air flow is used to keep the resistors cool as they can overheat and burn out.

Feb 10, 2015 | 1999 Chevrolet Lumina

1 Answer

Heater not blowing


Check your blower motor resistor for a bad connection or melted pigtail.It is located on the passenger side motor in the heat duct there is usally 2 screws that hold it against the heat duct.These resistors get pretty hot and melt the pigtail causing it to lose its connection.Perform the wiggle test on it with the ignition and fan switches on.You may need to replace the pigtail or the resistor or both.

Jan 15, 2012 | 1995 GMC Suburban

2 Answers

No heat


your blower motor resistor needs to be replaced if you only have one speed its a small inexpensive part runs about 15 dollars easy to replace.

Jan 17, 2010 | 2000 Oldsmobile Silhouette

1 Answer

2005 malibu - heat/ac has 4 levels for fsn, level


Your blower speed resistor has gone bad and needs to be replaced. You can pick one up at Auto Zone or Parts Source with the step by step instructions to getting the resistor replaced with common tools.

It is located under the glove box, way in the back of the passenger foot area. You'll need to remove 2 screws with a 7mm socket, and remove the plastic cover that covers the blower motor and another component box that I think controls the passenger airbag. After removing the plastic cover you'll need to side that passenger airbag module to the right so it pop off its mounting bracket and move it out of the way. That will give a better view of the blower motor. I highly recommend you also remove the blower motor itself because the Blower Motor Resistor is located behind it. I think you'll need a 5mm or 5.5mm socket to remove the 3 screws that hold in place the blower motor and 2 more screws for the Blower Motor Resistor... It's a cramped location to work in but if you have all the tools and enough lighting then it shouldn't take more than 30-60 minutes to do. The Blower Motor Resistor costs about $19-$25. Good luck

Nov 30, 2009 | 2005 Chevrolet Malibu

2 Answers

No heat


Have you checked the relay for the system. Should be in the under hood fuse block.

Oct 07, 2009 | 2004 Dodge Dakota

1 Answer

2000 silverado a/c only works on high fan speed. Blows ice cold. But lowering fan speed, or adding heat to adjust temperature causes compressor to cut out.


Hi! The blower resistor is the culprit here,located on passenger side of vehicle under glove box area. I have replaced several of these for the same problem. You also need to check the connector for the resistor for heat damage to terminals and replace as needed. The harness will come with wiring attatched and heat shrink **** splice sleeves. hope you find this information useful!

Sep 13, 2009 | 2000 Chevrolet Silverado

1 Answer

2003 yukon denali---relay locate for blower


the relay is built into the speed resistor or motor control module ) depends if you have automative or manual heater controls. is automatic it will be motor control module and manual is the resistor module. these units are located beside the heate fan motor. the motor helps keeps the unit cool. just unbolt the module, unplug it and install new one. Just check to make sure the connector is good.. The heat created by the connection sometimes melts the power or ground leads (red or black) and if this is so you will need to replace the pin.

Sep 01, 2009 | 2003 GMC Yukon Denali

1 Answer

Location of the Heat resistor in a 2003 Chevy Malibu?


Under the glove box, behind the blower motor itself. Remove the shroud below glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the purple/black power connector to it - - you'll need this extra room to work with. 2 more screws, same size, 6.5mm on mine, 7or 8mm on some others, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage - up to $400, what a sham.

Feb 24, 2009 | 2003 Chevrolet Malibu

1 Answer

I have a 2003 jeep liberty and the heat only blows on speed 2 and 4 would i need to replace the whole blower motor or just the resistor and if it is just the resistor,is it located in the glove box?


spray it with electric spray contac cleaner right in where the switch is work the switch after you spray it.check resistor for low amps if high replace it.

Feb 21, 2009 | 2006 Jeep Wrangler

Not finding what you are looking for?

Open Questions:

See all 1993 Dodge Dakota Questions

1993 Dodge Dakota Logo

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

83489 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22393 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...