Question about 1997 GMC Jimmy

1 Answer

Need a rough estimate on how much it will cost to have a cv boot repaired on an 1997 GMC Jimmy 4x4.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • GMC Master
  • 3,854 Answers

A transmission shop would cast about 1 hour labor plus the parts. Labor cost is around $75.00 an hour here, and the Reman CV joint with the core exchange is around $80.00 and without the core exchange $160.00. Hope this helps.So best i can give you an average $225.00 but call around a reputable transmission shop, since they work on this type of repair all the time. Good luck.

Posted on Dec 11, 2009

Testimonial: "thanks for your help "


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to repair not working rear lights 1997 gmc jimmy

brake lights not working - 1997 GMC Jimmy - RepairPal > Questions > GMC > Jimmy > 1997 GMC Jimmy
Jan 11, 2011 - hi about 2 days ago i realized my brake lights were not working but my turn signal lights were working and parking lights as well but no brake ...

Tail Lights don't work but third brake light does, not fuses ... > Edmunds Answers
Sep 23, 2009 - 97 GMC Jimmy 4x4 blinkers work, reverse lights work, above window ... I just lost hazard lights and rear brake lights, they were working 2 days ... If it is a frayed wire or solder point, then you can repair it, but not any worn contacts. ... Does anyone have any suggestions on 1997 Honda Accord tail & brake lig.

Nov 19, 2015 | GMC Cars & Trucks

1 Answer

Where is the evap purge solenoid sensor on a 1997 jimmy

where is the evap sensor on a 1997 gmc jimmy 4x4 6 cylinder

Jul 25, 2012 | 1997 GMC Jimmy

1 Answer

I have a 1997 gmc jimmy and when she off i am losing coolant out drive side of the radiator do i need to repast the hole radiator

if you take the radiator to a radiator repairer they may be able to repair it for less than the cost of a new one, if it can't be repaired they may nave a reconditioned one......hope this helps.....cheers.

Jul 19, 2011 | 1997 GMC Jimmy

1 Answer

Where does one find a CV boot that is split to provide for easy replacement on a GMC 4x4? Or how does one replace with a standard boot, does the CV Joint seperate from the axle part?

there used to be a split boot but what was the point?? you have to remove the joint to clean the old grease out anyhow, and yes the joint does come off the shaft, remove the entire unit and do it on the bench, put the shaft in a vise and knock the joint off with a soft headed hammer clean it repack it and install the boot with new grease, good luck

Sep 17, 2010 | 1992 GMC Jimmy

2 Answers

Rough idle and alot of carbon out exhaust pipe, 1993 gmc jimmy

You need new egr valve gasket with a screen on it. It will block carbon from clogging it causing rough idle. Need 10mm wrech and socket set. I found the part at napa for around 22 bucks. I have had my 93 4x4 Jimmy for 10 yrs it now has 235000 on it and still going.

Dec 30, 2009 | 1993 GMC Jimmy

1 Answer

Cv boots need repair work grease pack.

from the symptoms you now describe re clicking ? after 2 yrs driving your cv joints now req renewing as due to lack of lubrication will have caused serious wear/damage to the ball bearings and carriers may i advise you have them replaced A S A P as one or both could lock up and result in an accident with untold consequences? cv joints in uk cost approx £60 plus fitting per side not a difficult job even possible d i y ? if you feel inclined?

Feb 23, 2009 | 2002 Hyundai Santa Fe

1 Answer

Severeal cylinders misfire

Sounds like the TPS (throttle position sensor) usually located where the throttle body meets the intake manifold. It may need re-calibrating or renewing.

Feb 06, 2009 | 1991 GMC S-15 Jimmy

Not finding what you are looking for?
1997 GMC Jimmy Logo

204 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

83083 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides