Question about 2006 Lincoln Zephyr

1 Answer

I oun a lincoln zephyr 06 the blower motor does not run i checked the motor by removing it and connected to the battery. i also ckecked the wires to the motor i have 12 v going into the motor but it does not run.I also checked all fuses and relay.

Posted by on

  • adtphil Dec 12, 2009

    replaced blower motor still don't work

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 398 Answers

If you have12v going into the blower motor and it still does not run. the blower motor is bad

Posted on Dec 11, 2009

  • Roosevelt James Dec 13, 2009

    you must make sure u have a good ground.connect it direct to 12v andit wil work. also need you to check blower relay

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vacuum Issue on 2006 Lincoln Zephyr


Problem Description and Possible Solution
A vacuum leak from the PCV grommet. A vacuum leak can cause the Check Engine Light to illuminate. The molded rubber hose connections may crack and collapse, causing the vehicle to run roughly. A damaged PCV hose will require replacement.

Problem Data
Average mileage: 137,860 (98,300–203,000)
17 model years affected: 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007

Jan 21, 2018 | Lincoln Cars & Trucks

1 Answer

Heater fan will not run on 2006 lincoln zeypher


lincoln zeyphr so ford have recycled the name again ,used to be a brit car called the zeyphr ,nice car in its time anyway heater motor not working well this is easy to check out but i have no idea on the product layout as little old me is a europeon mechanic but what you do is look up under the passenger side dash and remove any cover then you will see the blower motor .Now find the deed wires and check for voltage with ignition and switch turned on ,if no power then start looking for a fuse wherever they are if power then is it a motor with a built in resistor for the different speeds if so look again and their will be a twin wire connection into the actual motor ,now hot wire this with a bit of twin flex motor will work either polarity if it works then work backwards like power to the switch or no power to switch the a fuse if not is power going to the coresponding fuse .Its all a process of elimination to fault find the problem

Nov 03, 2011 | 2006 Lincoln Zephyr

2 Answers

My driver's side headlight is out on my 06 lincoln zephyr I bought a new HID light and had it installed but it still wont work. I think it may just be the fuse. But how do I get to the fuse box to...


if one side works, its not going to be a fuse, whoever installed it needs to recheck it if that is possible,, On those bulbs its very important not to touch the actual bulb, as the oil in the body will cause them to over heat and burn out faster . If you can't have the installer check the bulb again,, remove the retaining ring that holds them in place,, remove the bulb , and check it with a meter , check any wiring that leads to the socket to be sure its plugged in completely

Aug 31, 2011 | 2006 Lincoln Zephyr

1 Answer

How does the blower motor come out/


  • Disconnect the negative battery cable.
  • Disconnect the blower motor lead connector from the wiring harness connector.
  • Remove the blower motor cooling tube from the blower motor.
  • Remove the four retaining screws.
  • Turn the motor and the wheel assembly slightly to the right so that the bottom edge of the mounting plate follows the contour of the wheel well splash panel.
  • Lift up on the blower and remove it from the blower housing.
  • Installation the new blower motor by reversing the removal steps.
  • Connect the negative battery cable.
  • Dec 18, 2010 | 2001 Lincoln Town Car

    1 Answer

    Need to replace heater blower motor. How do I get to it?


    Behind the glove box. Please see my tip at http://www.fixya.com/cars/r6234839-doesn_t_heater_or_air_conditioner_blow . These are generic instructions. If you get stuck, please get back to me.

    See instructions from autozone.com below.


    REMOVAL & INSTALLATION


    With Air Conditioning
    See Figures 1, 2 and 3

    1. Disconnect the negative battery cable.
    2. Remove the glove compartment door and glove compartment.
    3. Disconnect the blower motor wires from the blower motor resistor.

    jturcotte_62.gif
    Fig. Fig. 1: Disconnect the blower motor wires from the blower motor resistor-1988 Escort
    1. Loosen the instrument panel at the lower right-hand side prior to removing the motor through the glove compartment opening.
    2. Remove the blower motor and mounting plate from the evaporator case.
    3. Rotate the motor until the mounting plate flat clears the edge of the glove compartment opening and remove the motor.
    4. Remove the hub clamp spring from the blower wheel hub. Then remove the blower wheel from the motor shaft.
    jturcotte_63.gif
    Fig. Fig. 2: Unbolt the mounting plate from the case


    jturcotte_64.gif

    Fig. Fig. 3: The motor can now be removed from the case


    To install:

    1. If removed, assemble the blower wheel to the motor shaft and install the hub clamp.
    2. Install the motor and blower wheel assembly.
    3. Secure the instrument panel at the lower right-hand side.
    4. Connect the blower motor wires at the blower motor resistor.
    5. Install the glove compartment door and the glove compartment.
    6. Connect the negative battery cable.
    7. Check the system for proper operation.

    Without Air Conditioning

    1. Disconnect the negative battery cable.
    2. Remove the air inlet duct assembly.
    3. Remove the hub clamp spring from the blower wheel hub. Pull the blower wheel from the blower motor shaft.
    4. Remove the blower motor flange attaching screws located inside the blower housing.
    5. Pull the blower motor out from the blower housing (heater case) and disconnect the blower motor wires from the motor.

    To install:

    1. Connect the wires to the blower motor and position the motor in the blower housing.
    2. Install the blower motor attaching screws.
    3. Position the blower wheel on the motor shaft and install the hub clamp spring.
    4. Install the air inlet duct assembly and the right ventilator assembly.
    5. Connect negative battery cable.
    6. Check the system for proper operation.

    Nov 05, 2010 | 1989 Ford Escort

    1 Answer

    My 1988 Ford Tempo's heater fan is not working. I can feel heat at the windshield vents,but the fan wont come on. I have jumped the fan speed switch with a paper clip--and blew a fuse--and checked the...


    your circuit is simple--I will paste it below. suspect the blower has shorted and caused the switch to burn up. remove the blower and hotwire it to the battery to see if it works. If not, replace the blower. Then run continuity tests on the swoitch and replace switch if bad. If you have questions, please let me know. Here is procedure for taking blower out:


    REMOVAL & INSTALLATION With Air Conditioning

    1. Disconnect the negative battery cable.
    2. Remove the glove compartment door and glove compartment by removing the retaining screws and bolts. Push the sides of the glove box in to free the drawer from dash panel.
    3. Loosen the instrument panel at the lower right hand of the glove compartment opening. This is on it necessary if the panel is in the way of the motor housing.
    4. Remove the retaining screws securing the ducting around the blower motor.
    5. Remove the clip securing the blower motor fan blade to the motor arm. Remove the fan blade from the motor.
    6. Remove the blower motor mounting plate from the evaporator case by unscrewing the retaining screws.
    7. Rotate the motor until the mounting plate clears the edge of the glove compartment opening and remove the motor.
    8. Remove the wire harness from the rear of the motor.
    9. Inspect the fan blade for broken edges or cracks. Replace if needed.

    To install:
    1. Connect the wire harness to the rear of the blower motor.
    2. Install the motor into the case and secure with the retaining screws.
    3. Position and fasten the fan blade to the blower motor arm. Secure with the clip.
    4. Secure the blower motor outer housing to the duct assembly with the retaining screws.
    5. Install the instrument panel at the lower right hand side if removed earlier.
    6. Install the glove compartment door and glove compartment.
    7. Connect the negative battery cable.
    8. Run blower motors to make the motor works correctly.
    Without Air Conditioning
    1. Disconnect the negative battery cable.
    2. Remove the right ventilator assembly.
    3. Remove the hub clamp spring from the blower wheel hub. Pull the blower wheel from the blower motor shaft.
    4. Remove the blower motor flange attaching screws located inside the blower housing.
    5. Pull the blower motor out from the blower housing (heater case) and disconnect the blower motor wires from the motor.

    To install:
    1. Connect the wires to the blower motor and position the motor in the blower housing.
    2. Install the blower motor attaching screws.
    3. Position the blower wheel on the motor shaft and install the hub clamp spring.
    4. Install the air inlet duct assembly and the right ventilator assembly.
    5. Connect negative battery cab
    6. Check the system for proper operation.

    36d4b25.gif

    Oct 21, 2010 | 1988 Ford Tempo

    1 Answer

    A/c and Heater blower motor does not work at all with the controls in the dash. I have replaced with new blower motor and have also tested both the old and new motors. Both will blow when straight wired to...


    Hello, did you check the ground wiring for a bad contact?

    I don´t see any other reason why the motor would not run if it works connected directly to the battery and you have 12 Volts supply at the multiplug .

    Jun 25, 2010 | 2001 Lincoln Town Car

    1 Answer

    The ashtray door/cover will not stay closed in the dash 06 Zephyr


    I found that if you take the ash tray out there is a little hole. shine a light in it and you should be able to see a slide mechanism on it push it over to the side and the door will lock,might want to put a little lube in it and that worked for my 06 zephyr

    Apr 16, 2010 | 2006 Lincoln Zephyr

    1 Answer

    Blower not working


    check blower motor fuse and relay.if all is good.remove blower motor hot wire it and ground it using jumper wires to battery if blower motor run your ac + heater control switch is bad.if blower motor dont run when you hook it to battery.replace blower motor.

    Nov 22, 2009 | 2005 Chevrolet Aveo

    3 Answers

    Lincoln 2000 town car Blower doesn't work at HI-MED-LOW speeds...


    it is called blower motor resistor , should be close to blower motor , you will see a plug type connector with two screws , remove the screws and there should be a resistor inside the cover for the motor, swap with new and reassemble

    Feb 19, 2009 | 2000 Lincoln Town Car

    Not finding what you are looking for?
    2006 Lincoln Zephyr Logo

    Related Topics:

    171 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Lincoln Experts

    yadayada
    yadayada

    Level 3 Expert

    79865 Answers

    fordexpert

    Level 3 Expert

    5687 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22326 Answers

    Are you a Lincoln Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...