Question about 1996 Cadillac Seville CA Value

1 Answer

Drives fine and then won't start or stalls.

Drives fine for a while and then won't start or stalls. replaced fuel pump relay and thought that solved the problem. ran fine a couple of days and now back to a no start. no fuel pressure (using a gauge),nor can you hear the fuel pump when you turn on the key. when running correctly the car has proper fuel pressure.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 101 Answers

Remove the cover from around the fuse box under the hood on the drivers side then try moving the wires around from the main fuse box where it runs down from the box to the top of the transmission, have somebody try to start the car while you are doing this and see if it starts up there is a splice that likes to get hot and quit working in the pink or red wire that powers a portion of the fuse box including the fuel pump fuse. look for a brown spot in the wire, if you can make it start by moving these wires around cut the brown spot out and re-splice them together using a **** connector. seen it a thousand times....

Posted on Dec 11, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1992 Dodge Grand Caravan 3.3L stalled and wont start. No hum from fuel pump when key turned on, no fuel pressure at rail. I tryed starting fluid thru intake and no go. What could cause this?


is the fuel pump working now. sometimes the fuel relay can be the fault for no fuel. you need between 3-5 bar on fuel rail so just putting fuel in will not work. you will need a meter to check there is voltage getting to the pump the wires on pump remove them and connect to the meter and turn on ignition if volts then the pump is dead if there is no volts the relay is not working or the fuse has blown, , if fuse not blown then the relay is not working, or there is a damaged wire, even if the relay clicks it doesn't always mean its connecting.

Jan 29, 2017 | Dodge Cars & Trucks

1 Answer

My plymouth, voyager turns off while I'm driving it down the road..


Just an Idea. When it dies next time check the relay temperatures, if you can. Once I had a fan relay which would over heat and the radiator fan would not work. After relay cooled down it would work(This usually happened when I was stuck in traffic). Could be a fuel pump relay. If relay is a lot hotter than the other relay could be bad relay. My thought is it will not cost you anything to try it. I think it may be something electrical over heating. 30 years ago my thought would have been the coil, when the coil started going bad it would heat up and the car would die till it cooled off.

Nov 18, 2017 | Cars & Trucks

1 Answer

My car continues to stall while going down the road and after sitting a few minutes it will start again. I have replaced the fuel pump, fuel pump relay, fuel filter, plugs, plug wires, altenator, voltage...


OVP, MAF and have duty cycle set.

OVP's (Over Voltage Protection relay) are known issues in these cars.

Hop on over to benzworld.org to find out alot more.

Jul 29, 2010 | 1989 Mercedes-Benz 300-Class

1 Answer

?87 F-150 5.0 stalled and won?t restart. Electric


Is the fuel pump inside the fuel tank? If, so, you could try disconnecting the wire harness at the tank, and hot-wiring the fuel pump directly to a 12 volt source, in the correct polarity of course! If the pump runs, your problem may be a fuel pump relay, or a wire problem or connector problem. If the pump does NOT run, post that info. There may be a way around the problem!

Apr 20, 2017 | 1987 Ford F 150

1 Answer

Fuel Pump Making my car stall


its not the fuel pump. replace your main relay.

Jul 10, 2009 | 1993 Honda Civic 4 Door

2 Answers

2000 2.0 vw shutt down after running 20 min


Replace the fuel pump relay, it's easy and cheap.

Jun 08, 2009 | 2000 Volkswagen Jetta TDI

1 Answer

Stalling truck


Sounds like it could be a number of things Coil breaking down,ignition module breaking down or a failing relay.Could be ignition relay or fuel pump relay.The relay is the quickest,easiest and cheapest option to try first.

Oct 20, 2008 | 2002 Chevrolet Avalanche

Not finding what you are looking for?
1996 Cadillac Seville CA Value Logo

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...