Question about 2003 GMC Yukon Denali
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
check the gas pedal if it doesnt have a cable it tends to go out it is a drive by wire system g.m. vehicles have a common problem
Posted on Feb 12, 2010
i hav the same problem wit my 98 deville wat did u do to fix it and wat was the cheapest way. Also did u have anyother problems wit ur car during the time u were driving it wit these lights on
Posted on Dec 29, 2010
SOURCE: I'm getting Engine Power reduced
there having a lot of electrical issues with this vehicle.i would check the eng control module and the accelerator pedal sensor for corrosion in the connectors,if there corroded clean them with a soft brush and put dielectric grease on the connectors and modules.hope this helps.
Posted on Feb 06, 2011
Tips for a great answer:
Sep 06, 2014 | 2007 Ford Mondeo 2.0
Mar 04, 2017 | 2005 Pontiac Grand Prix GT
Feb 16, 2018 | 2010 Chevrolet Equinox
The Body Control module (BCM) detects that the traction control switch has been pressed (signal circuit is low). The Body Control module (BCM) sends a serial data message to the EBCM in order to disable traction control. The IPC receives a serial data message from the EBCM requesting illumination. The BCM sends a serial data message to the radio in order to activate an audible warning.
Your best bet is to take it to a ASE certified an qualified repair shop ,that has the diagnostic tool to fix this problem .
Jun 17, 2012 | 2007 Chevrolet Equinox LS New Cars
Jun 30, 2011 | 2000 Volkswagen Beetle
May 19, 2011 | 2002 Volkswagen Golf
Apr 05, 2011 | Audi A4 Cars & Trucks
Feb 07, 2011 | 2002 Volkswagen Passat
Feb 14, 2010 | 1997 Chevrolet Cavalier
1,007 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: