Question about 1996 Mazda 626

1 Answer

I need to get my dome light to work can you help me?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 398 Answers

Most of the the time the dome socket is burnt out and need to be replace. test for voltage at the socket on the hot wire.if no voltage check fuse and switch

Posted on Dec 10, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford taurus tss 2004 map lights work but dome light wont come on


It is possible the bulb in the dome light is burnt out or there is a bad connection @ the bulb. That is at least where you start. you will need to remove the dome light cover & wiggle the bulb while the door is open, or best to have two doors open to remove the possibility of a faulty switch. If it still doesn't flicker or start to work remove the bulb & inspect it to see if the filament is broken. If you can't tell best to replace the bulb & try again.
Please advise if you need more help.

May 29, 2014 | Cars & Trucks

1 Answer

2002 Lancer CE dome light fuse location


The dome light feed comes from the ETACS ECU. There are four fused inputs: 7.5A multipurpose fuse 2, 15A multipurpose fuse 14 and, in the enngine compartment relay box, 10A DEDICATED fuses 17 and 18. One of these four should apply to the dome light

Oct 13, 2012 | 2002 Mitsubishi Lancer

1 Answer

95 Camry interior lights don't work


The ecu-ig fuse is for the ignition from the Electronic Control Unit, or computer. The SRS fuse is for the Supplemental Restraint System, that is for the air bag system. The dome light is fused with a 7.5A fuse called "dome", which is up in the engine compartment junction block #2, on the inside of the left front wheel well. The "dome" fuse is in the lower left quadrant of the block.

May 11, 2010 | Cars & Trucks

2 Answers

I have a 2010 Acadia, the interior lights do not come on when I open the door. I have pushed the dome light button in and have left the button out still no lights when I open the door. Any suggestions?


Next to the round exterior light switch is a switch that controls the brightness of the interior dome lights. You can push (detent) that button in and it will pop out to make it easier to brighten/dim those lights. The tricky part is that the switch for making the dome lights illuminate when you enter/exit the vehicle is actually the top half of the backplate of the dome brightness switch. It says "dome off" on the upper portion of the backplate. That one inch area - that barely depresses - is actually the switch to make the dome lights work with the door operation. Try pressing it and then opening your door. It should work. Good Luck!

Jan 09, 2010 | 2008 GMC Acadia

7 Answers

Dome lights won't turn off


Been having a problem with the dome lights on a 99 chevy blazer. Still can't figure out what the problem is. There is a dome light overide button located under the dimmer wheel. When I push the overide button in the dome light goes off, but when I open any of the doors the dome light will not come on. When the overide button is out the dome light stays on all the time and will not turn off even though every door is closed. I checked all the pushbuttons and everything tests good. Has anyone had this problem and know how to fix it?

Sep 04, 2009 | 1997 Chevrolet Blazer

1 Answer

98 toyota corolla radio, dome light, and power locks don't work


2005 toyota corolla radio,dome light,alarm and power locks dont work.

Apr 26, 2009 | 1998 Toyota Corolla

1 Answer

2004 PT Cruiser dome light doesn't work


If there is a switch on the dome light, that may be your problem. You would need to remove the assembly and check for voltage coming into the switch using a voltmeter with the door open.

May 30, 2017 | 2004 Chrysler PT Cruiser

2 Answers

Dome light


the switch is in the latch assembly

Jun 19, 2008 | 2004 Ford F250

Not finding what you are looking for?
1996 Mazda 626 Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

Marvin
Marvin

Level 3 Expert

83096 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...