Question about 1999 Dodge Intrepid
Your thermostat is located under the housing where the upper radiator hose connects to the engine. The housing is held to the engine with bolts,and has a gasket that must be replaced when you replace the thermostat. Make sure all surfaces are cleaned before reassembly.
Posted on Dec 10, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
The Water pump on your Intrepid 2.7L.
Is located in front of the engine, But you can't see because is inside of the timing cover.
And the Water pump is driven by the Timing chain.
I hope this help on your question.
Thank you for use fixya..
Posted on Jan 15, 2009
What engine? 2.7 passenger side on the bottom next to oil pan. 3.2 and 3.5 Drivers side coming off the side of block, near the front under the exhaust manifold.
Posted on Mar 24, 2009
The "Vehicle Speed Sensor" signal is generated by the transmisson output speed sensor. That is the one located at the rear of the case. It is externally mounted. That supplies "vehicle speed" info to the other On-Board Computers. The input turbine speed sensor is located just behind the bell housing area of the case. I believe the trans controller is the only module that needs that info. The Crank Position Sensor give engine RPM info and it is located on the bell housing near the engine block. I hope this helps.
Posted on Apr 02, 2009
Tips for a great answer:
Jun 14, 2012 | 2001 Dodge Intrepid
Jan 11, 2012 | 2001 Dodge Intrepid
Feb 23, 2011 | 2001 Dodge Intrepid
Aug 14, 2009 | 1999 Dodge Intrepid
May 18, 2009 | 2001 Dodge Intrepid
Jan 27, 2009 | 2001 Dodge Intrepid
Jul 21, 2017 | 1999 Dodge Intrepid
304 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: