Question about 2006 Jeep Wrangler

1 Answer

My door latch will not lock in to place. It is below freezing and I dont know if the door is broke or the latch is just stuck

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

Likely it's just stuck. Spray it with wd 40 or other solvent and make sure the latch hook is open. If it's not, pull the door release handle (like you are opening the door) and gently pry the hook back to the open position.

Posted on Dec 10, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bmw 6 series doors are closed and latch is stuck


Buy something called a z-tool or call AAA and have them open the door for you.. A z tool took the place of a slim jim. It will not damage your car though...

Jan 25, 2014 | 2005 BMW 6 Series

1 Answer

Rear latch lock stuck in the open position


use a round bar ( a screw driver ) and place it under the latch and pull the latch out as you press the button to unlock as if you were opening the door.

Jan 06, 2014 | 2008 Chevrolet Uplander

2 Answers

2006tdifordfocusdoors


They are stuck and need to be lubed. Use WD 40 and spray the latch on the door. Then close the door and open it a few times to work the spray in. Then spray it again it should work just fine.

Nov 25, 2012 | Cars & Trucks

1 Answer

2000 pont. gr am pass door only opens when you use door key to unlock and pull handle at same time , the door lock are auto. you can hear it unlock but cant open it normally


there has been lots of problems with the power door lock actulator on this model . you will need to remove the door pannel and then remove the door lock latch assembly and inspect to see if the actulator is broke . If it is broke then you will need to replace the latch assembly as i dont belive that the actulator comes seperate from the latch . but check with your local parts store or dealer

Mar 04, 2011 | Pontiac Grand Am Cars & Trucks

3 Answers

Driver side door is frozen open with lock closed. Try to close door and it bounces back. Unlocking with key or with auto-lock does nothing. Key turns, lock button goes up and down, but mechanism does not...


Give the locking "jaws" a good dose of WD-40 and start with a pair of pliers ans working the door handle get the "jaws" moving and work it a lot while keep dousing it with the lubricant. Worst case scenario would be that the spring that opens the jaws is broken and will need replaced. Please rate this answer, thanks.

Feb 06, 2011 | Ford Taurus Cars & Trucks

2 Answers

2002 Hyundai Elantra Drivers dorr Lock Jammed not unlocking properly. Lock lever on inside and key on outside are stuck and door move bery much and will not unlock car. Originally cable in door to release...


Same thing happened with mine. It turned out that the power door lock motor went out. Since the handle or the switch can unlock the driver's door, both of these mechanisms are connected. When the door lock motor goes out it freezes in whatever position, it was last engaged.

Nov 06, 2010 | Hyundai Motor 2002 Elantra

1 Answer

Power sliding door will not open at all manually with remote or with door locks tried to remove iod fuse and sliding door fuse but still dont open thanks


either something jammed in track/lock-- or actuator rod broke or disconnected from lock --need to remove interior door panel to get to lock release and latch check all rods and clips for damage or missing repair or replace as necessary u can manually unlock the door at latch if something was jammed or stuck in latch

Nov 26, 2009 | 2007 Dodge Caravan SXT Minivan New Cars

1 Answer

The driver side door lock wont go all the way up.


The outside door handle spring is broke ,or the latch spring is broke. The only way to tell is remove the door panel and inspect the rod from the handle to latch. Look for broken spring on handle. I have installed an external spring from the handle rod to latch to keep the rod in the full up position.

Nov 18, 2009 | 1999 Ford Ranger SuperCab

1 Answer

Driver's side door power locks are stuck; door stuck shut.


sounds like the rods are disconnected the clips hold the rods in place the latching mechanism holds the handle in place as well did you replace the speakers or did a shop? if a shop did then they caused this if you did then you may have caused this either way untill you reattach the rods none of it will work. you will have to manually open the door at the latch from inside teh door behind the panel.

Jul 16, 2008 | 1993 Ford Mustang

Not finding what you are looking for?
2006 Jeep Wrangler Logo

Related Topics:

178 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

83514 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22393 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...