Question about Toyota Camry

1 Answer

2004 camry will start but gas pedal dosent work

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Broken cable

Posted on Dec 10, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Key was left on ignition of camry 2007. Car wouldn't start, jumpstarted and then it started, but no rpm or response to gas pedal.The radio does not work either. My son replaced the fuel fuse but

You most likely blew a relay. It's just like blowin a fuse only a bit bigger. It sounds like maybe your secondary ignition. Your relay box should be on the drivers side, either right on top(when u open the hood) or mounted to either the firewall or the fender

Feb 06, 2013 | Cars & Trucks

1 Answer

Car shut down when foot not on the accelerator

For this types of problem,there are few help links.I suggest you to click the link below and go through the troubleshooting procedure :-----Car only starts when gas pedal is pressed? won't start without hitting the gas pedal?
----------Complete loss of brake pedal then all gets normal?
----------Car dies when gas pedal is pressed?
--------------Pushing on the gas pedal, but the car slows down? Gas pedal to the floor and the car slows down?
-------------Idles rough and quits when gas pedal is pressed less? will help.Thanks.

Feb 02, 2012 | 2002 Toyota Camry

1 Answer

My 92 camry wont start due to low or no compression. i need to get it started to put therma gasket in it so i can drive it to the dealership n trade it in. do you have any idea how? thanx

If this car has no or low compression i dont think its going to run, you can try holding the gas pedal to the floor and cranking it, you may nned to hold the gas pedal to keep it running but low or no compression i dont know, but its wroth a try.good day

Sep 03, 2011 | 1993 Toyota Camry V6

1 Answer

Car wont start, put in new battery new terminals check fuses. have lights but it dosent kick over

If it is an automatic, try starting in Neutral.If that works than it is a bad Neutral start switch-- which is located in the transmission shift lever.
If it is a stick shift than it could be the clutch switch, whish is located on the clutch pedal.
Or if all that does not make a difference, check the starter relay,located in the fuse/relay box in the engine compartment.
If the relay is good than you are left with abad starter.

Apr 21, 2010 | 1993 Toyota Camry V6

1 Answer

The last two mornings my Toyota Solera's gas pedal did not respond. the car started, I put it in gear but the gas pedal did not respond. Came back 2 to 3 hours later after it was warmer and I was able to...

1. never drive a car thru high water!
yes i have seen the throttle motors fail on the pickups
after fording deep water, cleaning it is a temporary fix at best.
there are other sensors in the throttle body assembly
that also fail when soaked with water.
replacing the assembly is the best fix.

Feb 01, 2010 | 2004 Toyota Camry

1 Answer

Car starts but the engine does not reve when I

either broken accelerator cable or broken throttle position sensor, open the bonnet and see if the gas pedal actually turns the throttle, if the throttle is turning then the fault is in the TPS -
That should fix it, simple to fit. one out one in + reattach the connector.

Jan 26, 2010 | 2004 Toyota Camry

2 Answers

My 2000 Toyota Sienna cannot start in the morning/cold engine

the crank position sensor and map sensor is malfunctioning

Aug 01, 2009 | 2004 Toyota Sienna

1 Answer

2005 camry tail light blows

Does it work when you press the brake pedal? If so, sounds like you have a faulty bulbs. IF it doesn't work when brake pedal is applied I would check the fuse under the hood or left kick panel on the driver side.

Sep 20, 2008 | 2004 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

83083 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides