Question about 2004 Dodge Ram 2500

1 Answer

The heater blower only blow out the dash vents will not blow on floor or defroster on 2004 ram 2500

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 83 Answers

More than likely you have a bad climate control module (the knob critter thing). Unfortuneantely, you can't just buy one and install it, it has to be programmed on that year and model truck. I hate to say it, but sounds like a trip to the dealer. OR, you can find one at a slavage yard and try for the best. If the programming is the same, you might get lucky. the Stick

Posted on Dec 10, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to repair 2004 Ford Crown Victoria A/C will not blow from dash vents


its either a bad air control panel or u have a bad damper valve in your dash

May 01, 2014 | 2004 Ford Crown Victoria

1 Answer

How to repair


i'd think that the vent adjuster knob/slider is not working correctly strip out the heater panel around the control knobs and check the vent direction is working properly either stiff operation so a little wd40 on the cable would probably do the trick or some thing causing the vent itself to not move

May 01, 2014 | 2004 Ford Crown Victoria

1 Answer

Heater and Defroster not blowing air


check vent flaps inside the blower unit....

Nov 24, 2013 | 1996 Mitsubishi Mirage

2 Answers

I have a 2007 dodge 2500 diesel and the heater will only heat up to a very light heat.


Mode Door 1.
a.This door regulates air flow to either the dash vents or defrost/floor. If you have air flowing only through the vents with no defrost or floor, this door is failing. From our experience, this door is usually the first domino to fail. Not sure why, just is.
<!--[if !supportLists]-->4.Mode Door 2.
a.When mode door 1 is set to divert air away from the vents and into the second stage of the system, door #2 chooses whether air goes to the defrost vents to the windshield or out through the floor vents in the passenger and driver's side footwells. Failure is indicated by an inability to choose between defrost and floor.
b.This door turns out to be the most difficult to replace. In order to replace the door, the dash panel has to be removed. It's still better than the dealer fix because you don't have to evacuate the AC system, drain the radiator, and remove the plenum box. But it is more work than the other fixes. When this door breaks, it falls in the down position, blocking the floor vents and diverting all air through the defrost vents. From a safety standpoint, this is good since you'd most likely rather have a clear windshield than warm feet. We suspect that a large percentage of customers will just leave this door unrepaired. You will have heat through the dash vents and to the windshield, just nothing to the floor. It's inconvenient, but you'll have to make the determination if warm feet are worth the extra work to fix the door. An extra pair of socks is easier.

Jan 12, 2013 | 2007 Dodge Ram 2500

1 Answer

Heater blows out of defroster and floor vents no where else no matter where switch is set


Three things come to mind.
Defective door actuator.
Broken door.
Faulty switch.

Have someone operate the controls while you look up at the motors(at least three) blend, recirculation, and vent control.
observe the motors inaction you might be able to see the axles on them move. if all of them move, the door is at fault. Requiring dash and vent assy removal for repairs.

Oct 28, 2012 | 2001 Dodge Ram 2500 Truck

1 Answer

Heater blower will not blow out to floor


In relation to this problem,there is help link provided below.Click the link below to go through its procedure to troubleshoot the problem :----------
http://howtobyme.blogspot.in/2012/02/heater-blows-only-from-defrost.html

---------
This will help.
Thanks.

Feb 11, 2012 | 2004 Chevrolet S-10

1 Answer

Defrost blows constantly? How do i fix it?


does it blow through the defrost vent only when you switch to vent/floor or does it blow through defrost and vent/floor? is it a switch that is just electric or a manual lever that you slide? the manual type will have that problem if the diverter or the linkage behind the lever(in the dash behind the panel......may be able to access underneath) becomes broken or disconnected so that the air is diverted to defrost regardless where you move it.if you can get to it, you will see what is broken or maybe a fastenerr fell off.

Feb 13, 2010 | 1994 Chevrolet C1500

1 Answer

2003 Dodge Ram 1500 quad cab. While replacing a


it may be the switch itself they do go bad.Otherwise he could have pinched a hose or left one off. But it sounds like he is trying to help.

Feb 11, 2010 | 2004 Dodge Ram 2500

Not finding what you are looking for?
Cars & Trucks Logo

283 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

81342 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...