Question about 1997 Chevrolet K1500

1 Answer

I have a 1997 chevy suburban k1500 and when in 4 wheel drive i hear a clicking sound from under the floor

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 73 Answers

That could be a number of issues with your transmission, the u-joints on the front driveshaft, or the transfer case. Get it checked out. Good Luck.

Posted on Dec 09, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove transmission from a 1997 chevy suburban 4x4


Jack up and block under the front wheels about a foot off the ground Go underneath and remove the rear transmission mount cross bar and drive shaft lower down the transmission enough to get at the bell housing mount bolts Remove them and the 4 torque mount bolts use a floor jack and roll the trany back and out

May 22, 2015 | 1997 Chevrolet Suburban

1 Answer

Chevy push button wheel drive


check the vacuum lines to the actuator in the front wheels . check the actuator operation in the transfer case.

Feb 15, 2014 | Cars & Trucks

1 Answer

1997 chevy suburban 1500 four wheel drive wont start


ignition contol modual. need to get that check. orielly can check them for free.

Dec 06, 2011 | 1997 Chevrolet K1500

1 Answer

I replaced belt on my 97 Suburban but the tention pulley did not click. But the belt feels tight. The pully moves back and forth. Is it safe to drive without me hearing the click sound.


yeah it'll be ok for you to drive it as long as its not sloppy loose or super tight you'll be ok. but if you still have doubts replace your tensioner pulley

Jul 28, 2010 | 1997 Chevrolet Suburban

1 Answer

1999 Chevy Suburban 1500 stuck in 4 wheel drive.


Check the wire harness on the transfer case to make sure it's still plugged in. Check the selector switch in the dash. Check the hub sensor wire harnesses on the front wheels.
Check for error codes through OBD-II connector under the dash.
Good luck.

Feb 14, 2010 | 1999 Chevrolet Suburban

2 Answers

I am looking for the proper procedure to shift into 4wd lo on a 1994 GMC Suburban K1500


Typically and this is how it works on my 94 chevy suburban.

Put the truck into neutral.
apply the emergency brake
press the brake pedal and move the 4X4 shifter into 4wd lo
Than put the vehicle back in park release the emergency brake
and you should good to go from there.

please let me know if you need any further assistance with your vehicle and i would be glad to help you.

Jan 09, 2010 | 1994 GMC Suburban

1 Answer

4HI and 4LO light flashing 2000 Blazer LT


it is very possible that a wheel speed sensor is open or reading erratic, causing the ECM to override the 4WD switch. Borrow/rent/buy a scanner that will tell you this info,

Jul 15, 2009 | 1997 Chevrolet Suburban

1 Answer

1997 Cheverolet Suburban


I had the same problem with my 97 Suburban & replaced all the same stuff before i found out what really was wrong. it turned out to be a front wheel bearing. my abs would kick on at low speeds under 10 mph right before completly stopping. there is an electrical sensor in the wheel bearing that was malfunctioning creating the illusion the wheels were about to lock up therefore kicking on the abs. now all you have to do is figure out which wheel bearing is the source of your problems. if i were a betting man, i would stack my chips on this solution. good luck.

Feb 23, 2009 | 1997 Chevrolet Suburban

1 Answer

1998 Chevy Blazer 4x4, $ wheel drive won't work (both 4hi & 4lo )


Reset the computer by disconnecting the battery. This should solve this. nutetral is for the four lo only to engage.

Mike

Jan 26, 2009 | 1997 Chevrolet Blazer

5 Answers

HOwling noise from 99 Suburban 4X4


might be one of your catalytic converters clogging up. usually happens after engine has been running for a time? mostly heard when you let off the gas pedal? does the noise appear to be coming from the transfer case area? i thought i was having tranny problems, but turned out to be one of the catalytic converters. whew....

Oct 18, 2008 | 2002 Chevrolet Suburban

Not finding what you are looking for?
1997 Chevrolet K1500 Logo

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

83481 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22393 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...