Question about 2001 Chrysler PT Cruiser

1 Answer

WHERE IS THERMOSTAT LOCATED ON 2001 PT CRUISER

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,627 Answers

Follow the top radiater hose to the engine and the part it clamps to is the thermosat housing.The thermosat is in that housing.

Posted on Dec 09, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How much coolant goes into the radiator of a 2001 pt cruiser?


Approximate coolant capacity.
2001 to 2002 Chrysler PT Cruiser: 7.2 qt (7 liters)
2003 to 2010 Chrysler PT Cruiser: 6.5 qt (6.2 liters)
Mar 4, 2015

Which coolant for a Chrysler PT Cruiser? - PT Cruiser Repair

pt.cruiser.repair/663/which-coolant-for-a-chrysler-pt-cruiser/
2001 pt cruiser Google Search

Jan 27, 2017 | 2001 Chrysler PT Cruiser

2 Answers

Where is the thermastat located on the 2001 pt cruiser


Here are the instructions from chiltons.

Removal & Installation
  1. Disconnect negative battery cable.
  2. Drain cooling system below thermostat housing level.
  3. Remove thermostat.
  4. Disconnect engine coolant temperature sensor.
  5. Disconnect heater supply hose.
  6. Turbocharger equipped vehicles:
    • Recover the refrigerant from the refrigerant system.
    • Disconnect A/C suction line from A/C compressor.
  7. Remove housing attaching bolts.
  8. Remove housing and gasket.
To install:



  1. Clean all gasket sealing surfaces.
  2. Install gasket and housing. Tighten bolts to 20 ft. lbs. (28 Nm).
  3. Turbocharger equipped vehicles:
    • Connect A/C suction line to A/C compressor.
    • Evacuate the refrigerant system.
    • Charge the refrigerant system.
  4. Connect heater supply hose.
  5. Connect engine coolant temperature sensor.
  6. Install thermostat.
  7. Fill cooling system.
  8. Connect negative battery cable.
Please do not hesitate to ask further questions about your vehicle.
please do not forget to rate and comment about your experience with fixya.

Dec 27, 2009 | 2001 Chrysler PT Cruiser

1 Answer

I have a 2001 pt cruiser need to find where the crank sensor is located 4cyl


It is located next to crankshaft. Just follow spark plug wires to coil pack and module. Then follow from there and they lead directly to crank sensor.

Nov 19, 2009 | 2001 Chrysler PT Cruiser

3 Answers

Location of powertrain control module on 01 PT Cruiser?


The PCM attaches to a bracket welded on the dash panel

2d254d5.gif

Oct 31, 2009 | 2001 Chrysler PT Cruiser

1 Answer

Need to replace a Thermostat on a 2001 PT Cruiser. Have the new Thermostat need insturctions on how to do the replacement.


Most thermostats are located in the upper radiator hose housing mounted to engine block. Make sure engine is cold put a catch pan under your car to catch any antifreeze that comes out. Remove the two bolts holding the housing on the engine and remove thermostat and gasket. Clean engine block where gasket goes very good and also the housing, have to remove all gasket material so when installing new one it will seal and wont cause a leak. Make sure when you put the thermostat back in it goes in spring side down towards engine. Replace housing and bolts. replace lost coolant with a 50/50 mixture in your recovery tank. Start engine let heat to temp and check for leaks.

Sep 08, 2009 | 2001 Chrysler PT Cruiser

2 Answers

Where is the power steering sensor located 2001 pt cruiser


It is located on top of the rack and pinion assembly.

Jul 15, 2009 | 2001 Chrysler PT Cruiser

3 Answers

Chrysler pt cruiser fuel filter location?


Under vehicle, center, below seating area, mounted on top of fuel tank, in fuel pump module

Mar 27, 2009 | 2001 Chrysler PT Cruiser

1 Answer

2001 pt cruiser no heat


did you check the fluid level by removing the rad. cap? Radiator should be full to top. If Chryslers are low on coolant, the heater will not blow warm air.

Jan 04, 2009 | 2001 Chrysler PT Cruiser

1 Answer

Where is the oil pressure switch located


it is located toward the rear of the engine on block rear of exhaust manifold one wire, green in color i believe

Dec 10, 2008 | 2001 Chrysler PT Cruiser

Not finding what you are looking for?
2001 Chrysler PT Cruiser Logo

Related Topics:

441 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

83096 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...