Question about 2001 Volkswagen Beetle

1 Answer

2001 beetle with a code of glow plug heater CKT A malfuntion...dont know what to do

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 194 Answers

P0380 right ?? with a cold car pull the harness off the plugs and first check that the harness gives out 12v when the key is turned on. you gotta be quick so having 2 people helps a lot. if no juice here the GP relay might be shot.... then use an ohm meter to check the resistance of the plugs. all 4 should be exact same reading. if the computer sees an imbalance between plugs it trips a code. if the plugs are old replace them anyway.

Posted on Dec 09, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

OBDII codes


The other codes are related to the transmission control system. O would focus on getting the car started. I will guess you are getting no sparks. This could all be caused by a bad crankshaft position sensor.

Jan 06, 2018 | 2001 Volkswagen Beetle

1 Answer

1998 ford ranger 4x4 4.0l 6cylinder automatic does


My friend this sounds like a catalytic converter problem. A number one symptom in the case of a "burned up" catalyst is loss of power or as you put it bogged down. Try disconnecting at the flange if not too much trouble or simply remove the O2 sensor downstream and see if pressure changes (old trick)

Jul 09, 2011 | 1998 Ford Ranger SuperCab

1 Answer

PO672 CYLINDER 2 GLOW PLUG CIRCUIT, THIS IS WHAT THE COMPUTER ERROR CODE SHOWS. WHAT DOES THIS MEAN?


If you have replaced the glow plugs....replace glow plug harness. If code reappears, replace glow plug controller.

FYI: VW numbers the glow plugs backwards. IE: #1 cylinder next to the timing belt cover is number #4 glow plug...so your #2 is actually #3 on the engine.

Dec 20, 2010 | 2002 Volkswagen Beetle Turbo S

1 Answer

I get PO700 trans cntrl syst malfuntion and PO705Trans range sensor ckt malfuntion PRNDLimput where are located??


this may sound a bit stupid but I suggest that you check the positive battery cable (below the main fuse). That was where my problem came from. On mine I had 700 and 705 codes and it got to where the starter lost it's solenoid signal.

Nov 10, 2010 | 2007 Suzuki Forenza Sedan

1 Answer

My 2001 VW Beetle diesel will not start sometimes. The glow plug light will not even come on. If it does come on, it starts fine. If the glow plug light does not come on, it will not start. We changed...


Check for battery to motor ground and battery to body ground for corrosion under mounting bolts. also check motor to body ground strap for corossion and overall condition. Bad ground can cause all sorts of problems. Also check all electrical connectors to glow plugs for corossion.

Oct 20, 2010 | 2001 Volkswagen Beetle

1 Answer

Glow plug heater


befor doing anything else, check each glow plug resistance, one bad one will cause problems

May 10, 2010 | 2000 Ford F350 Super Duty Super Cab

1 Answer

Glow plug heater


the glow plug relay is located onthe pass side valve cover ! it has two large cables on it and two small ones

May 01, 2010 | 2000 Ford F350 Super Duty Super Cab

1 Answer

P1196 manufacture specific DTC


o2 sensor heater circuit malfuntion. bank1 sensor 1. this is the oxygen sensor before the cat.

Oct 31, 2009 | 2001 Volkswagen Beetle

1 Answer

Can anyone tell me where to find the glowplug relay, it's a 7 prong relay, on a 2002 vw beetle 1.9 diesel no turbo ? allready been under the dash and checked all the relays, none of which are 7 prong,...


Above the Relay Panel is the Auxiliary Relay Panel. Has thirteen positions in it.
6 across the top, 7 across the bottom.

Across the bottom the Glow Plug Relay is the fourth one over from the left. It is Number 10.
(180)

Sep 17, 2009 | 2002 Volkswagen Beetle Turbo S

Not finding what you are looking for?
2001 Volkswagen Beetle Logo

Related Topics:

263 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

Marvin
Marvin

Level 3 Expert

83772 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...