Question about 1999 Porsche 911 Carrera

1 Answer

Cost of rear plastic window on 1999 911 cabriolet

Cost of rear plastic window repair upholstery is pulled away from window on 1999 911 cabriolet

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Most auto upholstery shops can fix this - mine cost about $600 for a tinted plastic. Clear plastic was the same cost. I had mine done in Costa Mesa, CA

Posted on Jan 24, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 chevy lumina van lock broken and can't gain entrance to end. Any solutions to open or replace a lock?


Does Lumina sedan have rear seat pass thru to trunk ?? if sedan then a pull tab will be in seat upholstery near shelf / by rear window . pull it crawl in with Light Plus friend on outside to hand tools .. IF VAN must remove interior panels to gain access .. Try small thin needle nose pliers to pick broken KEY Piece out of lock 1 ST . if successful spray in Lubricant before trying another key . BUT must be reason lock jammed -- Frozen by weather change or Mechanism Disconnected due to lack of lubrication or worse Plastic Parts used in assembly by Factory .. DRILLING Lock Out will get it Open but new / used parts to repair are now on your shopping list ..

Nov 13, 2014 | 1990 Chevrolet Lumina

1 Answer

I have a 2009 Chevy malIbu. The plastic cover behind the seat is pulling away from the bucket seat. It has 2 little white plastic screws that are bent and cannot be straightened. How can I repair this or...


you can call a dealer to see if these clips are available seperatly, if they are part of the seat, contact an upholstery shop and see if they can repair it

Jun 10, 2012 | Cars & Trucks

1 Answer

2003 austin mini cooper broken back seat latch


I just got done fixing mine. The culprit was a slipped axial spring by the key-lock mechanism in the seat. Yep, it's likely that nothing is broken, just a bad design, I'm looking at you MINI. It's not pretty to get at, but the repair is fairly straightforward.

Labeled pictures can be found here: http://www.flickr.com/photos/25717593@N04/sets/72157629775433188/with/7217494500/

The first task is getting the seat back out. I tried several different ways to "alternatively actuate" the latch from the back, but couldn't see anything and couldn't come up with an appropriate tool. The nature of the failure doesn't let you grab the cable with pliers and pull. The cable is totally useless at this point.

So, I went in from the front. To get at the latch mechanism, you have to partially pull off the upholstery. Luckily, it is not nearly as bad as it sounds. The upholstery has a plastic edge that presses into a seam on the back side of the seat pan. You just start at the top of the seat, and start pulling the edge out. You can do it with just your fingers. I'm afraid as time goes on and the cloth gets worn, things may rip, but my '05 interior has held up quite well..... even in AZ. Anyway, separate the edge as much as you can from the top, around the upper right corner and down the right side. Maybe you can get away with just pulling away the top.

Pull back the top and right corner of the upholstery and padding. Again, maybe you can get away with just pulling away the top.You just want to get enough access inside the seat to see in at the top left corner with a flashlight. What you'll see is a metal ear with a hole in it. Take a coat hanger, put a small hook in the end, fish it into the corner, hook the hole and pull the ear up. Your seat will unlatch.

Once you have the seat back removed, pull back the upholstery from the upper left corner and remove the two Torx bolts. Bend back the upholstery, hold on to the plastic key lock housing from inside and pull it straight off the latch assembly. There are no screws hold them together, its just a press fit of plastic onto two posts.

You can now see the top where the cable end is attached. You will see the axial spring and it will more than likely be resting on the metal housing instead of the plastic lever where it should be. I just put the spring back on which is dumb because this failure is bound to occur again in the future. If I have to do it again, I will probably heat up a small piece of pin and push it into the plastic behind the spring flange with it sticking up about two spring wire diameters. This would act as retainer and probably keep the pin from wiggling off again.

Look at the annotated pictures linked above for more info. Good luck.

Jan 19, 2012 | Mini Cars & Trucks

1 Answer

2003 Audi A4 Cabriolet Engine turns over but will not start


First determine if the engine timing belt is still good.

Pop off the clips holding the black plastic cover over the timing belt...and pull away so you can see the belt.( The end away from the transmission.)

Have someone watch the belt as you crank the motor.

Belt should smoothly run while cranking.

If not....you have a broken set of teeth on the belt.

Jan 17, 2011 | 2003 Audi A4 Cabriolet

1 Answer

Rear glass in a4 soft top has come away from hood any ideas on repairers or what adhesive i can use


I went to a local car upholstery shop. They used special glue meant just for this and it only cost $55. for them to do it (correctly...vs me doing it!)

Oct 26, 2010 | 2003 Audi A4 Cabriolet

1 Answer

How to replace rear rag top window in a 97


I will assume that you have a glass window ,as opposed to a clear plastic one.
Look for a tiny zipper on the window welting ,on the inside,or a sewin ,in velcro tab .
Some of the window styles will change ,without notice from the manifacturer.
Check with an upholstery shop /a glass shop,they should know this ,and most will be happy to help.
I hope this help's

Mar 08, 2010 | 1997 Audi Cabriolet

1 Answer

How do you get to rear window 1991 towncar, it is stuck all the way down


You have to open the door and remove the door panel. There is a screw at the top front and the top rear of the panel. Also there is a screw hidden under the plastic covers on each end of the door pull strap. Push up on the plastic covers and remove the top first with a knife tip. If they mess up, they can be reinstalled with a spot of silicon. Open the ashtray door and remove the screw. pull the switch panel up and remove the screws from bottom of switch. Slip upholstery tool (any parts store) under door panel and pry out around edges. Pull plastic moisture barrier off of door and there is your window!!!

Oct 07, 2009 | Lincoln Town Car Cars & Trucks

2 Answers

Cloth coming away from the rear glass


I have the same problem with my 4 year old A4 cab, the seal has gradually broken over last 6 months and now the whole right & left sides of the window are exposed - tried glueing it myself with no success.

Audi tell me it is possible to have the window stitched into the fabric but I assume this involves replacing the original window with a plastic one and therefore losing the option of heated rear window.

I very much doubt Audi will cover the cost of a new roof once warranty runs out, I find it disappointing (but predictable) that they cannot simply re-seal the fabric to the window.

Jul 10, 2009 | 2003 Audi A4 Cabriolet

3 Answers

Split in my rear plastic window audi cabriolet 1996 2.6 v6 HELP!!


The window can be replaced just go to a foreign car used auto parts or junkyard or go to your nearest dealer for your car and have it done.

Jan 02, 2018 | 1996 Audi Cabriolet

Not finding what you are looking for?
1999 Porsche 911 Carrera Logo

Related Topics:

423 people viewed this question

Ask a Question

Usually answered in minutes!

Top Porsche Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22393 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

918 Answers

Marvin
Marvin

Level 3 Expert

83557 Answers

Are you a Porsche Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...