Question about 2001 Chrysler Voyager

Open Question

Chysler grand voyager dashboard failure

I have a 98 chyrsler grand voyager 3.3. For some time now the dash board dials wont work. They just go to zero, so I dont know my speed , revs,petrol and temp gauge. A few bangs on the top of the dash or on the persplex gets everything working again, but I know this cant be doing the car any good. My sister in law has the same car and also the same fault. Any answers appreciated

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
ndguy2481
  • 251 Answers

SOURCE: Speed gauge is not working in car.

more then likely it is a speed sensor located between the motor and transmission

Posted on Dec 08, 2008

Ad
  • 363 Answers

SOURCE: MY CHYSLER VOYAGER 1997 2.0

It sounds like your transmission is going into the limp mode. The transmission goes into limp mode to protect the transmission from major damage. You either need to take it to the dealer or to a transmission shop to have a diagnostic test done.

Posted on Jul 23, 2009

  • 57 Answers

SOURCE: i have a chrysler voyager 2ltr P-reg when turning

Its likely to be the 21 pin plug behind the heater control panel. Remove the long plastic strip under the control panel (prise of gently, held on by 2 clips) remove 2 screws behind this and 2 screws above on panel. The whole lot should easily come away. There will be 3 plugs, remove all three and try to start the car. If it starts your problem would be the earth. Hope it helps

Posted on Sep 24, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 Plymouth Grand Voyager.........Dashboard instruments quit working and don't light up. Speedo, tach, fuel gauge, temp gauge, and mileage indicators and lights for same stopped working. ABS...


You have some wiring problems shorting out that is coming from the dash board so if you or anyone you know how to use a multimeter to check the wireing harnesses plus check any connectors that might be just very touching the connector of dashboard which means a bad connection to dashboard.

Jun 04, 2011 | 1998 Plymouth Voyager

2 Answers

,have 1997 plymouth grand voyager, instrument cluster goes out while driving code #p1698, if u hit dashboard above cluster it usually comes on has 3,3 litre enginel


Sounds like you may have the dash cluster solder problem. Here's a link to some pictures of what needs to be done, but if you google Caravan dash soldering, or similar, there is more details out there.

http://www.ingriddijkers.com/CaravanPics.html

Jan 14, 2011 | 1997 Plymouth Grand Voyager

1 Answer

1998 grande voyager 3.3 l v-6 every three to


I'll bet you do have an immobilizer. When you turn the key, when it works, look at the lights on the top of the dash, toward the right side. Do you have a yellow light that lights up that says alarm? What you are describing is a common problem with 98 caravans. It sounds like you have a cracked circuit board in the cluster. When the cluster messes up it crashes the diagnostic line of the vehicle. When this happens the antitheft system cannot communicate with the ecm.

Jun 15, 2010 | 1998 Plymouth Voyager

2 Answers

Water leak from under dashboard on passenger side


ok your evaporator is leaking, same must be replace with a new one. its not a easy do it yourself tash, it entail removing the dash board.

Jul 31, 2009 | 2000 Chrysler Grand Voyager

1 Answer

HELP! Problems on my 1997 Grand Caravan P1698, P0138, P0140


you need to go over your entire wiring harness, under the hood and inside the dash. Start with the ground wire on the battery and work your way inside. It sounds like there is a loose ground wire somewhere

May 06, 2009 | 1999 Plymouth Grand Voyager

1 Answer

I have a 97 plymouth grand voyager sometimes it will start other times wont i replaced one computer but it still does it starter is new and the guages quit working help


You need to pull out the Printed Circuit board behind the dash board gauges and re-solder ALL the parts on the board. Only attempt this if you are experienced at soldering electronic PC boards as you could permanently damage the board.

Mar 31, 2009 | 1998 Plymouth Grand Voyager

3 Answers

Dashboard gauges are all out


check your fuse box, should be somewhere under the dash, or sides of dash.

Dec 25, 2008 | 1999 Plymouth Voyager

Not finding what you are looking for?
2001 Chrysler Voyager Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...