Question about 2007 Jeep Liberty Sport

1 Answer

2007 Jeep Liberty - Not Starting: Our jeep will

2007 Jeep Liberty - Not Starting: Our jeep will randomly not start and when you turn the key just one click forward the oil light will stay on so we checked the oil and it was fine but added just a little and it started after about 10 minutes. After that we did not have any problems for weeks and then it did it again so we went and had the oil changed - that seemed to help for a month or so and now it is doing it again only may not start for days - and then it will start and run fine again although we are not driving it. We took it in and they told us they had no idea what was wrong and that we would have to wait until it will not start again and have it towed back to the garage because currently they have no idea what is wrong. Any suggestions??? Thanks!

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 20,706 Answers

One click is , lamp test, mode, see operators guide on how to start your car, it tells all this lamp stuff.
Does it crank
if a/t car , you cant push start it so
automatic trans, cars, tell what you have for drivetrain

first learn 2 word
cranks ok
but does not start
or will not crank

mine push starts and gravity hill starts, but is and M./t stick shifted
jeep.
i can start my car 3 ways. see?
done so vast time.

tell what happens as you turn the key
head lamps are bright right>
i turn the key the starter is silent.
and i try to crank in neutral as the operators guide directs you and it does what?
the A/t CAR WILL CRANK IN PARK OR NEUTRAL.
TRY THAT.

Posted on Mar 21, 2017

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: Oil pressure light comes on after driving on highway for 10 miles

Sounds like your sending unit sensor - if it was your pump going out, your engine would be history by now. Rule of thumb, if your oil check light ever comes on, it's usually too late to remedy the problem. You have a major issue, but since you've obviousely drove it quite a bit since then and it still hasn't seized up, I'm guessing you're ok...for now. Since you took it to a shop and they said you're ok, I'm assuming they checked your level and visually checked for leaks and found nothing. Either, you've got somethijng partially blocking your pick-up tube for the pump which is in your oil pan, or a electrical issue with the sensor. I would start by having someone check the sensor out and go from there...good luck.

Posted on Dec 30, 2008

MrScary66613
  • 1990 Answers

SOURCE: 2005 Jeep Liberty Renegade Differentials

This totally depends on how Much "Hard Driving" that you do. Offroad, 4x4 all the Time, ETC.... If you do I would Change at every 50,000 If not Every 80,000 is OK

Posted on Jan 10, 2009

  • 6982 Answers

SOURCE: Cuts off, but will restart, then cuts off again

Likely, you have a damaged engine bearing. When there is a problem there it will turn oil pressure light on because bearings keep the pressure inside the crankshaft...It may stop as the bearing overheats and binds, then loosens up a bit allowing a re-start when it gets cooler. Battery sounding dead is likely because the engine is locking up and too difficult for starter to turn.
At this point, it is not a do-it -yourself project ...either you need a lower end rebuild or engine replacement.

Posted on May 28, 2009

Molson02536
  • 3854 Answers

SOURCE: 2003 Jeep Liberty. Changed oil, running very rough and dies.

Buy some Marvel Mystery oil from Auto Zone and add it to you engine oil. Keep an eye on your engine oil level everyday with the Marvel in there and change the engine oil every 3000 miles. Hope the Marvel will clean out the lifters for you and the rest of the sludge in the engine. Do Not Use Engine Flush!!!! There know to eat the seals and kill engine sensors.
The EGR could also be stuck with carbon build up and may need to be cleaned or replaced. Try doing this, turn your radio off and disconnect the battery for a min, turn the ignition key to the run position and re connect the battery then start the liberty. That should reset the air idle control valve
Let it idle down and then go for a test drive after it warms up. Good luck and keep me posted, while your at Auto Zone have them scan your liberty for any DTC codes. Be glad to help.

Posted on May 31, 2009

  • 6982 Answers

SOURCE: my 2001 jeep liberty needs water added often, like

OK, you know that you are loosing coolant somewhere. What you need to do (I can't from here) is carefully look at everything that water passes through till you find evidence of seepage. Check the ground where you park (but remember that coolant will run down and across, dripping somewhere other than exactly where the leak is) Check the chassis after sitting a few hours, under the pump pulley and head/block parting lines..rug on passenger side and heater control valve on hoses going into firewall.but definitely EVERWHERE.

Posted on Jun 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Jeep Liberty will not start no click no noise rather new battery. starts with jump but will not turn off even removed the key. replaced the power relay. still no start. newer battery.


Did you check the starter motor relay , location , under hood power distribution center ? When you turn the key to start the ignition switch sends a 12 volt input to the PCM / ECM - engine computer . The engine computer will then energize the starter motor relay . This is all computer controlled . Hooking up a scan tool to check for DTC'S - diagnostic trouble codes an viewing input data should be the first in diagnosing a problem like this .
040 Starting System Tests Start Here
048 Engine Hard to Start or No Start Scan Data for Starting Problems
How to voltage drop test starter motor circuit

Starter Voltage Drop



Jun 24, 2017 | 2005 Jeep Liberty

1 Answer

My 2009 Jeep Liberty will turn on but the instrument panel will not?


sounds like lock cylinder is shot
but google jeep liberty forums and post there

Feb 02, 2013 | 2009 Jeep Liberty

1 Answer

2007 jeep liberty suddenly won't start after


Try starting in neutral. Gear sensor may be heating up and not registering park.

Mar 03, 2012 | 2007 Jeep Liberty Sport

2 Answers

I have a 2003 Jeep Liberty with a locked sterring wheel


Turn the wheel while turning the key will unlock the wheel wiggle the wheel while turning the key.

Oct 20, 2009 | 2003 Jeep Liberty

Not finding what you are looking for?
2007 Jeep Liberty Sport Logo

Related Topics:

333 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

79077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...