Question about 2002 Oldsmobile Silhouette

2 Answers

Mechanics told us Hepa Filter to heater was dirty. Can't find where the filter is? Please tell us how to get to it.

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

In the back of the glove compartment there is a door to access 2 filters O'Reillys has them for 26 bucks for both, The first 1 pulls straight out and the second slides from the left

Posted on Dec 29, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 615 Answers

I think you are talking about the cabin filter. On other oldsmobiles you open the hood and access it below the wipers on the passenger side by the firewall.

Posted on Dec 11, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hello I have a 96 Pontiac sunfire with codespo172


PO141 is caused by the O2 heater circuit wiring has a high resistance like an open or short to ground. the heater circuit element in the O2 sensor has an open or short. code PO172 is set when the O2 sense too much fuel is supplied and not burning completely. could be caused by a bad MAF/dirty sensor caused by dirt on the sensor wire or dirty air filter/over oiled filter if you use a K&N filter that requires it to be oiled. fuel pressure is too high causing too much fuel to enter cylinders. even fuel volume can cause this like a dirty injector allowing too much fuel to enter the cylinders. since these codes deal with the O2 sensor replace the sensor as they are a problem then clear codes and drive to see if codes reappear. or if you have a digital volt ohm meter you can test the wiring, check the MAF sensor wire for dirt and clean with intake cleaner.

Sep 03, 2014 | Cars & Trucks

1 Answer

Golf e mk4 is noisey sounds like tappets, but various mechanics reckon that it is hydraulic cylinder shims? car has done 66k and not been looked after, just had it serviced and still noisey. it needs a...


BAD LIFTERS WILL MAKE A NOISE.IF VALVE LIFTERS AND LOWER SPRING SEALS BEEN REPLACED AND LIFTERS STILL NOISEY.EITHER ENGINE OIL TOO THICK OR ENGINE NEED OIL CHANGE + FILTER CHANGE.DIRTY OIL CAUSE LIFTER NOISE OR OIL PASSAGES IN THE CYLINDER HEAD STOPPED UP NOT ALLOWING LIFTERS TO GET THE RIGHT AMOUNT OF OIL.OR OIL PRESSURE TO LOW DUE TO FAULTY OIL PUMP.OIL PRESSURE SHOULD BE 29 PSI @2000 RPM. TRYING ADDING SOME SEAFOAM CLEANER IN CRANK CASE IF OIL PASSAGES STOPPED UP IT WILL CLEAN OUT OIL SLUDGE.GO TO AUTO PARTS STORE TELL THEM YOU NEED SEAFOAM.AFTER 500 MILES YOU NEED TO CHANGE OIL AND FILTER AGAIN. SEE IF THIS HELP BEFORE SPENDING ALOT OF MONEY .

Oct 30, 2010 | Volkswagen Golf Cars & Trucks

1 Answer

How do I replace the HEPA air filter?


??????? hepa filter ? if you are refering to a cabin filter you dont have one 2001 and up have them

Oct 08, 2010 | 1995 Nissan Maxima

2 Answers

I have a problem with my subaru legacy bf it jerks


If it happens under load then it could be a coil pack . If not it may be a blocked fuel filter.

Jul 05, 2009 | 1999 Subaru Legacy

2 Answers

Where is the fuel filter located on a 2003 volkswagen jetta? My car jerks sometimes when i hit the gas...could it be the fuel filter?


If you vehicle is hesitating like it is not getting gas and then takes off like it just got gas then you might want to try replacing your air filter first, because is your air filter is dirty than you might not be getting the oxygen you need to run smooth, this will also give you better gas milage. If it is still doing this than you might want to replace the fuel filter it could also be dirty, you may be getting more than gas at the station. Unless you have the professional tools to remove and replace the filter, you might consider paying a VW place to do it for about $99 that is parts & labor. All auto mechanics are not the same.
Good Luck, mitchell in Houston

Apr 30, 2009 | 2003 Volkswagen Jetta TDI

1 Answer

Hepa filter


Remove the glove box.
Cut the plastic cross brace in the glove box opening with diagonal cutters in the area shown, and discard it.
df0f6a2.jpg Remove the bolts, the screws and the glove box frame.
21177f8.jpg
  1. Remove the filter lid (A) from the evaporator, then pull out the dust and pollen filter (B).
  2. Install the filter in the reverse order of removal. Make sure that there is no air leaking out of the evaporator.
  3. Install the glove box frame and glove box in the reverse order of removal.
443648a.jpg

Feb 13, 2009 | 2005 Honda Accord

2 Answers

Engin light is on


take the vehicle to an autozone they will connect it to the computer and tell you what error code is in there and that will tell you where to start in regards to fixing the problem.

Dec 02, 2008 | 1998 Toyota Corolla

3 Answers

2000 Buick Century Custom 4dr sedan


The cabin air filter for your 2002 Buick Century is located under the cowl in the firewall between the engine compartment and the passenger side of the front seat. To change the filter:
1. Leave the wipers in up position.
2. Open the hood
3. Remove the weather stripping from passenger side of cowl
4. Unclip the window washer line (two or three places)
5. Remove the three fasteners with an ordinary screwdriver (one is easy, the other two were more difficult)
6. Take out the cowel cover
7. Remove old filter
8. Put in new filter
9. Replace cover, fasteners, washer line, and weather stripping.

Do it about every 20,000 km. I left mine for nearly 130,000 km and it was filthy dirty.
New filter costs about $12

Jul 06, 2008 | 2000 Buick Century

Not finding what you are looking for?
2002 Oldsmobile Silhouette Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...