When I put my key in the ignition it will not turn?? how do i change the ignition

Change ignition barrel or get a new key cut try spraying lubricating oil down the barrel

change ignition

you might be able to reprogram the key, but you can only do this if you have two keys, what you need to do is put one key in the ignition turn the ignition on ( not over ) put the key that needs reprogramming into the drivers door and lock the vehicle with the key not the button, wait 10 seconds, remove the key, then press the unlock on the fobb, turn ignition off, remove key from ignition, put in the key that you just unlocked the car with and turn ignition do not turn over, turn off ignition,remove key wait 10 seconds, then put key back in then you should be able to turn it over as normal, if that does not work you will have to take key to be reprogramed at the main dealer...hope this helps

u must put a key to ignition and open a drive door 3 times and press and hold lock button

if you look on column right under switch you will see a small hole, theres the lock pin for the ignition, put key in ignition then with a small nail or pick stick in the hole push in then turn key slow you should feel pick push in the pin continue truning switch until a the dash lights come on and keep pushing in, then pull swith out, take new switch and turn key to same point as old slide in and turn key off, your done hope this helped.

you will but have to change the locks! that is a mechanical problem in the lock!!!

Remove panel under steering wheel. Put key in cylinder and turn back to accessory position. Looking under lower part of steering column locate a small pin under the key cylinder. While depressing the pin turn the key backwards and pull the entire cylinder with key out of column. Good luck.

seem to get a lot of this on these cars on here,try putting a drop of engine oil down the key hole and let it soak in

HAVE IT CHANGED OUT

first make sure the steering wheel isn't in the lock position, putting pressure on the ignition switch. if that is ok, get the key cylinder replaced asap before it quits completely. (harder to change a that point) what condition is the key in? maybe try fresh one.