Question about 1996 Chevrolet Lumina Mini

1 Answer

I have a 1996 chevy lumina sedan with no reverse. Other than replacing the tranny is there any other possible solutions.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 120 Answers

It is possible that your gear indicator is not lined up with the actual transmission. Try the lever in each position to see where each gear really is. You may just be off a notch. If so, you were probably driving around with only 3 out of your 4 forward gears. Good luck

Posted on Dec 06, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 chevy lumina van lock broken and can't gain entrance to end. Any solutions to open or replace a lock?


Does Lumina sedan have rear seat pass thru to trunk ?? if sedan then a pull tab will be in seat upholstery near shelf / by rear window . pull it crawl in with Light Plus friend on outside to hand tools .. IF VAN must remove interior panels to gain access .. Try small thin needle nose pliers to pick broken KEY Piece out of lock 1 ST . if successful spray in Lubricant before trying another key . BUT must be reason lock jammed -- Frozen by weather change or Mechanism Disconnected due to lack of lubrication or worse Plastic Parts used in assembly by Factory .. DRILLING Lock Out will get it Open but new / used parts to repair are now on your shopping list ..

Nov 13, 2014 | 1990 Chevrolet Lumina

1 Answer

I replaced a noisy air conditioning compressor in my 1996 Chevy Lumina sedan, but when I charged the AC Compressor, but the charge doesn't hold. How do I find and fix this problem?


YOU NEED A LEAK DETECTOR , SOME PARTS STORES , RENT THEM , MAKE SURE YOU CHECK VALVE WHERE YOU PUT THE FREON IN THEY LEAK A LOT AND FITTINGS

Jan 18, 2011 | 1996 Chevrolet Lumina Mini

1 Answer

1996 Chevy Lumina temperature gauge rising


the drop- electric fan is coming on to cool the overheat- the heat- sounds like thermostat is bad-replace

May 21, 2010 | 1996 Chevrolet Lumina Mini

2 Answers

1996 Chevy Lumina Sedan Whining noise from engine


The pattern you describe is consistent with an alternator going bad. Maybe the fields are already rubbing together. Test it this way: Start the car and leave on idle, when the whine is worse, then start using up electricity, by increasing the demand. Turn on AC, then lights, then full blower and then high beams. If there is a change in the whine, then either alternator or voltage regulator is the culprit. When a compressor pulley bearing is bad, noise shifts just by turning AC on and off.

Jan 02, 2010 | 1995 Chevrolet Lumina

1 Answer

Replacing driver's side mirror on a 1994 Chevy Lumina sedan


There are screws that hold the door panel on. They are typically located behind the small round plastic covers. If you look at the bottom of the door handle, you will see them. Also on the door lever, there might be a screw. After removing all of the screws, take a flat head screw driver, and gently pry up the panel. There are plastic clips that hold the panel securely to the door. Doing this will pop them out one at a time. Once the door panel is loose, lift it up, and it should come right out. Be sure to disconnect any wiring harness connectors before fully removing.

Mar 24, 2009 | 1991 Chevrolet Lumina

1 Answer

1996 chevy lumina 3.4. service engine light on


You will need to replace the valve body in the transmission.

Mar 01, 2009 | 1996 Chevrolet Lumina Mini

1 Answer

My name shawn


It means the engine mounts and tranny mounts are shot replace them and it will stop! Also your idle might be too high due to a TPS sensor malfunction.

Nov 10, 2008 | 1996 Ford Taurus

Not finding what you are looking for?
1996 Chevrolet Lumina Mini Logo

Related Topics:

225 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...