Question about 1996 Chevrolet C2500

1 Answer

Truck only starts when I pour gas into the throtle body carborator . It runs for about 30 seconds, I can see the fule injectors spraying gas until it stops.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 75 Answers

If you don't hear a fuel pump running look there first. Gray wire powers pump

Posted on Nov 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1985 grand Marquis acts like not getting fuel to start but if I pour gas directly into throttle body starts right up and runs what could be problem


Runs on the gas you pour in, or keeps running until you turn the key off ???
If the fuel pump relay fails, you would have to crank the engine until you get oil pressure to provide power to the fuel pump.
Do the injectors spray when you are cranking it ? Have you checked fuel pressure when the key is turned to start ?

Jul 11, 2012 | Cars & Trucks

1 Answer

Cleaning throttle plate and MAF sonsor


TO clean the throtle plate use a small tooth brush and some throtle body cleaner. remove the intake hose, spray the throtlebody and then open the throtle plate and spray plate , use brush to clean body and plate then spray clean try not to spray to much into engine , after its clean then start the engine you may have to hold gas pedal down to start as it going to be a little load up with fuel from the cleaner, some time sit will start up on its on and run a little rough for a few seconds and clear up. As far as the mass sensor this needs to be cleaned with mass air flow cleaner, this is a spray like the throtle spray but is made for that sensor and drys fast, spray the two sensors inside but dont touch them or move them spray as close to them as you can to clean them, good luck.

Mar 18, 2011 | Buick Regal Cars & Trucks

3 Answers

Our truck willn not start


Maybe your fuel pressure regulator valve!

Jan 16, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

1988 nissan pickup engine rotates but does'nt start.


it sounds like the injectors are not opening up man.. replace the injectores and this should fix your problem..good luck keith....

Mar 21, 2009 | 1987 Nissan Pickup

1 Answer

S10 has very high idle when cold and sticks to the gas when warm


you need to replace the throtle body controll sensor. Also you may want to make sure all your linkage from the pedal to the throtle body is cleaned and lubed correctly. While playing in this direct area. Your throtle body is only 4 bolts away. Why not get some carb cleaner and get to know your truck just a litle more.

If this is a carborator, then you need to turn my warmup idle down. there are 2 sets of idles on carborators. the one to warm up the engine, automatic choke or pin settings. Get a Chilton, find out which idles pin is for what. and play a litle bit.

I think you have a throtle body so I would also check the automatic air intake sensor. It could be going bad. Check your filter and make sure its clean.

hope all this helps.

tepfy

Feb 27, 2009 | 1992 Chevrolet S-10 Blazer

1 Answer

Truck will crank but not start


Try checking all the fuses with a test light may be a blown injector fuse.

Feb 10, 2009 | 1999 Chevrolet S-10 Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...