Which wiers go on which terminals for a 1995 saturn SL2 starter

https://www.youtube.com/watch?v=j6Wntha7ft8

Ignition module !

CAR STARTER REMOVAL? TESTING

One Wire From Starter Motor Goes To Solenoid And Other Goes To BATTERY. Starter GETS 12 VOLT SUPPLY FROM BATTERY AND WITH THESE VOLTAGE IT TURNS THE MOTOR AND THIS TRIGGERS THE STARTER SOLENOID AND YOUR VEHICLE RUNS.============

For your help there are few relatively help links showing how to remove and install starter with proper instructions:-----

These help links will help.

Click the link below:-----

How to test starter solenoid? http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html -------------------- How to test cars starter? http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html ----------- How to replace starter in car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-starter-in-car.html

-----------
How to replace Starter on Infiniti Q45? http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-starter-on-infiniti-q45.html

----------
2006 GM Montana: How to replace Starter Solenoid?

http://repairhelpcenter.blogspot.in/2012/06/2006-gm-montana-how-to-replace-starter.html

-----
Saturn SL2: How to replace Starter Motor?

http://howtobyme.blogspot.in/2012/06/saturn-sl2-how-to-replace-starter-motor.html

--------

Saturn SL2 Starter Wiring Diagram?

http://schematicsdiagram.blogspot.in/2012/06/saturn-sl2-starter-wiring-diagram.html

----------

• Oldsmobile starter solenoid replacement procedure?...

--------------------

• How to replace Oldsmobile starter moor?

----------

• Oldsmobile starter motor testing?

-------------

Oldsmobile STARTER MOTOR NOISE DIAGNOSIS?

------------

These details will help.

Thanks.

Bad ground will do that. Check battery terminal first, then the second place to check is grounds on the side of the motor where transmission bolts are. Then the starter itself can be corroded right where it lays against the motor, where it is bolted on. This can happen due to too much oil running down on it as well. Last of all the starter can be bad. It is best to have it diagnosised first before guessing at any repairs though.

to the back of your engine is the old starter.. Unbolt it (remember where the bolts are.. 2 the side of it.. Remove wires and connect it to new one.. Bolt starter back up..

You left off or broke one of the feed wires that are hooked directly to the battery terminal on the starter.Good Luck!

Could be a starter failing, but more likely a faulty negative battery cable or starter cable connection. Look for corrosion or looseness at the cables. On GM starters, corrosion on solenoid terminals on the starter can often cause these symptoms. On most vehicles over 10 yrs. old, replacing the neg. batt. cable will save many headaches.

It would be hard to guess but a simple diagnostic would be to use a 12v test light and see if the starter solenoid recieves a 12 v signal while turning the key. If it lights, the starter should turn over. This also gives you the oportunity to check and verify all electrical connections at the starter including the large orange fusible link wire at the large battery terminal.

Fuse box inside car front of console.Burnt terminal in front 68way connector,you will most likey need a used fus box,terminal will be o.k.hope this helps

Are all wires connected? There should be a fusable link that goes from the alternator to the larger terminal on the starter then a red cable that goes from the larger terminal starter to the battery.

A smaller gauge purple wire connects to the smaller terminal on the starter. This is for ignition.