Question about 2006 Nissan Quest

Open Question

Interior lights on 2004 quest not working at all. Fuses okay. Suggestions?

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 30 Answers

SOURCE: all interior dome light are

The interior light are controlled by the Body Control Module (BCM).
Check the fuse for the BCM. If the fuse is OK, then try to disconnect the car battery for about 10 minutes to reset the BCM. If resetting the BCM doesn't work you may have to replaced it.

Posted on Jun 23, 2011

Ad
  • 4 Answers

SOURCE: Dash lighting, clock,interior lights don't work.

check the room fuse under the hood... should illuminate all those things you have listed..

Posted on Jul 14, 2009

  • 1 Answer

SOURCE: 2005 chevy suburban- my back-up lights and

you bcm (body control module is bad) to have the dealer replace it will run you about $400. a quick fix for the reverse light is to splice 2 wires into the wire for the center plug in your trailer wiring. now run a wire up to each reverse light, cut the green wire to each reverse light and **** conect them up. this is a seperate revers feed than the one from the bcm. the dome lights remove the light cover on the second set of interior lights (the one between the drivers seats). the two side bulbs are map lights the center bulb is for the dome lights. run a jumper wire from the right or leftside socket to the center socket. you dome lights will now turn on with just the use of that switch i replaced the back bulbs with led's soo there is no extra amp's being drawn. you could bypass the bcm but i could not find any wiring diagrams for it and i dont know if it can take the added amp's

Posted on Sep 06, 2010

johnk950
  • 115 Answers

SOURCE: Low Beam headlights not working.

Possible relay fault,also a burnt dimmer switch will cause this symptom

Posted on Sep 06, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why no power from battery to anything on my Nissan Quest?


There are large fuses to protect the major circuits. Are you sure the cable connections are clean and tight ? Have you checked the major fuses for power, and the ground connection ?

Jul 27, 2014 | 1997 Nissan Quest

1 Answer

My daughter has a 2008 Kia Optima. It was purchased in excellent condition from Enterprise in 2009. It has been great until recently, when the key fob, door locks, interior lights and clock just stopped...


Is there an option to change interior light settings through a menu or specific buttona? Call the dealer and speak to the service adviser for support.

Nov 16, 2013 | 2008 Kia Optima

1 Answer

Audi A4 2004 interior lights not working


Lights may be turned off at the fixtures

Jun 27, 2017 | 2004 Audi A4

1 Answer

All interior dome light are out on 2004 quest, fuse checked are good


The interior light are controlled by the Body Control Module (BCM).
Check the fuse for the BCM. If the fuse is OK, then try to disconnect the car battery for about 10 minutes to reset the BCM. If resetting the BCM doesn't work you may have to replaced it.

Jun 23, 2011 | 2004 Nissan Quest

1 Answer

Interior lights not working


Check the fuses and bulb. One of them is likely to be blown

Oct 19, 2010 | 2004 Nissan Quest

1 Answer

I have a 2002 Freelander 2.5 SE automatic V6. All the interior lights are working apart from the centre console lights. The fuel, temperature, rev counter and speedo are all working. The heated rear screen...


The internal panel lights work off the left hand side of the side lights and are protected by the 10 amp fuse for this side. I had replaced both stop and tail lights with a heavy duty bulbs and because the left hand side powers the panel lights as well, obviously it was too much for the circuit. The right hand side was okay.

Oct 30, 2009 | 2002 Land Rover Freelander

1 Answer

Personal Lights in a 2004 Nissan Quest won't turn on


have the courtesy light circuit tested, u may have a sticking switch..

Jun 03, 2009 | 2004 Nissan Quest

Not finding what you are looking for?
2006 Nissan Quest Logo

Related Topics:

892 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

79851 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...