Question about 1997 Chevrolet Cavalier

1 Answer

Where is the coolant bleeder valve on a 1997 chevy cavalier

Posted by on

  • yadayada
    yadayada May 11, 2010

    what engine do u have?



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert that hasĀ over 500 points.


    An expert who has answered 200 questions.

  • Expert
  • 226 Answers

Drivers side engine compartment remove the air duct and it should be right near the engine close to the thermostat .

Posted on Nov 19, 2009


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 2431 Answers

SOURCE: I have a 1997 Chevy

You can bleed it where the brake hose is connected to the caliper that will work

Posted on Jun 16, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 1997 chevy cavalier. I replaced wheel cylinders, brake lines, front calibers master cylinder and booster. When I bleed the brakes I only get brake fluid from the front bleeder on the ABS system. I...

sometimes if you leave the bleeder screw open it will gravity bleed the cylinder.Make sure master cyl is full and do one wheel at a time.I have seen this work, I have done it.

Nov 16, 2010 | 1997 Chevrolet Cavalier

1 Answer

Car overheating

A heater line tube with valve

Jan 22, 2010 | 1999 Chevrolet Cavalier

1 Answer

1999 cavalier overheating new water pump thermostat new belt new belt tensioner

There a bleeder valve running alone the front on motor on a tube, with engine off open bleeder valve till no more air come's out, add coolant while it's open, then close, and recheck.

Dec 13, 2009 | 1999 Chevrolet Cavalier

1 Answer

Have a 1997 Cavalier that the cooling fan will not

You may have air in the cooling system. You should have a bleeder screw on the thermostat housing or heater tube depending on what engine is in it. With vehicle off and engine cool, open bleeder screw and fill radiator with coolant until steady stream of coolant comes out of bleeder screw. If this does not work proceed with computer diag for a faulty sensor or ecm.

Nov 24, 2009 | 1997 Chevrolet Cavalier

1 Answer

I have a 1997 Chevy Cavalier 2.2 Engine. After changing my IAC Valve, TPS, Thermostat, my coolant light still stays on. Car doesn't overheat.

If the coolant level is o/k check level indicator sensor which should be on the rad. It is a one wire sensor. Hope this helps. Moe

Apr 29, 2009 | 1997 Chevrolet Cavalier

1 Answer


  1. Negative battery cable.
  2. Raise and support vehicle.
  3. Coolant fan mounting bolt.
  4. Electrical connector from coolant fan.
  5. Coolant fan assembly out through the bottom.
  1. Coolant fan assembly in through the bottom.
  2. Electrical connector to coolant fan.
  3. Coolant fan mounting bolt. Tighten bolt to 6 Nm (53 inch lbs.) .
  4. Lower vehicle.
  5. Negative battery cable.
will need email address to send image

Jun 01, 2008 | 1997 Chevrolet Cavalier

Not finding what you are looking for?
1997 Chevrolet Cavalier Logo

268 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides