Question about 1999 Jeep Cherokee

1 Answer

Rear windshield wipers stoped working.

My rear windshield wipers stoped working. I want to check to see if its a bad fuse. Where do I find the fuse box and what number is it?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,985 Answers

If you check in your owners manual it will show you where to find the location of fuse boxes and which fuse does what,but you test them with a test light and the key on.

Posted on Nov 25, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WHERE IS THE WIPER/WASHER FUSE LOCATED ON 2007 PONTIAC TORRENT


In the under hood fuse box , should have diagram inside the lid . Front wiper's or rear ? Front fuse # 36 - 25 amp. Plus Two relay's PCB hi and Wiper PCB relay . Wouldn't think this being fuse problem . Wiper switch , motor etc... The wiper's are control by a computer . BCM - body control module .

The windshield wiper/washer system consists of front and rear wipers. The front and rear wipers are operative when the vehicle is in accessory or run. The front wipers have 4 different modes: Mist, Intermittent, Low, and High. When the front wipers are in the intermittent mode, there are 5 delay modes to chose from, commanded by the windshield wiper washer switch through the body control module (BCM). The rear wipers has an only one mode.

If the fuse is bad , could have a short to ground or wiper motor pulling to much current (amps) . Fuse's don't just blow for no reason ! Could also have DTC'S - diagnostic trouble codes stored in the BCM .
DTC B3715
DTC B3873
DTC B3875
DTC B3922

DTC B3715 02: Front Wiper Relay Drive Circuit Short to Ground
The body control module (BCM) controls the wiper motor based on input from the windshield wiper washer switch. The BCM monitors the wiper washer switch through three separate signal circuits and a ground circuit. The windshield wiper switch high signal circuit is used to determine high speed wiper operation, the windshield wiper switch low signal is used to determine low speed, intermittent, and mist operation through the use of a resistor ladder, and windshield washer switch signal circuit is used to determine washer operation.
The BCM controls the windshield wiper motor through two output controls, controlling two different PCB relays which control the desired wiper speed, high or low.
DTC B3922 00: Front Wiper Function Select Circuit

The PCB relay's are non- servicable , replace fuse box . Soldered in Your best bet mit be to take it to a qualified repair shop .

Feb 20, 2017 | Pontiac Cars & Trucks

1 Answer

2005 mercury mountaineer windshield wipers stopped working in the middle of the windshield. ..the rear windshield wiper works though


That really sounds like a fuse blew for the wipers.
Check your owners manual for fuse box location.
Please let me know if this helps

Mar 06, 2015 | 2005 Mercury Mountaineer

2 Answers

Back windshield wiper won't turn on


The rear wiper has a dedicated fuse. It's the 10A R/WIPER fuse in the relay block. This supplies power to the rear wiper and washer switch and the rear wiper control unit. That unit also gets power from the 20A AUDIO (!) fuse in the engine room fuse box. If the fuses are OK, the ignition switch is in the ON position, and the rear wiper and washer switch is turned on the rear wiper should work. If not check all the components described to find where the loss of power is occurring

Nov 15, 2012 | 2005 Kia Sorento

2 Answers

Windsheild wipers just quit working,and i cant find any fuses for this.where is it?


There is a 30 amp (pink) fuse located in the fuse box located inside the car (see picture below) and it is in the number 11 position in that box. That fuse is for the wiper system there is also a hi/low wiper relay located in the power distribution box located in the engine compartment. It is in the number 1 position (the big number 1 not the diode or fuse). You may want to check that out as well if the fuse is good. The picture for that is also below. I hope this helped and good luck.




clifford224_34.gifclifford224_35.gif

Mar 07, 2011 | 1997 Ford F150 Regular Cab

2 Answers

Windshield wipers will not shut off. what is the problem. i also pulled every fuse that said something about the wipers and they still run. what fuse number is it.


My fuse # is 19 and it's under the back seat. Also, I fixed my constantly on wipers by replacing the entire wiper motor. I believe that the actual problem is the module but that item does not come alone and one must purchase the entire motor. The dealer priced me at $150 but I got one at Autozone for $100 with a $30 refund once I returned the old one (core), so total price was $70.
Hope this helps.....

Feb 02, 2011 | 2006 Chevrolet Trailblazer

1 Answer

Windshield wipers stoped working i think it is a fuse. edkk@verizon.net


COULD BE FUSE.IF FUSE GOOD.CHECK TO SEE IF POWER GOING TO WIPER MOTOR.IF YES.REMOVE WIPER MOTOR HOT WIRE IT USING JUMPER WIRES TO CAR BATTERY.IF WIPER DONT WORK IF HOT WIRED.WIPER MOTOR IS BAD.IF WIPER MOTOR WORKS HOT WIRED.YOUR WIPER LINKAGES BINDING. NEED LUBRICATING OR REPAIRED.

Apr 18, 2010 | 2005 Acura TL

1 Answer

Rear windshield wiper stopped working, 4x4 dosent


sounds like a lot of fuse's blown or the fuse box it's self has a fault

Dec 24, 2009 | 2004 GMC Envoy

1 Answer

My windshield wipers stoped working , are they fused ans where the fuse located


Yes they are fused and the fuse is under the dashboard in the box. If all fuses are fine, I would check the wiper motor as they do burn after some years.Also connection might be loose.

Oct 31, 2009 | 1997 Mazda Protege

1 Answer

Windshield wipers


From your owners manual:

Fuse#11 30A , Wiper Run/Park
Relay, Wiper Hi/LO Relay, Windshield Wiper
Motor, Rear Washer Pump Relay

U will also need to check the relays if the fuse is ok, the relay, it is the underhood fuse box
Relay #202 — Front Wiper Run/Park Relay

Dec 18, 2008 | 2001 Lincoln Navigator

Not finding what you are looking for?
1999 Jeep Cherokee Logo

283 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...