Question about 1996 Chevrolet S-10 Pickup

1 Answer

My gaz pump not run before start engine - 1996 Chevrolet S-10 Pickup

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 546 Answers

If you can't hear the pump running with your ear at the filler tube, with the cap removed, when the key is turned to 'on' [not 'start'] but it starts & runs,the fuel system is 'holding' adequate pressure while turned off.If it starts,but doesn't want to run,replace fuel filter/check fuel line for damage or restriction.

Posted on Nov 19, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

95 chevy baretta ran out of gas now wont restart with plenty of gaz


You need to check if the fuel pump (in the gas tank) is still turning on to put gas up to the engine. It's been known to happen that running out of gas can burn out the fuel pump. Manufacturers put the pump in the tank so the surrounding gas will keep the pump running cool.

Oct 15, 2014 | Cars & Trucks

2 Answers

Why did my 2005 nissan altima, which had half tank of gas not start until I put in 9 gallons more, and then it started. What is wrong?


the tank came from a wreck car gaz pump is at the end off small pipe ,pipe had bent and pump is ouside of gaz Inside the tank, it happen to me

Aug 14, 2014 | 2005 Nissan Altima

1 Answer

Car Montero 2004 3.0L '' Pajero '' was running ok, i stopped it for 1hr, then i tried to start the engine, it wouldnt start but when i push the gaz it will start, but the problem is that there is a very...


you may be running lean or through a rod and the the knock sensor is retarding the timing so much the engine will not run. check fuel pressure. or you have a huge vac leak. look for p0300 code ( random multib

Feb 16, 2014 | Mitsubishi Montero Sport Cars & Trucks

1 Answer

ABS, BATTERY,GAZ LIGHTS WENT ON


no I am not there.. you need to put gas in.. charge the battery and try to start the car..after it charges a few hours..

Jan 02, 2014 | 1999 Chevrolet Venture

1 Answer

Gmc savana gaz gauge dead but pump work


check all wire connections for water / moisture problems as it is stopping the current from activating all the electrical items

Nov 10, 2013 | GMC Savana Cars & Trucks

1 Answer

I have a 2003 Pontiac Grand am and the chage oil light is on we changed the oil but we have no manual to read out to turn the light off


put the switch on but dont start, and push 3 time the gaz pedal to the floor, close the switch and start the engine.if not working do the same switch on 3time pedal gaz to the floor and start the engine.

Nov 14, 2010 | Pontiac Grand Am Cars & Trucks

1 Answer

Where is the fuel filter located on a 2003 envoy SLT


with the injection the gaz filter is in the gaz tang with the gaz pump.

Nov 14, 2010 | 2003 GMC Envoy

2 Answers

Installed new fuel pump car still won;t start


Check Filter inside Carb.. Also Under Beside the Gaz Tank ..Check unplug Gaz line beside Carb and start ..See if gaz came.. if yes
check filter inside Carb....Check wile pressing gaz pedal see if gaz spay . Make Shure The Primer Work Find.. Then Chek For Vaccum lost Vaccum Are Important For System Performance.. Some Logic Board work with Vaccum Exemple Boddy Trothle.. Electric Choke... Cruse Control Idle Control and Distributor Advance..
Good Luck

Oct 06, 2010 | Honda Accord Cars & Trucks

2 Answers

I have a 96 Chrysler Cirrus that runs perfectly until the engine gets warm. I've replaced the plugs, wires, distributor, cap, fuel pump, crank sensor, heat sensor, ignition module. When the car throws a...


faulty computer
faulty wiring
excessive carbon in combustion chamber, when hot, pre-ignition occurs. try using high octane gasoline first, but wait until empty, before filling up. it will take some time before the new gaz gets to the engine as the gaz lines and pump still have the old gaz.

another possibillity is water in the gaz tank.
when cold the gaz enrichment might compensate .


Jul 19, 2009 | 1996 Chrysler Cirrus

1 Answer

S10 pickup - engine won't start


when you put the kee on do you ear the gaz pump going if no get somebody to crank the the engine take a hammer and it the gaz tank most of the time the pump gonna kick in but get it check out you may have dirt from the fill up or simply change the gaz pump

Jun 20, 2008 | 1996 Chevrolet S-10 Pickup

Not finding what you are looking for?
1996 Chevrolet S-10 Pickup Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...