Question about 2001 Mitsubishi Galant
First disconnect the battery. Next remove the flat, angular heat shield from the starter itself (1x 8mm nut and 2x 8mm bolts). Do NOT try to remove the heat shield from the Exhaust pipe - it can't be removed with the starter in place and it's not necessary anyway. Next remove the oil filter. You'll loose a few ounces of oil so be prepared for that with a drain pan and either cover the removed filter to keep debris out or replace it and remember to check the oil level later. Remove the small signal wire from the solenoid (released by pushing in a tiny lever with a finger tip) and also remove the 12mm nut attaching the positive battery cable to the starter.
The starter is held in place by two 14mm bolts. On the engine (passenger) side, there is a 14x30mm bolt threading into the transaxle from the bottom of the starter. On the transaxle (driver) side, there is a longer 14x50mm bolt threading into the top of the starter.
Posted on Nov 18, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
dont know exsacly where is but should be where gear box meets engine and it sounds like the soliniod is stuck or gone or starter could be stuck in engine if manual put in gear and rock back and forward this may help relase it
Posted on Jun 06, 2009
Check your motor mounts, recently engine idled rough when in nuetral or stopped in drive, also jerked when put in reverse. took it to a automotive shop and found motor mounts cracked. Runs great now
Posted on Nov 13, 2009
SOURCE: P 0705 transmission range sensor
P0705 - Transmission Range Sensor Malfunction. The park/neutral position (PNP) switch includes a transmission range switch. The transmission range switch detects the selector lever position when the shift lever is in the N or P shift position and sends a signal to the Transmission Control Module (TCM). The possible causes of this are the following: Open or short park/neutral position switch circuit. Poor park/neutral position switch circuit connection. Misadjusted park/neutral position switch. Park/neutral position switch may be faulty. Inspect the pnp switch and replace if needed.
Posted on Jan 15, 2011
Tips for a great answer:
Apr 10, 2013 | 2001 Mitsubishi Galant
Oct 15, 2011 | 2001 Mitsubishi Galant
Mar 26, 2010 | 2001 Mitsubishi Galant
Jan 14, 2010 | 2001 Mitsubishi Galant
Dec 29, 2009 | 2001 Mitsubishi Galant
Dec 10, 2009 | 1995 Chrysler LHS
Oct 24, 2009 | 2001 Mitsubishi Galant
Jun 01, 2009 | 2001 Mitsubishi Galant
Mar 14, 2009 | 2001 Mitsubishi Galant
Nov 13, 2008 | 2001 Mitsubishi Galant
830 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: