Question about 2000 Hyundai Elantra

2 Answers

How do I remove tranny and clutch seems stuck on the engine 2000 hundai elantra manuel I can get it off about a half inch and it stops

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

How does one install rhe fork on the throw out bearing? Does it go on the face or between the 2 tabs?

Posted on Oct 06, 2011

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 149 Answers

The clutch is a pull type, not a push type, to remove the trans you have to remove the release fork lever, to do that fist remove the clutch slave cylinder, then remove the 14mm nut tha holds the fork arm, then you can remove the trans, however reassembly is a whole nother complicated story.

Posted on Nov 19, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does the trac off light on a hundai elantramean


Your car has disabled the traction control for some reason. Common reasons include

-tires spinning on ice or snow
-slipping clutch or transmission
-misfiring engine
-car is grumpy

Traction control is sort of the opposite of antilock brakes. When you push on the gas, it cuts back power to the wheels if they lose their grip.

Feb 19, 2015 | 2000 Hyundai Elantra GLS

1 Answer

How do I safely remove the diver's side rear door panel on a 2010 Hundai Elantra wihout damaging?


Using an engine puller (hydraulic crane) lift slightly on the door. Remove bolts and wire connectors. Door is now hanging on the engine puller hoist.

Aug 16, 2013 | 2010 Hyundai Elantra Touring

1 Answer

Hundai elantra touring 2012 over heats while sitting in idle


im assuming its an 2001 but ur question says 2012... the cooling fan prolly isnt coming on and if it is...then ur thermostat is stuck closed. does the gauge read hot or do u just notice the engine overheat?

Mar 24, 2012 | 2001 Hyundai Elantra

1 Answer

2000 hundai , no fuel to filter / engine


there is a relay in the engine compartment relay fuse box should be labeled pull it out look at the relay and jump the same wire the number 30 and 87 on the relay then try and start car. if it don't work check for power there if no power move to the fuse in same compartment.if there is power the installation could be wrong. make sure the ground is properly connected to the frame/body/sending unit.

Jul 13, 2010 | 2000 Hyundai Elantra

1 Answer

Has the hundai elantra 2000 have a timing belt or a chain


The 2000 Elantra has a timing belt, not a chain.

Mar 23, 2010 | 2000 Hyundai Elantra

1 Answer

I am replacing the clutch disc on a 2000 hyundai elantra. the is a c-type clip holding the throw out bearing to the pressure plate, i can't get the engine separated from the transmission. i understand the...


the clutch fork must be binding up on the input shaft!
release the fork from its pivot point!
[ i hope you removed or slackend off the fork adjuster & dont forget to readjust it when its all back together!

Jul 20, 2009 | 2000 Hyundai Elantra

1 Answer

2000 elantra 5 speed manual tranny will not come out!


dear friend-take the slave cylinder of as this is a pull tipe clutch.box should come out then.

Jun 30, 2009 | 2000 Hyundai Elantra

1 Answer

Tranny swap


No. Engine and Computer would be lacking connections and linkages needed to operate normally. Tranny swap haundai?

May 11, 2009 | 2000 Hyundai Elantra

Not finding what you are looking for?
2000 Hyundai Elantra Logo

240 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...