Question about 1996 Honda Civic

1 Answer

How do you change fuel filter on 1996 honda civic

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Honda Master
  • 1,149 Answers

Hi:
The fuel filter is mounted to the back wall of the engine compartment, next to the battery. It has a metal strap with a 10mm bolt holding it tight. First step is to depressurize the fuel system, or you can wrap a rag aroun the fittings and break them free before loosening the filter mount strap. Replace the copper seal rings when you move the fuel lines over to the new filter. tighten everything up, turn on the ignition,and check for leakss visually.

Posted on Nov 18, 2009

Testimonial: "this info. was very helpfull thank you"

  • atp86qru1 Dec 17, 2011

    I will try that solution by Ichand 1958. Do the copper ring seals come with the fuel filter??

  • Larry Chandler Dec 17, 2011

    Most new fuel filters come with the copper ring seals, but just open the filter you buy, before you leave the store to see that they are included with yours?

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Brian032472
  • 150 Answers

SOURCE: How to change the HEPA cabin filter in a 2006 Honda Civic

Open the glove box and there are push out tabs on the left and right side pop them out. Now watch it because you are about to dump the contents of your glove box on the floor. let the box hang freely from the lower hinge and look in the back. You will see a white panel that pulls out the panel has a tray attached with the filter element in it remove old element and replace with new 20ish bucks at the parts store lots more at the dealer. re-install filter tray and reverse your removal steps to re-install. Recommended approx 15k or annually

Posted on Nov 04, 2008

fknstart
  • 404 Answers

SOURCE: Replace fuel filter on 2004 Honda Civic

it come with a filter as one unit

Posted on Jan 06, 2009

blueextc3221
  • 15935 Answers

SOURCE: How to change upper control arm on 1996 Honda Civic DX ?

UPPER CONTROL ARM:

Do not disassemble the upper arm. If the ball joint or bushings are faulty, or the upper arm is damaged, the entire upper arm must be replaced.

  1. Raise and support the vehicle safely.
  2. Remove the front wheels. Support the lower control arm assembly with a floor jack.
  3. Separate the upper ball joint from the steering knuckle using a ball joint separator tool.
  4. Remove the self-locking nuts from the upper arm anchor bolts. Remove the upper arm from the vehicle.

Do not disassemble the upper arm. If the ball joint or bushings are faulty, or the upper arm is damaged, the entire upper arm must be replaced.
To install:
Use new self-locking nuts when installing the upper arm and strut.
  1. Install the upper control arm assembly into the strut tower.
  2. Connect the upper ball joint.
  3. Install the front wheels and lower the vehicle.
  4. With all four of the vehicle's wheels on the ground, torque the upper control arm nuts to 47 ft. lbs. (65 Nm). Torque the castle nut to 32 ft. lbs. (44 Nm); then, only tighten it enough to install a new cotter pin.
  5. Tighten the wheel nuts to 80 ft. lbs. (110 Nm).
  6. Check and adjust the vehicle's front end alignment.
The bushings on the front lower control arms are replaceable on most models.
This procedure requires the use of a press and may be above the skill range of the average driveway enthusiast. It is recommended that this procedure be done by a qualified machine shop if you are not skilled in the proper use of a press.
  1. Remove the lower control arm that is in need of new bushings.
It is recommended that both the left and right lower control arm bushings be replaced at the same time. The vehicles handling may become unstable if there are new bushings on one side of the car and worn ones on the other.
  1. Set up the control arm in a press.
  2. Using a impact socket of the correct length and size, press out the old bushing.
  3. Install the new bushing by slowly using the press to push it into the control arm.
  4. WARNINGExcessive force could cause the bushing to bend or tear so be careful.
  5. Once the bushing is properly seated in the control arm, remove the arm from the press and install it on the vehicle.

Posted on Apr 05, 2009

lemmingleejn
  • 173 Answers

SOURCE: oil filter in civic 97

If you go to a reputable motor factor,
you can only be sold the correct filter for the civic.
As there are soo many variables in engine type, it's almost impossible to tell, oil volume, or which type filter.
However, I will say, be sure that you don't mix semi-synthetic oil, and mineral oil.
Oil changes should be undertaken every 30,000 miles, (unless under extra work load, (in which case, slightly more regularly))

Otherwise, 10/40 or 15/40 grade oil, is perfectly fine.
The trick to not overfilling the oil, is simply just to take your time, clean the dip stick and retry, until you have the correct reading.

Please don't forget to rate:)

Posted on Jul 29, 2009

  • 1214 Answers

SOURCE: How often do I replace the fuel filter?

Fuel filters should be replaced when you feel that it needs to be changed, although many manufacturers claim their filter is good for the life of the car.
It really depends on how clean the gas has is that has been in the car.

Posted on Dec 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

96 HONDA CIVIC WILL NOT GO OVER 300 RPM


Check the fuel pressure. It could be that the fuel pump is going bad and starving the engine for fuel. Also check the fuel filter.

Apr 22, 2014 | 1996 Honda Civic

2 Answers

Where is fuel filter relay on 96 honda ferio


Not familiar with Honda Civics but I have never seen a relay or any other electrical component hooked to a fuel filter. The one for the fuel pump should be in the fuse panel normally under the hood. Usually identified on the cover or owners manual

Apr 04, 2014 | 1996 Honda Civic

1 Answer

I need directions to change the fuel filter on my 2006 Honda Civic Hybrid


No filter is used.
Last year for a fuel filter was 2001.

Oct 18, 2010 | 2004 Honda Civic

1 Answer

Dear I want to know what the best kind of engine oil for honda civic 1996 climate: lebanon Middle east


the cheapest and change it every 6000kms with a oil filter every third oil change

Sep 23, 2010 | 1996 Honda Civic

1 Answer

How to change fuel filter on 1996 Honda Civic


It is located Under hood, center, upper firewall, mounted in fuel line (basically back of dash). Take note of how it is mounted not to install backwards. Unhook battery ground. Unhook two fuel lines one on top one on bottom of filter.Mark fuel lines top/bottom tape helps not to get mixed up. Remove from clamp. place new filter in clamp noting proper top and bottom. replace fuel lines. reattach battery, cycle key on and off 3 times slowly. (when you turn key foreward you will hear pump kick on. when stops turn off. Do again 2 more times then start.

Jan 27, 2010 | 1996 Honda Civic

1 Answer

How to change fuel filter for honda civic 2001


It's been a while...I would look it up in 'images' you should find some pics -- Another source is the forums, just punch in 'fuel filter for honda civic 2001'

Dec 10, 2009 | 2001 Honda Civic

1 Answer

Honda civic 96 will not start have check all electrical and pump


check the oil and make sure it's NOT black, Check air filter, oil filter, and gas filter, check engine fuse, see if spark plugs are ok, check starter, check alternator and belt. if problem still persists please contact me at jhowe67@yahoo.com

Jun 24, 2009 | 1996 Honda Civic

1 Answer

HONDA CIVIC 1996 PULSING IDLE


It might be bad gas or a plugged filter or it might be a bad mass airflow sensor.

May 03, 2009 | 1996 Honda Civic

1 Answer

How to change a Civic Fuel Filter:Safely?


the fuel filter on this vehicle is going to be on the firewall just under the windshield. it will have 2 or 3 hoses connected into it, and should be connected to the mount with a hose clamp.

Jan 20, 2009 | 1988 Honda Civic 2 Door

1 Answer

1991 Honda Civic


12vot relay under dash behind change left hand side

Sep 04, 2008 | 1991 Honda Civic

Not finding what you are looking for?
1996 Honda Civic Logo

Related Topics:

1,253 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...