Question about 2009 Ford Fusion

1 Answer

How do I fit the jack in with the spare tire on 2009 ford fusion?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 323 Answers

The same way it came out, it should lay inside the rim with a bolt coming through the center hole of the rim
the bolt should hook to the floor of the trunk

Posted on Jan 16, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why won't my car start ford fusion 2009 wont start after hitting a curb and blew my tires out


the inertia switch may have been tripped due to the impact of hitting the curb and blowing out tire. blame ford for this design because in the past they manufactured cars that would blow up during collisions. so all ford vehicle now come with a intertia switch to shut off fuel when it senses extreme impact. all you have to do is flip the switch and your car should start and run again. its a pain. look for location of switch in owners manual.

Aug 28, 2014 | 2009 Ford Fusion SE

2 Answers

My Ford Fusion 2009 Shows Tier pressure sensor fault. So what is the solution please.


tyre pressure sensor is another gimmick and i would just ignore it and put a bit of black tape over the light .only the dealer can sort this out for you because as its a 2009 then its all encrypterd software on a europeon market vehicle

Jun 05, 2011 | 2009 Ford Fusion

1 Answer

I need to remove my spare tire from my 2002 f 250 truck


If it is like my 2002 Ranger the jack handle fits into a hole in the rear bumper and you turn the handle to lower and raise the spare tire.

Apr 16, 2011 | Ford F-250 Cars & Trucks

1 Answer

How to get down the spare tire underneath the 92 ford explorer xlt


Using the jack handle from the engine compartment. There will be a spot for it to fit into and then crank the spare down. To store the spare again, crank in the opposite direction. There is a cable that is wound on a spindle by the jack handle. This lowers and raises the spare.

Good luck, Jim

Mar 02, 2011 | Ford Explorer Cars & Trucks

1 Answer

My 2009 ford fusion's tire pressure light came on. how do i reset it after filling the tires to their proper pressure


The light should reset itself after driving the vehicle for 10 minutes or so out on the highway.

Jan 26, 2011 | 2009 Ford Fusion

2 Answers

Where is the spare tire located on a 1995 ford aerostar?


Section 00-02: Lifting, Jacking and Spare Tire Stowage 1995 Aerostar, Ranger, Explorer Workshop Manual
TIRE STOWAGE Tire, Spare, Removal, Aerostar If the Aerostar is a standard length vehicle the spare tire is mounted inside to a carrier at the left rear quarter panel. To remove the spare tire, remove the wing nut and plate. A flat tire can be temporarily stowed in the same location.



If the Aerostar is the bus with a standard length body or extended length (all models), the temporary spare tire is stowed at the rear of the vehicle under the body. The Aerostar standard length E-4WD bus spare tire is mounted on the floor.
  1. Insert lug nut wrench into the actuator hole and turn counterclockwise until the cable extends to allow the spare tire to be pulled rearward from under the vehicle.
  1. Slide spare tire to the rear and remove the retainer from the wheel.
  1. To stow cable/retainer with spare tire removed, insert cable fitting into carrier rear wall slot, place wheel retainer against the carrier, and turn lug nut wrench clockwise until slack is removed.
please rate, thanks

Jul 09, 2010 | 1995 Ford Aerostar

1 Answer

What is Fords recommended service for a 2009 fusion at 25000 km? The dealers seam to be adding all kinds of extras.


1. Check brakes
2. Inspect axle shaft seals,Constant Velocity Joint Boot, Transmission
3. Lubricate Chassis,linkage,steering, suspension
4. Replace Engine oil & filter
5. Rotate Tires

Feb 10, 2010 | 2009 Ford Fusion

1 Answer

I am trying to replace the jack and spare tire in my recently purchased 1998 sable perhaps there is a part missing could you help me figure out how it goes back in the trunk and holds both the jack and...


These cars were sold with a mini spare tire which was 3/4 the size of your full size spare that you have. Any Ford or Lincoln Mercury dealer pasts department can sell you the correct parts needed to bolt down your full size spare tire

Jan 26, 2010 | 1997 Mercury Sable

3 Answers

I wanna know how i would go about changing the under mounted tire... i just need to know how to lower the extra tire


theres a bell crank at the top of the tire mount like a wench tha takes a special long wiggle bar and hand tool to crank it down

Jan 15, 2010 | 2009 Ford F-150

Not finding what you are looking for?
2009 Ford Fusion Logo

Related Topics:

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...