Question about 2001 GMC Sonoma Extended Cab

2 Answers

How do I install starter for 2000 GMC Sonoma. This is a 4 cyl 2 wheel drive pick-up

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 17,970 Answers

E
Removal & Installation
2-Wheel Drive
- 2.2L Engine

  1. Remove or disconnect the following:
    Negative battery cable Front exhaust pipe, if necessary for access Starter heat shield, if equipped Brace rod from the front of the engine and the bell housing Drivers side wheel to access the starter motor wires and the starter motor attaching bracket-to-engine bolt through the opening in the wheel well Wires from the starter solenoid Attaching bracket-to-engine mount bolt Starter-to-engine block bolts. When removing the last bolt, be sure to support the starter to keep it from falling and possibly injuring you. Starter and shims (if equipped) from the vehicle Bracket from the starter assembly, if equipped

    how do I install starter for 2000 GMC Sonoma - e12f2d1.jpg

    Fig. Starter motor and related components - 2.2L engine

To install:
  1. Install or connect the following:
    Bracket to the starter, if removed. Tighten the bracket nuts to 97 inch lbs. (11 Nm). Starter and shims (if equipped) into position in the vehicle and thread one of the retaining bolts to hold it in position. Bracket-to-engine mount bolt (loosely), if equipped Starter mounting bolt, then tighten all mounting fasteners to 32 ft. lbs. (43 Nm) Wiring to the solenoid Brace rod and tighten the retainers Front exhaust pipe and tighten the fasteners, if removed Starter heat shield, if equipped Driver-s side wheel, if removed Negative battery cable

Hope helped with this (remember rated this help) Good luck.

Posted on Nov 18, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

The starter will be located on the lower right side of the engine and it is located near some key components for your vehicles ignition system. If you do not consider yourself at least a "B" level technician, I would suggest that you take it to a nearby shop in which u trust.

Posted on Nov 18, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove oil pan on a 2001 gmc Sonoma pick up truck to replace gasket


1993 GMC SONOMA 2.6 CYL V6 NOT 4x4 OIL PAN ...

? 2:31
https://www.youtube.com/watch?v=1KsRTlnW7Cg
Sep 27, 2011 - Uploaded by JohnSmiths8379858
trying to reomove the oil pan to this truck has been sitting for about 6 ... 1993 GMC SONOMA 2.6 CYL V6 NOT 4x4 OIL PAN REMOVAL "HELP!

Oil Pan Gasket: How to Change Oil Pan Gasket for 2001 ...

www.2carpros.com/questions/2001-gmc-sonoma-oil-pan-gasket
Mar 18, 2011 - How to change oil pan gasket for 2001 sonoma, can i get away with just raising the engine two inches to ... 2001 GMC Sonoma • 4 cylinder 2WD Automatic • 150,000 miles ... You need to remove the engine to get the sump off.

Nov 28, 2015 | GMC Cars & Trucks

1 Answer

1996 Sonoma heater stopped working. only high speed if I hot wire it


the blower motor module is burn.or defect replace it and check for bad terminals at module

Oct 11, 2014 | 1996 GMC Sonoma

1 Answer

1998 gmc sonoma starter removal


didnt say if its 4 wheel drive what size motor.

Jan 20, 2011 | 1998 GMC Sonoma

1 Answer

1998 gmc sonoma 4-wheel drive doesn't change from 4-wheel drive to 2-wheel drive


Problem in the shifter or transfer case. Bring it to a transmission repair shop. they do the diagnosis and repair in their sleep.

Apr 27, 2010 | 1998 GMC Sonoma

1 Answer

I want to put 225 60 r16 snows on my 2000 sonoma which currently has 205 60 r16 all seasons...i am putting the 2 snows on the back. any problems other than the speedometer and possible abs sensor?


There should not be any problems unless the truck is 4 wheel drive. Then there will be binding and possible damage. But is sounds like its 2 wheel drive.

Dec 30, 2009 | 1995 GMC Sonoma

1 Answer

I have a 2000 gmc sonoma and while driving down


Probably the CV joint. When you put it in 4x4 that puts extra torque on it so it wont vibrate so much.

Oct 24, 2009 | 2000 GMC Sonoma Extended Cab

1 Answer

How do you change starter on 95 gmc sonoma?


4 cyl or 6> 4 cyl must remove the exhaust at manifold then the bar from engine to tranny then starter it is a tight squeeze

Jun 30, 2009 | 1999 GMC Sonoma

2 Answers

1999 GMC sonoma starte installation


2.2L Engine remove protective shields as needed then remove front exhaust pipe. Remove the brace from the engine to the clutch housing, then disconnect starter wiring. 4.3L Engine 2 wheel drive just remove the right front tire and you will have access to the wiring. 4.3L Engine 4 wheel drive you must remove the differential carrier shield if equipped then remove the starter bolts and rotate the starter to get access to the wiring. Good Luck.

Jun 15, 2009 | 1999 GMC Sonoma

1 Answer

Engine won't start


maybe that could be check for that fuse if it is busted.if your starter will crank and still the engine will not start then check if there is current coming from your high tension wire of your distributor assembly.if there is no current check for the connection or fuses.

Dec 28, 2008 | 2000 GMC Sonoma Extended Cab

Not finding what you are looking for?
2001 GMC Sonoma Extended Cab Logo

4,797 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...