Question about 2006 Honda Fit

1 Answer

My 2006 honda fit is misfiring

My car fit is misfiring and shutting down

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that gotĀ 5 achievements.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.

  • Contributor
  • 27 Answers

I am unfamilliar with the problems these cars have as they are rather new. but i would bet anything is still covered under the manufacturer waranty.

generally tho mis firing is caused my a few things, an incorrectly gapped sparkplug, timing could be off, lose plug wires or a broken distributor/cap.

check those and call the dealer to find out if it's still coverd

Posted on Nov 18, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why is there cylinder 2 misfire?

It may just be a coil breaking down or a bad spark plug. Try swapping one of the coils over with the faulty one and see if the misfire happens on that cylinder and cylinder 2 runs fine. If it does then swap the faulty one for a new coil. Don't know about your car but most now have individual coils for each cylinder that fit directly onto each spark plug.

Aug 17, 2015 | 2006 Mazda Tribute

1 Answer

How much transmission oil must go in the honda fit 2006

How much oil you got,put the same back.Do you have deep stick?

Jan 17, 2015 | 2006 Honda Fit

1 Answer

I'm trying to locate the cylinders on a 2006

On top of the intake manifold you'll find the number for each cylinder at its respected position.

Sep 23, 2014 | 2006 Honda Accord

1 Answer

Replaced 1.8 liter engine in a 2006 Civic after it overheated bad. Had to replace two ignition coils and it will idle smooth until it gets warm then starts missing.Loses power and check engine light starts...

misfires are from coils , plugs , HT leads , and injectors and fuel pressure . If the head got that hot then it is possible that the injectors have an internal problem that shows when they get hot and the electronics breaks down.

Aug 16, 2014 | 2006 Honda Civic

1 Answer

Engine shut down due catalyst prblem

is your mechanic brain dead, he/she is not ASE certified, or it be fixed now.
Cats, (never dogs)
do break up (ceramic type) just for funs and giggles,
just vibration or bumps or hitting any OBJECT on the road can do that.
on my 88 jeep the rear exh mount broke and it shock the cat to DEATH. just a 99cent clamp , bam.
point to
if you drive any car with the CEL flashing that means
the CAT is melting ,diD YOU? its in the operators guide. and what to do , it says stop car, and let it cool and to go slow to nearest sevice,
mine says ,drop off the trailer too. (trucks)

if the engine was running in limphome with huge exhaust heat and air and fuel the cat is doomed, all cars can to that ACT.
next time (if true) stop avoiding the CEL. , scan it and find the errors.
so my guess, is the cat burned up and slagged on you.
the ECU EFI is running rich, and most likely MISFIRING like HELL.
all misfirings when ignored, kills the CAT.
i guess you mech, never seen and engine MISFIRE?
if not , fire him , no, run fast to the nearest ASE shop.

Jun 25, 2013 | 2006 Honda Odyssey

1 Answer

Limp mode removal

Have the fault codes read. Replace faulty items. Use only
genuine items as replacement as non-genuine are not always compatible with the OEM fitted CPU units. This results in the fault codes not cancelling out.

May 18, 2013 | 2006 Buick Grand National

2 Answers

I have a 2006 mercedes c230 sport. It is misfiring on cylinders 4 5 and 6 could it be an oxygen sensor? if so up stream or down

If the c230 has a misfire it may be a bad ecu or M.E. control unit. There is a company that can test it in Michigan.
Mercedes Ecm Repair

Jan 28, 2013 | GMC Yukon Cars & Trucks

1 Answer

Servicing of motorcar

Take a look at the following. I believe it covers maintenance. Don't think they show a manual for a 2006, but I imagine the 2007 is pretty close. You can print the pages that are most important.

Hope this is helpful to you.

Nov 18, 2009 | 2006 Honda Fit

2 Answers

Engine misfiring

I always replace plugs with same brand and number as came out whenever possible, just for that reason. I've seen too many engines run bad after changing from manufacturers recommended plugs.

Oct 06, 2009 | 2006 Honda Ridgeline

1 Answer

2007 Honda Fit with 50K. Intermittently misfire.

Buy some Seafoam from autozone $10 pour half can into half tank drive a little hard on it for a good 10 t0 15 miles. this should do the trick. let me know if it helped!

Sep 26, 2009 | 2006 Honda Fit

Not finding what you are looking for?
2006 Honda Fit Logo

Related Topics:

225 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides