Question about 2001 Dodge Ram 2500 Truck

1 Answer

No power to electric fuel transfer pump - 2001 Dodge Ram 2500 Truck

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 188 Answers

The fuse for the pump is probably blown if not theres a brake in the circut

Posted on Nov 18, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel Not Transferring Across Gas Tank?


the jet pump is a clever bit of kit it uses energy from the main pump to transfer fuel over to balance it out being a saddle tank arangement if its not doing its job then its faulty unless its not been installed correctly. there are no electrical connections only the level sensor. and pipework

Aug 05, 2017 | Jaguar Cars & Trucks

2 Answers

How can I power up the fuel pump without starting the engine?


Fuel pump runs for a bit every time key is turned from off to on, so off on then off on until you get it low enough or just use a siphon hose.
You could jump the fuel pump relay if you no electrical.

Mar 26, 2015 | 1995 Ford Escort

1 Answer

Fuel transfer pump


the transfer pump is in the right tank, you can get access to the tank sender/pump units from under the rear seat, i'd suggest checking power to the trans pump and go from there

May 16, 2014 | 2006 Dodge Charger

1 Answer

Were is the fuel pump relay on a 91 geo tracker also when I hooked power to the fuel pump it dindnt run


When you hooked power directly to the fuel pump, it may not have been grounded properly. If you're running power directly to it, and it is grounded properly, it should work fine, unless the fuel pump itself if bad. There is something called Ohm's law. it says you have to have power and a ground to transfer electricity. I am at a loss on where the fuel pump relay is. If the pump won't work with direct power, I can't imagine it being the relay.

Aug 10, 2013 | 1995 Geo Prizm

1 Answer

Lost electrical power to fuel pump


There are many reasons why fuel pumps have no power, most (in tank) fuel pumps fail due to low fuel inside of tank.

These fuel pumps turn at an alarming rate which in turn causes an alarming amount of heat. This heat is then dissipated by the fuel inside of the tank itself.If the driver/operator allows to run the fuel very low and continue to do so, this will over time allow for the fuel pump to overheat due to the ONLY source used to cool the fuel pump is the fuel inside of the fuel tank itself. Electrically, view the operator's manual or similar source to locate fuel pump fuse and/or relay of which will open the electrical path when the fuel pump overheats.
This should be a pretty good starting point to locate/isolate electrical issue you may be experiencing.

Good Hunting to you & hope this gets you back on the road soon!
FASTESTNASCAR

Dec 27, 2011 | 1987 Mercedes-Benz Mercedes Benz 190 Class

1 Answer

Does the 2004 cadillac deville have a access panel or do I have to remove the tank to gain acess to fuel pump


lucky you, you can get to it from the trunk.

Removal & Installation

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Relieve the fuel system pressure.
  3. Drain the fuel tank.
  4. Remove or disconnect the following:
    CAUTION When removing the fuel sender from the tank, the reservoir bucket is full of fuel. Use caution in containing the fuel.

    NOTE Note the direction the strainer is pointing.


    Negative battery cable Spare tire and jack Trunk lining Fuel sender access panel Sender and quick connect fittings from the sender Electrical connector from the sender and position harness and hoses aside


    Sender retaining ring Sender and take note of its position Fuel sender O-ring and discard it


    Strainer from the pump by pulling it down and twisting Pump electrical wires and hoses Pump assembly out of the rubber connectors

To install:
  1. Transfer any insulators and grommets from the old pump to the new one.
  2. Connect the pump to the fuel hose and tilt the bottom of the pump into the mounting bracket.
  3. Install or connect the following:

    New strainer on the pump so it points in the same direction as noted during removal Electrical connectors and fuel lines to the pump New O-ring on top of the fuel tank Fuel sender assembly into the tank Lockring Fuel line quick connectors Sender electrical connector Fuel sender access cover Trunk liner Spare tire and jack
  4. Refill with fuel and check for leaks.

Sep 03, 2011 | 2004 Cadillac Deville

2 Answers

How do i change a 2004 Lincoln LS fuel pump?


Hi. here's how to change the fuel pump. The actual electric fuel pump is in the tank on the right side. The tank is directly below the rear seat. If you remove the seat bottom you will find a 6 inch or so cover. Under the cover there is a plastic, threaded collar that locks the fuel pump into the tank. The driver's side also has a pump, but it works only my venturi effect from the electric pump on the other side. This pump is used to equalize the fuel level from left to right. The drive shaft tunnel prevents all but the very top of the tank from communicating left to right.

Aug 12, 2010 | 2004 Lincoln LS

1 Answer

How to replace tranfer pump on ford f350 7.3


IF YOU GOT A MECHANICAL TRANSFER PUMP YOU NEED A FLARE NUT WRENCH TO LOOSEN THE THREADED FUEL LINES.LOOSEN THE MECHANICAL TRANSFER PUMP BOLTS ONE OR TWO TURNS.MOVE THE PUMP BY HAND TO BREAK THE GASKET SEAL.USING A REMOTE STARTER SWITCH OPERATE STARTER TO ROTATE THE CRANKSHAFT IN SHORT BURSTS UNTIL THE FUEL PUMP CAM IS AT IT LOWEST POSITION.WARNING STAY CLEAR OF THE FAN AND DRIVEBELTS.DISCONNECT THE FUEL LINES FROM THE FUEL PUMP.REMOVE THE FUEL PUMP MOUNTING BOLTS AND REMOVE THE PUMP.THE ELECTRIC TRANSFER PUMP.TURN OFF RADIO FIRST THEN DISCONNECT THE NEGATIVE BATTERY CABLES. DETACH WIRES FROM THE PUMP.DISCONNECT THE FUEL INLET AND OUTLET LINES FROM THE PUMP AND PLUG THE LINES TO PREVENT CONTAMINATION AND LEAKAGE.LOOSEN PUMP MOUNTING BRACKET AND REMOVE THE PUMP.THE ELECTRIC TRANSFER PUMP LOCATED ON THE ENGINE MOUNT NEXT TO STARTER.THE MECHANICAL TRANSFER PUMP LOCATION IS ON THE RIGHT PASSENGERS SIDE OF THE ENGINE LOW AND NEAR THE FRONT.

Jun 11, 2010 | 1997 Ford F350 Crew Cab

1 Answer

99 dodge 2500 5.9 cummins fuel pressure at 3psi


The 3 psi is caused by a failed transfer pump. The problem the loss of could be the VP44 injection pump. This pump should be run at min 7psi. I had the same fuel pressure problem. I replaced my stock transfer pump with a FASS DDRP from www.usdieselparts.com. The stock pump is over $200 to replace and will fail again, sometimes right out of the box. The DDRP will supply about 15psi to the pump and is simple to install. I hope this helps.

Apr 29, 2009 | 1999 Dodge Ram 2500 4WD

1 Answer

How do i fit new fuel pump


the first thing is to figure out which pump... there is a transfer pump (in the fuel tank) and a high pressure pump (under the right rear of the car) get under the car and have someone turn the key to "run"... if you HEAR a humming sound coming from the pump that you can SEE, then it is most likely the transfer pump... if you hear NOTHING then remove the boot on the pump and check for voltage on the positive terminal using a light or a meter. If no voltage then check fuse or the fuel pump relay. (hint: you should hear a "clicking" sound with your ear close to the fuse panel when you turn the key...) VW fuel pumps are really reliable as long as you don't have too much dirt or water in the tank. Eliminate the electrical circuit and high pressure pump as suspects before looking at the transfer pump. Hope this helps.. (oh, and have a clamp handy when changing the high pressure pump to avoid a huge fuel spill!)

Apr 13, 2009 | 1989 Volkswagen Cabriolet

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

89 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...